UpBright Go Power Plus GP-200 Car Power

UpBright Car DC Adapter User Manual

For GoPower Go Power Plus GP-200 Emergency Portable Power Station

1. Product Overview

The UpBright Car DC Adapter is designed to provide power to your GoPower Go Power Plus GP-200 45000 mAh Emergency Portable Power Station. This adapter allows you to charge or power your GP-200 unit directly from a vehicle's 12V cigarette lighter socket, making it ideal for use in cars, boats, RVs, and campers.

UpBright Car DC Adapter

Figure 1: Overview of the UpBright Car DC Adapter, showing the cigarette lighter plug and the DC barrel connector.

2. Setup and Connection

Follow these steps to properly connect your UpBright Car DC Adapter to your GoPower GP-200 Portable Power Station.

  1. Identify the DC Input Port: Locate the DC input port on your GoPower Go Power Plus GP-200 unit. This is typically labeled for 12V or DC input.
  2. Connect the Adapter to the Power Station: Insert the barrel connector end of the UpBright Car DC Adapter firmly into the DC input port of your GoPower GP-200.
  3. Connect to Vehicle Power: Insert the cigarette lighter plug end of the adapter into the 12V cigarette lighter socket of your vehicle (car, boat, RV, or camper). Ensure it is securely seated.
  4. Verify Connection: Once connected, the GoPower GP-200 should indicate that it is receiving power or charging, typically via an LED indicator or display.
UpBright adapter connected to GoPower Portable Power Station

Figure 2: The UpBright adapter shown connected to a GoPower Plus Emergency Portable Power Station, illustrating the compatibility.

UpBright adapter in various vehicle types

Figure 3: The UpBright Car DC Adapter is compatible with various 12V vehicle sockets, including those found in cars, boats, and other portable power stations.

3. Operating Instructions

Once the adapter is properly connected, the GoPower GP-200 will begin to draw power from your vehicle's 12V socket. This allows for charging the internal battery of the power station or powering devices connected to the power station while on the go.

  • Charging: The adapter will supply power to charge the GoPower GP-200's internal battery. Charging time will vary depending on the power station's battery level and the vehicle's electrical system.
  • Powering Devices: You can use the GoPower GP-200 to power compatible devices while it is connected to the vehicle's 12V socket via this adapter.
  • Vehicle Engine On: For optimal performance and to avoid draining your vehicle's battery, it is recommended to use the adapter while the vehicle's engine is running.

4. Maintenance and Care

To ensure the longevity and proper functioning of your UpBright Car DC Adapter, follow these maintenance guidelines:

  • Keep Clean and Dry: Regularly wipe the adapter with a dry, soft cloth. Avoid exposure to moisture, extreme temperatures, and direct sunlight.
  • Inspect for Damage: Periodically check the cable and connectors for any signs of wear, cuts, or damage. Do not use the adapter if any damage is observed.
  • Proper Storage: When not in use, store the adapter in a cool, dry place, away from direct heat sources and out of reach of children. Avoid tightly coiling the cable to prevent internal wire damage.

5. Troubleshooting

If you encounter issues while using your UpBright Car DC Adapter, refer to the following common problems and solutions:

ProblemPossible CauseSolution
Power Station not charging/receiving power.
  • Loose connection.
  • Vehicle's 12V socket is not active.
  • Blown fuse in vehicle's 12V socket.
  • Damaged adapter cable/connector.
  • Ensure both ends of the adapter are firmly connected.
  • Check if the vehicle's ignition is on (some sockets are only active with ignition).
  • Consult your vehicle's manual to check and replace the fuse for the 12V socket.
  • Inspect the adapter for visible damage. If damaged, discontinue use and replace.
Adapter feels warm during use.Normal operation under load.A slight warmth is normal. If it becomes excessively hot or emits smoke/odor, immediately disconnect and discontinue use.

6. Specifications

Key technical specifications for the UpBright Car DC Adapter:

  • Model: Go Power Plus GP-200 Car Power (Adapter for GP-200)
  • Wattage: 24 watts
  • Power Source: Corded Electric (via 12V vehicle socket)
  • Total USB Ports: 1 (Note: This specification might refer to the power station it's compatible with, as the adapter itself is a simple cable. Included as per product data.)
  • Dimensions: 12.7 x 5.08 x 2.54 cm (5 x 2 x 1 inches)
  • Weight: 85.05 g (0.19 lbs)

7. Warranty and Support

UpBright stands behind the quality of its products. This UpBright Car DC Adapter comes with the following warranty and support:

  • Money Back Guarantee: Enjoy a 30-day money-back guarantee from the date of purchase.
  • Service Warranty: A 1-year full service warranty is provided for this product.

For any questions, technical assistance, or warranty claims, please contact UpBright customer support through the retailer where the product was purchased or visit the official UpBright website for contact information.

© 2023 UpBright. All rights reserved.

Product specifications are subject to change without notice.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.