1. Introduction
This manual provides essential information for the safe and efficient operation, installation, and maintenance of your White Point WPD104B Drawer Dishwasher. Please read all instructions carefully before using the appliance and retain this manual for future reference.
2. Safety Information
Always adhere to the following safety precautions to prevent injury or damage:
- Ensure the dishwasher is properly grounded before use.
- Do not allow children to operate or play with the dishwasher.
- Keep all detergents and rinse aids out of reach of children.
- Never open the dishwasher door during operation, especially during the hot wash or drying cycle.
- Use only detergents and rinse aids specifically designed for automatic dishwashers.
- Do not store or use flammable materials near the dishwasher.
- In case of malfunction, disconnect the appliance from the power supply and contact qualified service personnel.
3. Setup and Installation
3.1 Unpacking
Carefully remove all packaging materials. Inspect the dishwasher for any shipping damage. Report any damage to your retailer immediately.
3.2 Positioning the Dishwasher
The White Point WPD104B is a freestanding drawer dishwasher. Place it on a firm, level surface. Ensure there is adequate space for ventilation and access to water and drainage connections.
Image: The White Point WPD104B Drawer Dishwasher in its closed, freestanding position. This view shows the exterior design and control panel.
3.3 Water and Drainage Connections
- Connect the water inlet hose to a cold water supply with a minimum pressure of 0.04 MPa and a maximum of 1 MPa.
- Ensure the drain hose is securely connected to a suitable drain pipe, preventing kinks or blockages.
- Verify all connections are tight to prevent leaks.
3.4 Electrical Connection
Connect the dishwasher to a properly grounded electrical outlet. Ensure the voltage and frequency match the specifications on the rating plate of the appliance. Do not use extension cords or adapters.
4. Operating Instructions
4.1 Loading the Dishwasher
For optimal cleaning, load dishes correctly. Scrape off large food particles before loading. Place larger items in the lower rack and smaller, more delicate items in the upper rack. Ensure items do not block the spray arms.
Image: The interior of the White Point WPD104B Drawer Dishwasher, showing the upper and lower racks designed for efficient loading of various dish sizes.
4.2 Adding Detergent and Rinse Aid
- Fill the detergent dispenser with the appropriate amount of dishwasher detergent according to the manufacturer's instructions and the soil level of your dishes.
- Check the rinse aid indicator and refill the rinse aid dispenser if necessary. Rinse aid helps with drying and prevents spots.
4.3 Selecting a Wash Program
The WPD104B offers multiple wash programs. Use the control panel to select the desired program:
- Normal: For regularly soiled dishes.
- Intensive: For heavily soiled dishes and pots.
- Delicate: For fragile items and lightly soiled dishes.
4.4 Starting a Cycle
Close the dishwasher door firmly. Press the 'Start' button on the control panel. The selected program will begin.
4.5 Interrupting or Canceling a Cycle
To interrupt a cycle, carefully open the door. The dishwasher will pause. To cancel, press and hold the 'Start/Cancel' button (or equivalent) for a few seconds. The dishwasher will drain and reset.
5. Maintenance
5.1 Cleaning the Filters
Regularly clean the filter system located at the bottom of the dishwasher tub to ensure efficient operation. Remove the filter assembly, rinse it under running water, and remove any trapped food particles. Reassemble and replace securely.
5.2 Cleaning the Spray Arms
Check the spray arm nozzles for blockages. If necessary, remove the spray arms and clear any debris from the holes using a thin wire or toothpick. Rinse thoroughly and reattach.
5.3 Exterior Cleaning
Wipe the exterior surfaces of the dishwasher with a soft, damp cloth. Do not use abrasive cleaners or solvents.
5.4 Winterization (for non-use in cold climates)
If the dishwasher will be unused for an extended period in an area subject to freezing temperatures, it is recommended to drain all water from the appliance. Disconnect water supply, drain hoses, and run a short cycle to clear residual water. Consult a qualified technician if unsure.
6. Troubleshooting
Before contacting service, review the following common issues and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Dishwasher does not start | Power cord not plugged in; door not closed properly; fuse blown. | Check power connection; ensure door is latched; check household fuse/breaker. |
| Dishes are not clean | Improper loading; clogged spray arms; insufficient detergent; clogged filters. | Reload dishes correctly; clean spray arms; add more detergent; clean filters. |
| Water not draining | Clogged drain hose; clogged filter. | Check and clear drain hose; clean filters. |
| Excessive noise | Dishes rattling; foreign object in pump; improper installation. | Rearrange dishes; inspect pump area; ensure dishwasher is level. |
7. Specifications
| Feature | Specification |
|---|---|
| Model Name | WPD104B |
| Brand | White Point |
| Type | Drawer Dishwasher |
| Place Settings | 10 |
| Color | Black |
| Material | Metal |
| Wash Programs | Normal, Intensive, Delicate |
| Installation Type | Freestanding |
| Item Weight | 21 Kilograms |
| Package Dimensions | 55 x 41 x 31 cm |
8. Warranty Information
This White Point WPD104B Drawer Dishwasher comes with a standard manufacturer's warranty. Please refer to the warranty card included with your purchase for specific terms, conditions, and duration. Keep your proof of purchase for warranty claims. Extended warranty options may be available from your retailer.
9. Customer Support
For technical assistance, service requests, or inquiries regarding your White Point WPD104B Drawer Dishwasher, please contact your authorized White Point service center or the retailer from whom you purchased the appliance. Ensure you have your model number (WPD104B) and serial number ready when contacting support.