GoBoard 1 1/4 inch HI-LO Fasteners for Wood Studs

1. Introduction

The GoBoard 1 1/4 inch HI-LO Fasteners are specifically engineered for securely attaching GoBoard panels to wood stud framing. These fasteners feature a unique HI-LO thread design for superior grip and easy installation, ensuring a stable and durable substrate for tile and other finishes. This manual provides essential information for safe and effective use of these fasteners.

2. Safety Information

• Always wear appropriate personal protective equipment (PPE), including safety glasses, to protect against flying debris.
• Ensure the work area is well-lit and clear of obstructions.
• Use power tools according to their manufacturer's instructions.
• Keep fasteners out of reach of children and pets.
• Do not use damaged or bent fasteners.

3. Package Contents

Each box contains:

• 700 GoBoard 1 1/4 inch HI-LO Fasteners

4. Installation

4.1 Tools Required

• Cordless drill or impact driver
• Appropriate driver bit (e.g., Phillips head, star drive, as indicated by fastener head)
• Measuring tape
• Pencil or marker

4.2 Preparation

• Ensure GoBoard panels are cut to size and properly aligned with wood studs.
• Mark fastener locations according to GoBoard installation guidelines (typically 6 inches on center).

4.3 Fastener Application

1. Position the GoBoard panel against the wood studs.
2. Place a fastener on the tip of your driver bit.
3. Align the fastener perpendicular to the GoBoard surface and the wood stud.
4. Drive the fastener through the GoBoard and into the wood stud until the fastener head is flush with the GoBoard surface. Avoid over-driving, which can damage the board's surface layer.
5. Repeat for all marked fastener locations, ensuring consistent spacing and depth.

Image: A single blue GoBoard 1 1/4 inch HI-LO fastener, showing its flat head and distinct HI-LO thread pattern designed for secure grip in wood.

5. Maintenance

GoBoard fasteners do not require maintenance after installation. For unused fasteners, store them in their original packaging in a dry environment to prevent corrosion and maintain their integrity.

6. Troubleshooting

• Fastener not driving smoothly: Ensure the driver bit is correctly seated in the fastener head and that the fastener is aligned perpendicular to the surface. Check for obstructions in the wood stud.
• Breaking the GoBoard surface layer: This typically occurs from over-driving or driving the fastener at an angle. Ensure the fastener is driven perpendicular to the board and stop when the head is flush. Adjust clutch settings on your drill if available.
• Driver bit not fitting fastener head: Verify that you are using the correct type and size of driver bit for the fastener head. Using an incorrect bit can lead to stripping the fastener head or poor driving performance.

7. Specifications

8. Warranty and Support

Specific warranty information for GoBoard 1 1/4 inch HI-LO Fasteners is not provided in this document. For detailed warranty terms, technical support, or further assistance, please contact GoBoard customer service directly or visit the official GoBoard website.

GoBoard Official Website: www.goboard.com