FULIHUAPOW JR1932RX-24V Control Box Receiver

Introduction

This manual provides detailed instructions for the FULIHUAPOW JR1932RX-24V Control Box Receiver, designed for children's electric ride-on cars. It covers installation, operation, and important safety information to ensure proper functionality and user safety.

Product Overview

The JR1932RX-24V is a 2.4G Bluetooth control box receiver that enables remote control functionality for compatible children's electric ride-on vehicles. It features a slow start function for smooth acceleration and a 7-pin four-sided socket for connection.

Image showing the FULIHUAPOW JR1932RX-24V Control Box Receiver, a black rectangular unit with various ports and connectors.

Setup and Pairing (First Use or Battery Replacement)

Before initial use or after replacing batteries, the remote control needs to be paired with the receiver.

1. Install Batteries: Install two AAA 1.5V batteries into the remote control. Observe the positive and negative polarity markings inside the battery chamber. Close the battery cover. The indicator light will flash three times, confirming correct battery installation.
2. Initiate Pairing on Remote: Press and hold the frequency key (often labeled 'car select') on the remote control for approximately 2 seconds. The indicator light on the remote will begin to flash.
3. Power On Vehicle: Turn on the power supply of the electric ride-on car. The indicator light on the remote control should turn off, indicating successful pairing.
4. Troubleshooting Pairing: If the indicator light on the remote does not turn off, the pairing was unsuccessful. Turn off the power supply of the car and repeat steps 2 and 3.

Operating Instructions

Normal Operation

• The Bluetooth remote control features a slow start function, providing smooth acceleration for the vehicle.
• To stop the vehicle, press the emergency stop button on either the remote control or the manual control panel of the car.
• If the remote control is not used for 15 seconds, it will automatically cut off power to conserve battery.

Frequency Key Usage

• The frequency key operation is only required during initial setup or when replacing the remote control batteries.

Maintenance

• Ensure the remote control is not exposed to moisture or humidity, as this can negatively affect its performance or cause it to malfunction.
• If the remote control will not be used for an extended period, remove the batteries to prevent leakage and damage.

Troubleshooting

• Remote Control Not Responding: Verify that the batteries in the remote control are correctly installed and have sufficient charge. If the issue persists, re-attempt the frequency matching procedure as described in the 'Setup and Pairing' section.
• Vehicle Not Moving: Check the power supply of the electric car. Ensure the control box receiver is securely connected. If the remote control is not paired, the vehicle will not respond to remote commands.

Specifications

Warnings

• Do not mix old batteries with new ones, or different types of batteries.
• Always install batteries according to the positive (+) and negative (-) markings in the battery compartment.
• When the remote control is not in use for an extended period, remove the batteries.
• Dispose of waste batteries properly in designated recycling bins to prevent environmental pollution.