Introduction
This manual provides instructions for the HYSHIKRA 27Mhz Magnetic CB Antenna. This antenna is designed to enhance the transmission (TX) and reception (RX) capabilities of compatible CB radios.
Important Note: This antenna is designed for indoor use only. Due to its limited suction power, it is not recommended for use outside a vehicle.
Product Components
The package includes:
- 1 x 27Mhz Magnetic Mount CB Antenna
An overview of the HYSHIKRA 27Mhz Magnetic CB Antenna, showing the antenna whip, magnetic mount base, and the attached RG58 coaxial cable with a UHF-Male connector.
Setup Instructions
1. Antenna Assembly
Attach the antenna whip to the magnetic base. Ensure it is securely fastened.
This image illustrates the dimensions of the antenna, showing a total height of 34cm and a magnetic base diameter of 6.5cm. A close-up of the UHF-Male (PL259) connector is also visible.
2. Placement
Place the magnetic base on a flat, metallic surface indoors. The magnetic base provides stability for indoor use.
Warning: This antenna is not designed for outdoor vehicle use due to limited magnetic suction. Using it on the exterior of a moving vehicle may result in detachment and potential damage.
This image depicts various usage scenarios. Please note that despite some illustrations, this antenna is strictly recommended for indoor use only. It is not suitable for outdoor vehicle mounting due to limited magnetic suction.
3. Connection to CB Radio
Connect the UHF-Male (PL259) connector of the RG58 cable to the antenna input port on your compatible CB radio (e.g., Uniden, Midland, Cobra, President Randy Series).
A detailed view of the UHF-Male (PL259) connector, which connects the antenna cable to the CB radio.
Video demonstrating the assembly and connection of the CB Magnetic Mount Antenna, showcasing its components and how they fit together.
Operating Instructions
Once connected, power on your CB radio. The antenna will facilitate improved signal transmission and reception. Refer to your CB radio's manual for specific operating procedures.
Maintenance
- Keep the antenna and cable clean and free from dust.
- Periodically check the connections to ensure they remain secure.
- Avoid bending or kinking the cable to prevent internal damage.
Troubleshooting
- Poor Signal Quality: Ensure the antenna is placed on a sufficiently large metallic surface for optimal grounding. Verify all connections are tight.
- No Signal: Check that the antenna is correctly connected to the CB radio. Confirm the radio is powered on and functioning correctly.
- Antenna Detachment: This antenna is for indoor use only. Do not use it on the exterior of a moving vehicle.
Specifications
| Feature | Detail |
|---|---|
| Antenna Type | 27Mhz Magnetic Mount CB Antenna |
| Connector Type | UHF-Male (PL259) |
| Cable Type | RG58 |
| Cable Length | 4 meters |
| Magnet Mount Base Diameter | 2.7 inches (approx. 6.5 cm) |
| Compatibility | Cobra, Uniden, Midland, President Randy Transceivers, and most mobile CB radios |
| Intended Use | Indoor only |
| Item Weight | 1.04 pounds |
| Package Dimensions | 13.7 x 3.35 x 2.05 inches |
Warranty and Support
For technical assistance or any issues, please contact the seller by clicking "RADIO MAX" below the "Buy Now" button on the product page and selecting "ask a question".