ZunDian 6-in-1 1800 Amp Jump Starter & Power Station

Introduction

The ZunDian 6-in-1 Power Station is a versatile and essential tool for automotive emergencies, outdoor activities, and general power needs. It integrates a powerful jump starter, a 260 PSI air compressor, a 400W AC power inverter, a 12V power station, a 15W USB-A port, and a 300-lumen LED flashlight into one compact unit. Designed for convenience and reliability, it ensures you are prepared for various situations.

Safety Information

WARNING: Read all safety instructions before use.

• Always wear eye protection when operating the jump starter.
• Ensure proper polarity connections (positive to positive, negative to negative) to avoid damage or injury. The unit features 10 intelligent protection systems for safety.
• Do not expose the unit to rain or wet conditions.
• Keep out of reach of children.
• Operate in a well-ventilated area.
• Do not disassemble the unit. Refer to qualified service personnel for repairs.

Product Overview

The ZunDian 6-in-1 Power Station is designed for ease of use with clearly labeled controls and integrated components.

Figure 1: Front view of the ZunDian 6-in-1 Power Station.

Front Panel Controls

• Pressure Gauge: Displays air pressure for the compressor.
• Compressor Switch: Activates the air compressor.
• Reverse Polarity Indicator: Illuminates if jumper cables are connected incorrectly.
• Light Switch: Turns the LED worklight on/off.
• DC Volts Meter: Shows the unit's battery voltage.
• Charging Jack: Input for recharging the power station.
• Battery Status Button: Press to check the remaining battery charge.
• DC 12V Sockets: Two 12V outlets for powering DC devices.
• LED Worklight: Provides illumination for dark environments.

Figure 2: Detailed view of the front panel controls.

Rear Panel Features

• USB-A Port: 15W output for charging mobile devices.
• AC Outlets: Two 110V/120V outlets (400W total) for AC devices.
• Inverter Switch: Activates the AC power inverter.
• Jumper Safety Switch: Must be turned ON for jump-starting functionality.
• Air Compressor Hose Storage: Compartment for the integrated air compressor hose.

Figure 3: Rear view of the power station showing outlets and switches.

Included Accessories

• Integrated heavy-duty battery booster jumper clamps.
• Integrated inflatable hose.
• 1x AC Power Adapter.
• 1x DC Power Adapter.
• 1x User Manual.
• 1x Car accessories (likely various nozzles for inflation).
• 1x Car Repair Tools (e.g., safety hammer).

Setup

Initial Charging

Before first use, fully charge the ZunDian Power Station. It comes with a 22Ah sealed lead-acid rechargeable battery.

1. Connect the AC Power Adapter to the Charging Jack on the front panel.
2. Plug the AC Power Adapter into a standard wall outlet.
3. Allow the unit to charge until the battery indicator shows full charge.
4. Alternatively, use the DC Power Adapter to charge the unit from a 12V car outlet.

Figure 4: Charging the power station.

Operating Instructions

Jump Starting a Vehicle

The 1800 Peak Amp Jump Starter can start 8.5L Gasoline Engines and 6.0L Diesel Engines for various 12V vehicles.

1. Ensure the vehicle's ignition is off.
2. Connect the red (positive) jumper clamp to the positive (+) terminal of the vehicle's battery.
3. Connect the black (negative) jumper clamp to a clean, unpainted metal part of the vehicle's engine block or chassis, away from the battery.
4. Turn the Jumper Safety Switch on the rear panel to the 'ON' position.
5. Attempt to start the vehicle. If it doesn't start immediately, wait a few minutes and try again.
6. Once the vehicle starts, immediately turn the Jumper Safety Switch to 'OFF'.
7. Disconnect the black (negative) clamp first, then the red (positive) clamp.

Figure 5: Jump starting a vehicle.

Using the Air Compressor

The 260 PSI air compressor can inflate tires (195/65/R15 automotive tires from 0 psi to 35 psi in 3 minutes) and other inflatables.

1. Retrieve the inflatable hose from its storage compartment on the rear panel.
2. Attach the hose securely to the tire valve stem or appropriate inflatable adapter.
3. Turn the Compressor Switch on the front panel to 'ON'.
4. Monitor the pressure gauge until the desired pressure is reached. The sensor automatically stops when proper pressure is reached.
5. Turn the Compressor Switch to 'OFF' and disconnect the hose.

Figure 6: Inflating a car tire with the air compressor.

Figure 7: Multi-purpose air compressor for vehicles, bicycles, balls, and inflatables.

Portable Power Station Functionality

The unit can power up to 6 devices simultaneously with its 400W AC inverter, USB-A port, and 12V DC sockets.

1. For AC devices, turn the Inverter Switch on the rear panel to 'ON'. Plug your 110V/120V devices into the AC outlets.
2. For USB devices, plug your USB cable into the USB-A Port on the rear panel.
3. For 12V DC devices, plug them into the DC 12V Sockets on the front panel.

Figure 8: Powering various devices with the ZunDian Power Station.

Maintenance

Care and Storage

• If not used for a long time, charge the battery jumper within three months to maintain battery health.
• Store the unit in a cool, dry place away from direct sunlight and extreme temperatures.
• Keep the unit clean and free from dust and debris.

Troubleshooting

Specifications

Warranty and Support

The ZunDian 6-in-1 Power Station comes with a 1-year warranty and friendly customer service. For any questions, issues, or to request replacement parts (e.g., lost charger or nozzle), please contact ZunDian customer support.

Contact Information:

• Refer to your user manual for specific contact details or visit the official ZunDian website.