1. Introduction
The Generic SALT ONE XL Halogenerator is a portable device designed to disperse fine salt particles (aerosols) into an enclosed space, facilitating halotherapy sessions. This manual provides essential information for the safe and effective operation, maintenance, and troubleshooting of your halogenerator. Please read this manual thoroughly before initial use and retain it for future reference.
2. Safety Information
Observe the following safety precautions to prevent injury or damage to the device:
- Always use the halogenerator in a dry environment. Avoid exposure to water or excessive humidity.
- Ensure the power supply matches the device's requirements (60 watts).
- Do not obstruct the air intake or exhaust vents during operation.
- Keep out of reach of children and pets.
- Only use pharmaceutical-grade salt specifically designed for halogenerators.
- Do not attempt to open or repair the device yourself. Refer to qualified service personnel.
- Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition.
3. Package Contents
Verify that all items are present in the package:
- SALT ONE XL Halogenerator Unit
- Power Adapter
- User Manual
- Cleaning Brush
- Initial Salt Supply (may vary)
4. Setup
4.1 Placement
Place the halogenerator on a stable, flat surface or mount it securely on a wall within the salt room or desired application area. Ensure adequate air circulation around the unit.
Figure 4.1: Front view of the SALT ONE XL Halogenerator.
4.2 Power Connection
Connect the provided power adapter to the halogenerator's power input port, then plug the adapter into a standard electrical outlet.
4.3 Salt Loading
Open the salt chamber cover located on the top of the unit. Carefully pour the recommended amount of pharmaceutical-grade salt into the chamber. Close the cover securely before operation.
Figure 4.2: Top view of the halogenerator showing the salt chamber.
Figure 4.3: Example of a halotherapy room environment.
5. Operating Instructions
5.1 Powering On/Off
Press the power button on the control panel to turn the unit on. The display will illuminate. Press the button again to turn the unit off.
5.2 Session Programming
The SALT ONE XL Halogenerator offers unlimited programming capabilities, often controlled via a mobile application. Refer to the specific mobile application's instructions for detailed programming steps, including session duration, salt concentration, and fan speed settings.
5.3 Monitoring Operation
During operation, the device will quietly disperse salt aerosols. Monitor the control panel for any status indicators or error messages. Ensure the salt chamber has sufficient salt for the duration of the session.
6. Maintenance
6.1 Regular Cleaning
To ensure optimal performance and longevity, regularly clean the halogenerator. Use the provided cleaning brush to remove any salt residue from the grinding mechanism and the salt chamber. Wipe the exterior with a dry, soft cloth.
6.2 Salt Chamber Care
Periodically inspect the salt chamber for any blockages or excessive build-up. Ensure the chamber is completely dry before adding new salt. Do not use water or liquid cleaners inside the salt chamber.
7. Troubleshooting
Refer to the table below for common issues and their solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Device does not power on. | No power supply; loose connection. | Check power adapter connection and wall outlet. Ensure power button is pressed. |
| Device beeps continuously and does not emit salt particles. | Salt chamber empty; salt residue blockage; grinder malfunction. | Check salt level in chamber. Clean the salt grinding mechanism thoroughly. If problem persists, contact customer support. |
| Low salt aerosol output. | Insufficient salt; clogged grinding mechanism; incorrect settings. | Refill salt chamber. Clean the grinding mechanism. Verify programming settings via mobile application. |
| Unusual noise during operation. | Foreign object in grinder; worn components. | Turn off and unplug the device. Carefully inspect the salt chamber for any foreign objects. If noise continues, contact customer support. |
8. Specifications
| Feature | Detail |
|---|---|
| Product Dimensions | 7"D x 7"W x 20"H (7 x 7 x 20 inches) |
| Wattage | 60 watts |
| Controller Type | Mobile Application |
| Coverage Area | Up to 250 sq ft |
| Aerosol Particle Size | More than 98% below 2 microns |
| Manufacturer | MM Personal Services |
| Color | White |
9. Warranty and Support
9.1 Warranty Information
The Generic SALT ONE XL Halogenerator comes with a one-year global warranty from the date of purchase. This warranty covers manufacturing defects and malfunctions under normal use. It does not cover damage caused by misuse, accidents, unauthorized repairs, or failure to follow instructions in this manual.
9.2 Customer Support
For technical assistance, warranty claims, or inquiries regarding your halogenerator, please contact the manufacturer or your point of purchase. Have your product model and purchase date ready when contacting support.
