PHILIPS S5466/18
Philips Shaver Series 5000 User Manual
Model: S5466/18
Product Overview
The Philips Shaver Series 5000 (Model S5466/18) is an electric shaver designed for both wet and dry shaving. It features ComfortTech self-sharpening blades and 360-degree flexing contour heads for optimal skin contact and a comfortable shaving experience. The shaver includes an intuitive display for battery status, cleaning advice, and travel lock indication, along with a SmartClick precision trimmer for detailing.
Image: Philips Shaver Series 5000, including the shaver unit, a detachable precision trimmer, and a grey travel pouch.
What's in the Box
- Philips Shaver Series 5000 (Model S5466/18)
- SmartClick Precision Trimmer attachment
- Soft Travel Pouch
- Charging Cable
- User Manual (this document)
Setup
Initial Charging
Before first use, fully charge the shaver. Connect the charging cable to the shaver and plug it into a power outlet. The battery indicator on the shaver's display will show the charging progress. A full charge takes approximately 1 hour and provides up to 50 minutes of shaving time. A quick 5-minute charge can provide enough power for one full shave.
Image: The shaver's LED display indicates battery level, cleaning reminder, and travel lock status.
Attaching the Precision Trimmer
To attach the SmartClick precision trimmer, first remove the shaving head by pulling it upwards. Align the trimmer attachment with the shaver body and press it down until it clicks into place.
Operating the Shaver
General Shaving Instructions
- Ensure the shaver is charged.
- Press the power button to turn on the shaver.
- Move the shaving heads in small, circular motions over your skin. Apply gentle pressure.
- For best results, stretch your skin with your free hand to ensure hairs stand upright.
- After shaving, press the power button to turn off the shaver.
Image: A man demonstrating the use of the Philips Shaver Series 5000 on his cheek, highlighting the shaver's ergonomic design and flexible heads.
Wet Shaving
The Philips Shaver Series 5000 is fully waterproof and can be used for a comfortable wet shave with shaving foam or gel, or even in the shower. Apply shaving foam or gel to your skin before shaving. Rinse the shaver head under running water during and after use to prevent clogging.
Image: The shaver being used with shaving foam, demonstrating its wet shaving capability.
Using the Precision Trimmer
Once the precision trimmer is attached, turn on the shaver. Use the trimmer to shape your mustache, sideburns, or trim beard lines. Move the trimmer gently against the direction of hair growth for precise results.
Image: A man using the detachable precision trimmer to refine his sideburns, showcasing its utility for detailed grooming.
Maintenance
Daily Cleaning
After each use, especially after wet shaving, clean the shaver head. Press the release button to open the shaving unit. Rinse the shaving unit thoroughly under warm running water. Shake off excess water and allow it to air dry before closing the unit.
Image: The open shaving head of the Philips Shaver Series 5000 being cleaned under running water, illustrating the ease of maintenance.
Replacing Shaving Heads
For optimal performance, it is recommended to replace the shaving heads every 12 months. The shaver's display will indicate when replacement is due. The compatible replacement shaving head for this model is SH50/50 (ASIN B00ZR19API).
- Turn off the shaver and disconnect it from the power supply.
- Open the shaving unit by pressing the release button.
- Remove the retaining ring by turning it counter-clockwise.
- Take out the old shaving heads.
- Insert the new shaving heads into the shaving unit.
- Place the retaining ring back and turn it clockwise until it locks.
- Close the shaving unit.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Shaver does not turn on. | Battery is depleted. | Charge the shaver for at least 5 minutes for a quick shave, or 1 hour for a full charge. |
| Poor shaving performance. | Shaving heads are dirty or worn out. | Clean the shaving heads thoroughly. If performance does not improve, replace the shaving heads (SH50/50). |
| Shaver stops during use. | Battery is low. | Recharge the shaver. |
| Skin irritation after shaving. | Incorrect shaving technique or sensitive skin. | Ensure you are using small, circular motions with gentle pressure. Consider wet shaving with foam/gel. Allow skin to adapt to electric shaving. |
Specifications
- Model: S5466/18
- Shaving System: ComfortTech blades, 360° Contour Heads
- Shaving Type: Wet & Dry
- Battery Type: Lithium-ion
- Charging Time: 1 hour for full charge, 5 minutes for 1 shave
- Shaving Time: Up to 50 minutes
- Display: 3-level battery indicator, cleaning indicator, travel lock indicator
- Cleaning: Fully washable
- Accessories: SmartClick Precision Trimmer, Soft Pouch
- Power Source: Battery Powered
- Item Weight: 0.3 Kilograms
- Dimensions: 1 x 1 x 1 cm
- Blade Material: Stainless Steel
- Country of Origin: China
Warranty and Support
This Philips product comes with a standard manufacturer's warranty. For detailed warranty terms and conditions, please refer to the warranty card included in your product packaging or visit the official Philips support website.
For technical support, troubleshooting assistance, or to purchase replacement parts (such as SH50/50 shaving heads), please contact Philips Customer Service or visit their official website. Keep your proof of purchase for warranty claims.
- Official Philips Website: www.philips.com
- Replacement Shaving Head (SH50/50): ASIN B00ZR19API
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.