1. Introduction
This manual provides essential information for the safe assembly, operation, maintenance, and troubleshooting of your Onlyfire Premium 60-inch Outdoor Propane Gas Fire Pit Table. Please read all instructions carefully before using the product and retain this manual for future reference.
Image 1.1: The Onlyfire Premium 60-inch Outdoor Propane Gas Fire Pit Table in operation.
2. Safety Information
WARNING: Failure to follow these instructions could result in fire, explosion, or carbon monoxide poisoning, which could cause property damage, personal injury, or death.
- Keep away from flammable materials. Ensure adequate clearance from combustible surfaces.
- Only use propane gas of the correct type. Refer to the specifications section for fuel type.
- Store propane tanks in a well-ventilated outdoor area, away from direct sunlight and heat sources.
- Regularly check all gas connections and hoses for leaks using a soapy water solution. If bubbles appear, there is a leak. Tighten connections or replace parts as necessary.
- If you smell gas, immediately turn off the propane tank valve. Do not attempt to light the fire pit. Ventilate the area and do not use the fire pit until the leak is located and fixed by a qualified technician.
- Always supervise the fire pit while in use. Never leave a lit fire pit unattended.
- Keep children and pets at a safe distance from the fire pit, especially when it is in operation or cooling down.
- After use, turn off the flame control knob and the safety valve on the propane tank. Allow the fire pit to cool completely before covering or storing.
- Do not use the fire pit in an enclosed space. This appliance is for outdoor use only.
- Do not burn solid fuels (wood, paper, charcoal, etc.) in this propane fire pit.
3. What's Included
Please verify that all components are present and undamaged before proceeding with assembly.
- One (1) 60-inch Fire Pit Table unit
- Lava Rocks (sufficient quantity for burner area)
- One (1) 12FT Hose with Regulator
- User Manual (this document)
4. Setup Instructions
Follow these steps for proper assembly and connection of your fire pit table.
- Unpack Components: Carefully remove all items from the packaging. Inspect for any shipping damage.
- Position the Fire Pit: Place the fire pit table on a flat, stable, non-combustible surface outdoors. Ensure there is adequate clearance from walls, ceilings, and other flammable objects.
- Connect the Propane Hose: Connect the regulator end of the 12FT hose to a standard 20lb propane gas tank (not included). Hand-tighten the connection securely. Connect the other end of the hose to the inlet on the fire pit's control panel.
- Install Igniter Battery: Locate the igniter button on the control panel. Unscrew the cap and insert one (1) AAA battery (not included) with the positive (+) end facing outwards. Replace the cap.
- Distribute Lava Rocks: Carefully place the provided lava rocks into the burner pan, ensuring they do not block the igniter pin or the burner holes. Distribute them evenly over the burner.
Image 4.1: Detailed view of the adjustment knob, stainless steel burner, and lava rocks.
Image 4.2: The fire pit table with its control panel visible on the side.
5. Operating Instructions
Follow these steps to safely ignite and operate your fire pit table.
- Open Propane Tank Valve: Slowly turn the valve on the propane tank counter-clockwise to open the gas flow.
- Ignite the Burner: Press and hold the igniter button while simultaneously turning the control knob counter-clockwise to the 'LOW' position. You should hear a click and see the flame ignite. Continue holding the igniter button for 5-10 seconds after ignition to ensure the flame is established.
- Adjust Flame: Once the flame is stable, release the igniter button. Rotate the control knob to adjust the flame height and intensity to your desired level (between 'LOW' and 'HIGH').
- To Turn Off: Rotate the control knob clockwise to the 'OFF' position. Then, close the valve on the propane tank by turning it clockwise until fully shut.
Image 5.1: The fire pit burner with flames emanating from the lava rocks.
Image 5.2: The fire pit table in operation, showing the flame and control panel.
6. Maintenance
Proper maintenance ensures the longevity and safe operation of your fire pit table.
- Cleaning: Allow the fire pit to cool completely before cleaning. Use a soft cloth with mild soap and water to clean exterior surfaces. Do not use abrasive cleaners or harsh chemicals.
- Lava Rocks: Periodically inspect lava rocks for debris. Replace if they become excessively dirty or degraded.
- Burner and Igniter: Keep the burner ports and igniter pin clear of debris. Use a soft brush if necessary.
- Storage: When not in use for extended periods, disconnect the propane tank and store the fire pit in a dry, protected area. A weather-resistant cover (not included) is recommended to protect the unit from the elements.
- Gas Connections: Annually check all gas connections and the hose for wear, cracks, or damage. Replace any damaged components immediately.
7. Troubleshooting
Refer to this section for solutions to common issues.
| Problem | Possible Cause | Solution |
|---|---|---|
| Fire pit does not ignite. | 1. Propane tank valve closed. 2. No gas in tank. 3. Igniter battery dead or incorrectly installed. 4. Igniter pin or burner ports blocked. 5. Gas hose kinked or damaged. | 1. Open propane tank valve fully. 2. Replace or refill propane tank. 3. Check/replace AAA battery, ensure correct polarity. 4. Clear debris from igniter pin and burner ports. 5. Inspect hose; replace if damaged. |
| Weak or low flame. | 1. Low gas pressure from tank. 2. Partially closed propane tank valve. 3. Burner ports partially blocked. 4. Regulator issue. | 1. Ensure propane tank is not low. 2. Ensure tank valve is fully open. 3. Clean burner ports. 4. Contact customer support if regulator is suspected. |
| Smell of gas. | Gas leak. | Immediately turn off propane tank valve. Do not light. Perform a leak test with soapy water on all connections. Tighten or replace components as needed. If smell persists, contact a qualified technician. |
8. Specifications
- Model Number: TOP2201-FP014CIb
- Product Dimensions: 60"W x 27"D x 16.5"H (152.3cm W x 68.5cm D x 41.5cm H)
- Material: Metal
- Finish Type: Painted
- Item Weight: 75 Pounds
- Fuel Type: Liquefied Petroleum Gas (Propane)
- BTU Output: 60,000 BTU (approximate)
- Color: Light grey
Image 8.1: Dimensional drawing of the fire pit table.
9. Warranty and Support
For warranty information or technical support, please contact ONLYFIRE OUTDOOR LIVING customer service. Refer to the product packaging or the brand's official website for current contact details.
