Introduction
This manual provides essential instructions for the setup, operation, and maintenance of your RELIC by Fossil Men's Automatic Skeleton Watch, model ZR12663. Please read this manual thoroughly to ensure proper use and longevity of your timepiece.
Your automatic watch is powered by the natural motion of your wrist and does not require a battery. The intricate mechanical movement is visible through the skeleton dial, showcasing the craftsmanship of the timepiece.
Product Overview
Front view of the RELIC by Fossil Men's Automatic Skeleton Watch, featuring the black skeleton dial and brown leather strap.
Side view of the watch, showing the crown used for winding and setting the time.
Detail of the brown genuine leather strap and the black buckle with "RELIC" engraving.
Setup
1. Initial Winding
Your automatic watch is powered by kinetic energy. If the watch has stopped or has not been worn for an extended period, it will require manual winding to initiate movement.
- Locate the crown on the side of the watch case.
- Ensure the crown is in its normal, pushed-in position (Position 0).
- Rotate the crown clockwise approximately 40 times. This will build up sufficient power reserve to start the watch.
- The second hand should begin to move smoothly.
2. Setting the Time
- Pull the crown out to Position 1 (the outermost position).
- Rotate the crown either clockwise or counter-clockwise to set the hour and minute hands to the correct time.
- Once the time is set, push the crown back into its normal, pushed-in position (Position 0) to engage the movement and start the watch.
3. Adjusting the Leather Strap
The genuine leather strap features a buckle closure for a customized fit.
- Thread the end of the strap through the buckle.
- Insert the buckle pin into the desired hole on the strap to achieve a comfortable and secure fit on your wrist.
- Ensure the watch is snug enough to prevent excessive movement but not so tight as to restrict circulation.
Operating Your Automatic Watch
Your RELIC automatic watch is a self-winding mechanical timepiece. It harnesses the energy from your daily activities to power its movement.
- Daily Wear: For continuous operation, wear your watch regularly. The natural motion of your arm will keep the mainspring wound.
- Power Reserve: A fully wound automatic watch typically has a power reserve of approximately 36-40 hours. If left unworn for longer than its power reserve, the watch will stop and require manual winding as described in the "Initial Winding" section.
- Accuracy: Mechanical watches, including automatic movements, may exhibit slight variations in timekeeping compared to quartz watches. This is normal for mechanical movements.
Maintenance and Care
Water Resistance
Your watch is water resistant up to 30 meters (100 feet), rated at 3 ATM. This means it is suitable for:
- Splashes
- Brief immersion in water
Important: This watch is NOT suitable for swimming, showering, diving, or any prolonged water activities. Always ensure the crown is fully pushed in before any contact with water.
Cleaning
- Wipe the watch case and crystal with a soft, dry, lint-free cloth.
- For the leather strap, avoid excessive moisture. If it gets wet, allow it to air dry naturally, away from direct heat or sunlight.
- Do not use chemical cleaners, solvents, or abrasive materials, as these can damage the watch's finish or strap.
Storage
- When not wearing your watch, store it in a cool, dry place, away from direct sunlight, extreme temperatures, and strong magnetic fields.
- The original watch box (see image below) provides suitable protection for storage.
The RELIC by Fossil watch box, ideal for safe storage.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Watch has stopped or is running slowly. | Insufficient power reserve. The watch has not been worn or manually wound enough. | Manually wind the watch by rotating the crown clockwise approximately 40 times. Wear the watch regularly to keep it wound. |
| Time is inaccurate. | Mechanical watches can have slight variations. Exposure to strong magnetic fields. | Reset the time accurately. Avoid placing the watch near strong magnets (e.g., speakers, refrigerators, certain electronic devices). If inaccuracy persists, consult a professional watch repair service. |
| Moisture or condensation under the crystal. | Exposure to excessive moisture or temperature changes beyond water resistance limits. | Immediately take the watch to a professional watch repair service. Do not attempt to open the watch yourself. |
Specifications
| Feature | Detail |
|---|---|
| Model Number | ZR12663 |
| Movement Type | Automatic (Mechanical) |
| Case Diameter | 45 Millimeters |
| Case Thickness | 13 Millimeters |
| Band Width | 22 Millimeters |
| Band Material Type | Leather (Brown) |
| Case Material Type | Alloy Steel (Black) |
| Crystal | Mineral Glass |
| Dial Color | Black (Skeleton with Amber Lens) |
| Water Resistance Depth | 30 Meters (100 Feet / 3 ATM) |
| Closure Type | Buckle |
| Special Features | Open Dial, Skeleton Movement, Self-Winding |
Case Size Guide for round watches. This image illustrates various watch case diameters for reference.
Warranty and Support
Manufacturer's Warranty
Your RELIC by Fossil watch is covered by a manufacturer's warranty. The specific terms and duration of the warranty are typically included with your purchase documentation or can be found on the official RELIC by Fossil website.
Please retain your proof of purchase for any warranty claims.
Customer Support
For further assistance, technical support, or warranty service, please contact RELIC by Fossil customer service. You can usually find contact information on their official website or through the retailer where the watch was purchased.
For more information, visit the official RELIC by Fossil Store.