Leelbox FG6000ioL-B 5500W Inverter Generator User Manual

1. Introduction

Thank you for choosing the Leelbox FG6000ioL-B 5500W Inverter Generator. This manual provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your generator. Please read this manual thoroughly before operating the unit and keep it for future reference.

The Leelbox FG6000ioL-B is a powerful and portable 4-stroke gasoline inverter generator designed to deliver clean, stable power for a variety of applications, from sensitive electronics to power tools. It features a 5500W peak and running power output, advanced inverter technology for pure sine wave output, and a low-noise design for quiet operation.

Figure 1: Leelbox FG6000ioL-B 5500W Inverter Generator. This image shows the overall design of the generator, highlighting its compact and robust frame.

2. Safety Information

Your safety and the safety of others are very important. Always operate the generator according to the instructions provided. Failure to do so can result in serious injury or death.

General Safety Precautions:

• Carbon Monoxide Hazard: Generators produce carbon monoxide, a colorless, odorless, poisonous gas. Operate the generator outdoors in a well-ventilated area, far away from windows, doors, and vents. Never operate indoors, in a garage, or in partially enclosed spaces.
• Fire Hazard: Gasoline is highly flammable. Refuel in a well-ventilated area with the engine off and cool. Do not smoke or allow open flames near the generator. Store fuel in an approved container.
• Electrical Shock Hazard: Do not operate the generator in wet conditions. Ensure all electrical connections are secure and properly grounded. Never connect the generator directly to your home's electrical system without a proper transfer switch installed by a qualified electrician.
• Hot Surfaces: The generator's engine and muffler become very hot during operation and remain hot for some time after shutdown. Avoid touching hot surfaces to prevent burns.
• Keep Children and Pets Away: Ensure children and pets are kept at a safe distance from the generator during operation.

3. Product Overview

Familiarize yourself with the components and controls of your Leelbox FG6000ioL-B generator.

Key Components:

• Engine (223cc)
• Fuel Tank (13L capacity)
• Control Panel
• Frame for portability and protection
• Muffler

Control Panel:

The control panel provides access to all operational controls and indicators.

Figure 2: Detailed view of the Leelbox FG6000ioL-B control panel. This image highlights the various switches, meters, and outlets for operation.

• ENG. SW. (Engine Switch): Used to turn the engine ON or OFF.
• ECO. SW. (Economy Switch): Activates or deactivates the ECO mode for fuel efficiency and reduced noise.
• Digital Meter: Displays voltage, frequency, and running hours.
• Indicators:
  • OUTPUT: Illuminates when power is being generated.
  • OVERLOAD: Illuminates and may shut down the generator if overloaded.
  • OIL: Illuminates when engine oil level is low.
• AC230V Outlets: Two standard 230V AC outlets for connecting appliances.
• Multifunctional Socket (DC12V 8.3A): Provides 12V DC power.
• DC Circuit Breaker: Protects the DC circuit from overload.

4. Setup

Before starting your generator for the first time, follow these steps carefully.

4.1 Initial Inspection:

• Check for any visible damage from shipping.
• Ensure all components are present as listed in the packing contents.

4.2 Add Engine Oil:

The generator is shipped without engine oil. You must add the recommended oil before starting.

• Place the generator on a level surface.
• Locate the oil fill cap/dipstick.
• Carefully add the recommended 4-stroke engine oil (e.g., SAE 10W-30) to the proper level. A long-necked funnel may be required due to the oil fill location. Do not overfill.
• Securely replace the oil fill cap/dipstick.

4.3 Add Fuel:

Use fresh, unleaded gasoline with an octane rating of 87 or higher.

• Ensure the generator is off and cool.
• Open the fuel tank cap.
• Slowly add gasoline to the fuel tank, being careful not to overfill. Leave some space for fuel expansion.
• Securely close the fuel tank cap.

4.4 Grounding the Generator:

For safety, always ground the generator before operation. Connect a grounding wire from the generator's grounding terminal to a suitable ground source (e.g., a ground rod).

5. Operating Instructions

5.1 Starting the Engine:

1. Ensure the generator is on a level surface and all electrical loads are disconnected.
2. Turn the fuel valve to the 'ON' position (if applicable).
3. Move the choke lever to the 'CHOKE' position (for cold starts).
4. Turn the ENG. SW. to the 'ON' position.
5. Pull the recoil starter handle firmly and smoothly until the engine starts.
6. Once the engine starts, gradually move the choke lever to the 'RUN' position.

5.2 Using ECO Mode:

The ECO mode adjusts engine speed to match the load, saving fuel and reducing noise.

• To activate ECO mode, turn the ECO. SW. to the 'ON' position.
• To deactivate ECO mode, turn the ECO. SW. to the 'OFF' position. Use OFF for high-load applications or when stable power is critical.

5.3 Connecting Electrical Devices:

After the engine has started and is running smoothly, you can connect your electrical devices.

• Ensure the total wattage of connected devices does not exceed the generator's running power (5500W).
• Plug your devices into the AC230V outlets or use the DC12V 8.3A multifunctional socket as needed.
• The inverter technology generates pure sine waves, making it safe for sensitive electronics like laptops and televisions.

Figure 3: Illustration of inverter technology providing pure sine waves, suitable for sensitive appliances.

5.4 Stopping the Engine:

1. Disconnect all electrical loads from the generator.
2. Turn the ENG. SW. to the 'OFF' position.
3. Turn the fuel valve to the 'OFF' position (if applicable).

6. Maintenance

Regular maintenance ensures optimal performance and extends the lifespan of your generator. Always perform maintenance with the engine off and cool.

6.1 Engine Oil Check/Change:

• Check oil level before each use. Add oil if the 'OIL' indicator light is on.
• Change engine oil after the first 20 hours of operation, then every 100 hours or annually.

6.2 Air Filter Cleaning:

• Inspect the air filter every 50 hours or monthly.
• Clean or replace the air filter element if it is dirty.

6.3 Spark Plug Inspection:

• Inspect the spark plug every 100 hours or annually.
• Clean or replace if necessary.

6.4 Fuel System Maintenance:

• If storing the generator for more than 30 days, drain the fuel tank and carburetor, or use a fuel stabilizer.

7. Troubleshooting

This section covers common issues and their solutions. For problems not listed here, contact customer support.

8. Specifications

Technical specifications for the Leelbox FG6000ioL-B Inverter Generator.

Figure 4: Detailed specifications table for the Leelbox FG6000ioL-B generator.

9. Warranty and Support

For warranty information, please refer to the documentation included with your purchase or contact the retailer. For technical support or spare parts, please contact Leelbox customer service through their official channels.