1. Introduction
Thank you for choosing the Bestway Steel Pro Round Above Ground Pool. This manual provides essential information for the safe assembly, operation, and maintenance of your pool. Please read all instructions carefully before setting up and using your pool. Keep this manual for future reference.
This pool is designed for outdoor use only. Adult supervision is required at all times when children are in or near the pool.
2. Package Contents
Please check to ensure all components listed below are present in your package. If any parts are missing or damaged, do not proceed with assembly and contact Bestway customer service.
- Pool Liner (Tritech material)
- Metal Frame Components (legs, horizontal beams, connectors)
- Filter Pump (Model 58381, 1.249 m³/h)
- Filter Cartridge (Type I, Model 58093)
- Repair Kit (for underwater use)
- Drainage Valve Adapter
- Instruction Manual
3. Safety Information
WARNING: Failure to follow these instructions can result in serious injury or death.
- Adult Supervision: Always supervise children in and around the pool.
- No Diving: This pool is not deep enough for diving. Do not dive or jump into the pool.
- Pool Barrier: Install fencing or approved barriers around the pool to prevent unsupervised access by children. Check local regulations for requirements.
- Chemicals: Handle pool chemicals with care. Follow manufacturer's instructions for storage and use. Keep chemicals out of reach of children.
- Electrical Safety: Ensure all electrical components (filter pump) are connected to a grounded outlet protected by a Ground Fault Circuit Interrupter (GFCI). Do not use extension cords.
- Cleanliness: Keep the pool area clean and free of debris to prevent slips and falls.
- Emergency Equipment: Keep a telephone and a list of emergency numbers near the pool.
4. Setup
4.1 Site Preparation
Choose a suitable location for your pool. The site must be:
- Level: The ground must be completely flat and level. An uneven surface can cause the pool to collapse, leading to serious injury and property damage.
- Clear: Remove all sharp objects, stones, roots, and debris from the area.
- Stable: The ground must be firm enough to withstand the weight of the filled pool (approximately 4,678 liters or 1,236 gallons).
- Accessible: Ensure there is access to a power outlet for the filter pump and a drainage point.
Figure 1: Pool Dimensions. External diameter 3.05 m, external height 0.76 m. Swimming surface diameter 2.95 m, swimming surface height 0.66 m.
4.2 Pool Assembly (Tool-Free)
- Carefully unpack all components and lay them out on the prepared ground.
- Spread the pool liner on the ground, ensuring the drain valve is positioned where you want it for future drainage.
- Assemble the metal frame according to the diagrams provided in the separate assembly guide (if applicable). The frame components are designed for tool-free connection. Ensure all connections are secure.
- Once the frame is assembled, gently pull the liner up and over the frame, ensuring it is centered and evenly distributed.
- Connect the filter pump hoses to the designated inlet and outlet ports on the pool liner. Refer to the filter pump manual for specific connection instructions. Ensure all clamps are tightened securely.
Figure 2: Assembled pool frame and liner before filling.
5. Operating the Pool
5.1 Filling the Pool
- Before filling, ensure the drain valve cap is securely closed.
- Begin filling the pool with water. As the pool fills, smooth out any wrinkles in the bottom of the liner, working from the center outwards.
- Fill the pool to approximately 90% capacity, which is about 4,678 liters (1,236 gallons). Do not overfill.
Figure 3: Pool in use with filter pump connected.
5.2 Filter Pump Operation
The included filter pump (Model 58381) is crucial for maintaining water clarity and hygiene. Refer to the separate filter pump manual for detailed operating instructions.
- Ensure the pump is connected to a proper electrical outlet (GFCI protected).
- Run the filter pump for several hours each day (typically 4-8 hours, depending on usage and water conditions) to circulate and filter the water.
- Never operate the pump when people are in the pool.
6. Maintenance
6.1 Water Chemistry
Proper water chemistry is essential for a safe and clean pool. Regularly test your pool water and adjust chemicals as needed.
- pH Level: Maintain pH between 7.2 and 7.6.
- Chlorine: Maintain free chlorine levels between 1-3 ppm.
- Alkalinity: Maintain total alkalinity between 80-120 ppm.
6.2 Cleaning
- Skimming: Use a skimmer net to remove leaves, insects, and other debris from the water surface daily.
- Vacuuming: Periodically vacuum the pool bottom to remove settled dirt and debris.
- Liner Cleaning: Wipe down the pool liner with a soft brush or cloth to prevent algae buildup.
6.3 Filter Cartridge Maintenance
The filter cartridge (Type I, Model 58093) should be cleaned regularly and replaced every 2-4 weeks, or more frequently depending on pool usage and water conditions.
- Turn off and unplug the filter pump before performing any maintenance.
- Remove the filter housing cover and take out the cartridge.
- Rinse the cartridge thoroughly with a garden hose. If it remains dirty or discolored, replace it with a new one.
- Reassemble the filter pump.
6.4 Winterization
When the swimming season ends, it is recommended to drain and disassemble your pool for storage.
- Drain: Connect a garden hose to the integrated drainage valve. Open the valve to drain the water to a suitable location.
- Clean: Once empty, clean the pool liner thoroughly and allow it to dry completely.
- Disassemble: Carefully disassemble the metal frame.
- Store: Store the liner and frame components in a dry, protected area, away from extreme temperatures and pests.
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Pool is leaking | Small puncture or tear in liner | Use the included underwater repair kit to patch the leak. Ensure the area is clean before applying the patch. |
| Water is cloudy | Insufficient filtration, improper chemical balance, high organic load | Check filter cartridge for cleanliness and replace if necessary. Test water chemistry and adjust pH and chlorine levels. Run filter pump for longer periods. Shock treat the pool if needed. |
| Filter pump not working | No power, clogged impeller, airlock | Check power connection and GFCI. Ensure pump is primed (refer to pump manual). Clean impeller if accessible (unplug pump first). |
| Algae growth | Low chlorine, high pH, poor circulation | Adjust chlorine and pH levels. Brush pool walls and floor. Run filter pump. Consider using an algaecide. |
8. Specifications
- Model: Bestway Steel Pro Round Pool (56679)
- Dimensions (External): Diameter 3.05 m (10 ft), Height 0.76 m (30 in)
- Swimming Surface Dimensions: Diameter 2.95 m (9.7 ft), Height 0.66 m (26 in)
- Water Capacity (90%): 4,678 Liters (1,236 Gallons)
- Liner Material: Tritech (reinforced PVC and polyester)
- Frame Material: Corrosion-resistant steel
- Filter Pump: Bestway Flowclear™ Filter Pump (Model 58381)
- Filter Pump Flow Rate: 1.249 m³/h (330 gal/h)
- Filter Cartridge Type: Bestway Type I (Model 58093)
- Assembly: Tool-free, approximately 20 minutes for 2-3 people (excluding filling)
9. Warranty and Support
Bestway products are manufactured to high-quality standards. For specific warranty information, please refer to the warranty card included with your product or visit the official Bestway website. If you encounter any issues or require assistance, please contact Bestway customer support with your model number (56679) and proof of purchase.
For further assistance, you may visit the Bestway Official Website.