1. Introduction
Thank you for choosing the FACMAS Large Flight Bird Cage with Rolling Stand. This manual provides essential information for the safe and efficient assembly, operation, and maintenance of your new bird cage. Please read these instructions carefully before use and retain them for future reference.
2. Safety Instructions
- Ensure all parts are securely fastened during assembly to prevent instability.
- Place the bird cage on a flat, stable surface to avoid tipping.
- Keep small children and pets away during assembly to prevent injury or ingestion of small parts.
- Regularly inspect the cage for any damaged or loose components that could harm your bird.
- Do not overload the cage with excessive accessories or birds beyond its intended capacity.
- Avoid placing the cage in direct sunlight or near heat sources to prevent overheating.
3. Package Contents
Before beginning assembly, verify that all components listed below are present and undamaged:
- Cage panels (front, back, sides, top, bottom)
- Pull-out tray
- Wire grate
- Perch(es)
- Food/Water cups
- Rolling stand components (legs, wheels, base)
- Assembly hardware (screws, nuts, washers)
- Hanging hook
Image 3.1: Overview of the FACMAS Large Flight Bird Cage. This image displays the complete bird cage with its main structure, including the wire panels, pull-out tray, and hanging hook, providing a visual reference for the product.
4. Setup Guide
Follow these steps to assemble your bird cage:
- Assemble the Base: Attach the four corner legs to the bottom panel of the cage using the provided screws. Ensure they are firmly secured.
- Attach the Side Panels: Connect the front, back, and side wire panels to the base and to each other. Use the designated clips or screws to secure them, ensuring a tight fit.
- Install the Top Panel: Place the top panel onto the assembled side panels. Secure it using the appropriate fasteners.
- Insert Grate and Tray: Slide the wire grate into the bottom of the cage, above where the pull-out tray will sit. Then, slide the pull-out tray into its designated slot at the very bottom of the cage.
- Attach Hanging Hook: Secure the hanging hook to the top of the cage. Ensure it is stable and can support the cage's weight.
Image 4.1: Close-up of the cage feet and pull-out tray. This image highlights the aluminum alloy feet providing stable support and the accessible pull-out tray designed for easy cleaning.
Image 4.2: Detail of the cage top and reinforced hook. This image shows the trapezoidal arc design of the cage top, indicating structural stability, and the reinforced hook for secure lifting and hanging.
5. Operating Instructions
Once assembled, your FACMAS bird cage is ready for use. Ensure your bird has access to fresh food and water at all times. The pull-out tray allows for convenient daily cleaning without disturbing your bird.
Image 5.1: Two birds inside the cage in an outdoor setting. This image demonstrates the cage in use, housing two small birds comfortably in a natural environment.
6. Maintenance
Regular cleaning and maintenance are crucial for your bird's health and the longevity of the cage.
- Daily Cleaning: Remove and clean the pull-out tray daily. Replace any soiled cage liners.
- Weekly Cleaning: Wipe down all cage surfaces with a bird-safe disinfectant. Clean perches and food/water dishes thoroughly.
- Monthly Deep Clean: Disassemble the cage if necessary for a thorough cleaning of all components. Inspect for rust or wear.
- Inspection: Periodically check all connections, wires, and the hanging hook for any signs of damage or loosening. Tighten screws as needed.
7. Troubleshooting
| Issue | Possible Cause | Solution |
|---|---|---|
| Cage feels unstable | Loose connections; uneven surface | Ensure all screws are tightened; move cage to a flat, level surface. |
| Tray difficult to slide | Debris in tracks; bent tray | Clean tracks thoroughly; gently straighten any bent parts of the tray. |
| Hanging hook seems loose | Improper installation; worn attachment point | Re-secure the hook according to assembly instructions; inspect for wear and replace if necessary. |
8. Specifications
- Product Dimensions: 16.14"L x 10.63"W x 11.42"H
- Material: Wrought Iron
- Color: Black
- Manufacturer: FACMAS
- ASIN: B0BL6VB7SQ
Image 8.1: Bird cage with key dimensions labeled. This image provides a visual representation of the cage's length, width, and height, including both imperial and metric measurements for clarity.
9. Warranty and Support
FACMAS is committed to providing high-quality products. If you encounter any issues or have questions regarding your bird cage, please contact the seller directly through your purchase platform. Please refer to your purchase documentation for specific warranty details.