Product Overview
This manual provides instructions for the Oraimo replacement HEPA filters, model OAS-FI-SV102, designed for use with the Oraimo OSV-102 Cordless Vacuum Cleaner. These filters are crucial for maintaining the vacuum's suction power and ensuring effective air filtration, capturing fine dust and allergens. The filters are reusable and washable, offering a cost-effective and environmentally friendly solution.
Image: The Oraimo OSV-102 Cordless Vacuum Cleaner shown with its various attachments and a set of four replacement HEPA filters, highlighting the product's components.
The package includes two (2) replacement HEPA filters, ensuring you have a spare for continuous use while one is being cleaned or dried. Regular replacement and cleaning of these filters are essential for optimal vacuum performance and air quality.
Important Safety Information
- Always turn off and unplug the Oraimo OSV-102 vacuum cleaner before attempting to install, remove, or clean the filters.
- Use only genuine Oraimo replacement filters (model OAS-FI-SV102) to ensure proper fit and filtration performance.
- Do not operate the vacuum cleaner without the filters properly installed.
- Keep filters away from open flames or excessive heat.
Installation Instructions
Follow these steps to replace the HEPA filter in your Oraimo OSV-102 Cordless Vacuum Cleaner:
- Power Off: Ensure the vacuum cleaner is turned off and disconnected from its charging base or power source.
- Locate Dust Cup: Identify the dust cup assembly on your Oraimo OSV-102 vacuum.
- Remove Dust Cup: Press the dust cup release button (if applicable) or twist the dust cup counter-clockwise to detach it from the main body of the vacuum.
- Access Filter: Inside the dust cup, locate the existing HEPA filter. It is typically a cylindrical or conical filter element.
- Remove Old Filter: Gently twist or pull the old filter to remove it from its housing. Dispose of the old filter responsibly if it is no longer usable.
- Insert New Filter: Take a new Oraimo replacement HEPA filter (OAS-FI-SV102) and insert it into the filter housing. Ensure it is seated firmly and correctly.
- Reattach Dust Cup: Align the dust cup with the vacuum's main body and twist it clockwise or push it until it clicks securely into place.
- Ready for Use: The vacuum cleaner is now ready for use with the new filter installed.
Maintenance and Cleaning
To maintain optimal performance, regularly clean your reusable HEPA filters. Follow these steps:
- Remove Filter: Follow steps 1-4 from the Installation Instructions to remove the HEPA filter from the dust cup.
- Tap Out Debris: Gently tap the filter against a trash can to dislodge any loose dust and debris.
- Rinse: Rinse the filter under cold, running water. Continue rinsing until the water runs clear. Do not use hot water or detergents, as this can damage the filter material.
- Air Dry: Allow the filter to air dry completely for at least 24 hours before reinstalling it. Ensure it is placed in a well-ventilated area, away from direct sunlight or heat. Do not use a dryer or other heating devices, as this can deform or damage the filter.
- Reinstall: Once completely dry, reinstall the filter into the dust cup and reattach the dust cup to the vacuum cleaner.
It is recommended to clean the filter every 2-4 weeks, depending on usage, and replace it every 3-6 months for best performance.
Troubleshooting
If you experience issues with your Oraimo OSV-102 vacuum cleaner after filter maintenance, consider the following:
- Reduced Suction:
- Check if the filter is clogged. Clean or replace the filter as per the Maintenance section.
- Ensure the filter is completely dry before reinstallation. A damp filter can impede airflow.
- Verify the dust cup is securely attached and there are no blockages in the vacuum's hose or brush head.
- Unusual Odor:
- A dirty filter can cause odors. Clean or replace the filter.
- Ensure the filter is thoroughly dried after washing to prevent mildew.
- Filter Does Not Fit:
- Confirm you are using the correct replacement filter model (OAS-FI-SV102) for your Oraimo OSV-102 vacuum cleaner.
- Ensure the filter is oriented correctly during installation.
Specifications
| Brand | Oraimo |
| Model Number | OAS-FI-SV102 |
| Compatible Devices | Oraimo OSV-102 Cordless Vacuum Cleaner, Dyson V11 (as per product information) |
| Reusability | Reusable, Washable |
| Number of Pieces | 2 |
| Item Weight | 3.52 ounces |
| Product Dimensions | 3.15 x 3.54 x 5.51 inches |
Warranty and Support
For any questions regarding the Oraimo replacement HEPA filters, including warranty information or technical support, please contact Oraimo customer service. Refer to the original Oraimo OSV-102 Cordless Vacuum Cleaner manual or the Oraimo official website for contact details.
