Introduction
This manual provides essential instructions for the safe and efficient operation, setup, and maintenance of your Illuminator WL-6000T 6,000-Lumen Dual Head LED Portable Flood Light. Please read all instructions carefully before use and retain this manual for future reference.
Safety Information
- Always ensure the power cord is fully uncoiled before use to prevent overheating.
- Do not operate the light with a damaged cord or plug.
- Avoid direct eye exposure to the LED light source.
- Ensure the light is placed on a stable, level surface to prevent tipping.
- This product is splashproof; however, do not submerge it in water.
- Disconnect from power supply before cleaning or performing any maintenance.
Package Contents
- Dual Head LED Work Light Assembly
- Detachable Metal Tripod
- 8-Foot Power Cord (integrated)
Setup
1. Tripod Assembly
- Unfold the legs of the tripod base until they are fully extended and stable.
- Loosen the height adjustment knob on the tripod pole.
- Extend the tripod pole to the desired height and tighten the knob securely.
2. Attaching the Light Assembly to the Tripod
The dual head light assembly can be used as a floor-level unit or mounted onto the tripod.
Image: The Illuminator WL-6000T flood light shown in both its full tripod-mounted configuration and its compact floor-level configuration, illustrating the versatility of the detachable tripod.
- Align the mounting bracket on the bottom of the dual head light assembly with the top of the tripod pole.
- Secure the light assembly to the tripod using the provided locking mechanism or screw, ensuring it is firmly attached.
3. Adjusting Light Heads
Image: A hand demonstrating the adjustment of one of the light heads on the Illuminator WL-6000T, showing the swivel and tilt capabilities.
- Each light head can rotate 360 degrees horizontally and tilt 120 degrees vertically.
- Loosen the adjustment knobs on the sides of each light head to position them as desired.
- Tighten the knobs firmly once the desired angle is achieved.
Operating
1. Power Connection
- Ensure the light is properly assembled and positioned.
- Plug the 8-foot power cord into a standard 120V AC electrical outlet.
2. Turning On/Off
- Locate the power switch on the unit.
- Flip the switch to the 'ON' position to illuminate the LED flood lights.
- Flip the switch to the 'OFF' position to turn off the lights.
3. Usage Examples
Image: The Illuminator WL-6000T flood light on its tripod, illuminating the engine bay of a car in a garage, demonstrating its utility for detailed work.
Image: The Illuminator WL-6000T flood light in its floor-level configuration, providing illumination close to the ground, suitable for various tasks.
- The dual heads allow for broad area lighting or focused illumination on specific tasks.
- Use the tripod for elevated lighting, or detach the light assembly for ground-level work.
Maintenance
Cleaning
- Always unplug the light before cleaning.
- Wipe the exterior surfaces with a soft, damp cloth. Do not use abrasive cleaners or solvents.
- Ensure the glass lenses are clean for optimal light output.
Storage
- Store the light in a cool, dry place away from direct sunlight.
- Coil the power cord neatly to prevent damage.
- The tripod can be collapsed for compact storage.
Troubleshooting
- Light does not turn on:
- Check if the power cord is securely plugged into a working outlet.
- Verify that the power switch is in the 'ON' position.
- Inspect the power cord for any visible damage.
- Light flickers:
- Ensure the power connection is stable.
- Try plugging into a different outlet.
- Light output is dim:
- Clean the glass lenses to remove any dirt or debris.
Specifications
| Feature | Specification |
|---|---|
| Model | WL-6000T |
| Light Output | 6,000 Lumens (total) |
| Light Source Type | LED (SMD) |
| Number of Light Sources | 2 (Dual Head) |
| Power Source | Corded Electric |
| Cord Length | 8-Foot (18/3 SJTW) |
| Material | Cast-Aluminum (casings), Glass (lenses) |
| Adjustability | 360-degree rotation, 120-degree tilt (each head) |
| Mounting Type | Floor Mount / Detachable Tripod |
| Tripod Height Adjustment | 22.75 to 44.75 inches (additional height) |
| Environmental Rating | Splashproof Outdoor Enclosure |
Warranty Information
For detailed warranty information, please refer to the official Illuminator product website or contact customer support. Keep your purchase receipt as proof of purchase for any warranty claims.
Support
If you encounter any issues not covered in this manual or require further assistance, please contact Illuminator customer support through their official website or the contact information provided with your product packaging.
