Introduction
This manual provides detailed instructions for the assembly, care, and maintenance of your VOLARE 5-Piece Queen Bedroom Furniture Set. Please read this manual thoroughly before beginning assembly or use to ensure proper installation and longevity of your furniture.
The VOLARE 5-Piece Queen Bedroom Furniture Set includes:
- Queen-size Bed Frame
- Two Nightstands
- Dresser
- Mirror
- Chest
Image: The complete VOLARE 5-Piece Queen Bedroom Furniture Set, showcasing the bed frame, two nightstands, dresser, mirror, and chest in a modern white design with high gloss lacquer finish and stainless steel accents.
Safety Information
Always follow these safety guidelines to prevent injury or damage to your furniture:
- Ensure all hardware is securely tightened before use. Periodically check and re-tighten as needed.
- Do not allow children to climb on or play with the furniture.
- Distribute weight evenly on surfaces to prevent tipping.
- For dressers and chests, consider using anti-tip kits (not included) to secure them to a wall, especially in homes with young children.
- Keep small parts out of reach of children during assembly.
Setup and Assembly
Before You Begin
- Unpack all components and verify against the parts list (not provided in this manual, refer to packaging).
- Clear a spacious area for assembly.
- Gather necessary tools: Phillips head screwdriver, flathead screwdriver, hammer (for some components).
- Assembly is recommended for two people.
Assembly Steps (General Guidelines)
Due to the modular nature of the set, specific assembly instructions for each piece (bed, nightstands, dresser, mirror, chest) are typically provided with the individual packaging. The following are general steps:
- Bed Frame Assembly:
Connect headboard and footboard to side rails using provided hardware. Install center rail and wooden slat system. Ensure all connections are secure. The bed frame is designed to support a mattress directly without a box spring.
Image: Close-up of the VOLARE Queen Bed Frame, highlighting the white upholstered PU leather headboard and the sturdy frame design.
- Nightstands, Dresser, and Chest Assembly:
Assemble the main frame of each unit. Install drawer slides. Assemble drawers and insert them into the frame. Attach handles/pulls. For the dresser, attach the mirror securely to the back of the dresser using the provided brackets.
Image: The VOLARE Dresser with its accompanying mirror, showcasing the high gloss finish and stainless steel drawer pulls.
Image: The VOLARE Chest of Drawers, featuring multiple drawers with stainless steel accents, providing ample storage.
- Final Placement:
Once assembled, carefully move each piece to its desired location. Ensure furniture is level and stable.
Operating and Usage Guidelines
Your VOLARE bedroom set is designed for daily use. Follow these guidelines for optimal performance:
- Drawers: Open and close drawers smoothly. Avoid overloading drawers to prevent damage to slides and frames.
- Bed Frame: Place your queen-size mattress directly on the wooden slats. No box spring is required.
- Surfaces: Use coasters under drinks and protective pads under decorative items to prevent scratches or marks on the high gloss finish.
Maintenance and Care
Proper care will help maintain the beauty and longevity of your VOLARE furniture set.
Cleaning Instructions
- High Gloss Lacquer Finish: Wipe surfaces with a soft, dry cloth. For stubborn marks, use a slightly damp cloth with mild soap, then immediately dry with a clean, soft cloth. Avoid abrasive cleaners, ammonia-based products, or silicone-based polishes, as these can damage the finish.
- PU Leather Headboard: Wipe with a soft, damp cloth. For spills, blot immediately with a clean, dry cloth. Do not use harsh chemicals or solvents.
- Stainless Steel Accents: Clean with a soft cloth and a non-abrasive stainless steel cleaner if necessary.
General Care
- Avoid direct sunlight and extreme temperature changes, which can cause fading or cracking.
- Keep furniture away from heat sources like radiators or fireplaces.
- Periodically check and tighten all hardware connections to ensure stability.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Drawers stick or do not slide smoothly. | Misaligned drawer slides, loose hardware, or overloaded drawer. | Check alignment of drawer slides. Tighten all screws on slides and drawer boxes. Reduce contents if overloaded. |
| Furniture wobbles or is unstable. | Uneven floor or loose assembly hardware. | Ensure furniture is on a level surface. Re-tighten all assembly hardware. Use shims if necessary for uneven floors. |
| Scratches or marks on high gloss finish. | Abrasion from objects or improper cleaning. | Use a soft, dry cloth for cleaning. Avoid dragging objects across surfaces. Minor scratches may be buffed out with specialized furniture polish (test in an inconspicuous area first). |
Specifications
| Feature | Detail |
|---|---|
| Model Number | CDF-VOLARE-SET5 |
| Set Includes | Queen-size Bed Frame, 2 Nightstands, Dresser, Mirror, Chest |
| Color | White |
| Finish | High Gloss Lacquer |
| Headboard Material | White PU Leather Upholstery |
| Accents | Stainless Steel Metal |
| Frame Construction | Sturdy Wood with Wooden Slat System and Metal Side Rails |
| Assembly Required | Yes, easy assembly |
| Total Item Weight | Approximately 250 pounds (for the entire set) |
| Manufacturer | CASA DESIGN FURNITURE |
| Country of Origin | Italy |
| UPC | 680585170420 |
Warranty and Support
For information regarding warranty coverage and customer support, please refer to the documentation included with your purchase or contact the manufacturer directly.
Manufacturer: CASA DESIGN FURNITURE
For further assistance or to report missing/damaged parts, please contact your retailer or the manufacturer's customer service department.
