Kismile Oscillating Parabolic Space Heater Instruction Manual

Introduction

This manual provides essential information for the safe and efficient operation of your Kismile Oscillating Parabolic Space Heater. Please read all instructions carefully before use and retain this manual for future reference.

Figure 1: Kismile Oscillating Parabolic Space Heater

Important Safety Instructions

WARNING: To reduce the risk of fire, electric shock, or injury, observe the following:

• Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
• This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
• Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
• Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
• Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair.
• Do not use outdoors.
• To disconnect heater, turn controls to OFF, then remove plug from outlet.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
• A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable vapors or liquids are used or stored.
• Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
• Always unplug heater when not in use.

Built-in Safety Features:

• Tip-Over Protection: The heater is equipped with a safety tip-over switch that automatically turns the unit off if it is accidentally tipped over. The unit will resume operation once placed upright on a flat, stable surface.
• Overheating Protection: An internal overheat protection system is designed to shut off the unit if internal components reach an unsafe temperature. This prevents potential fire hazards.
• Cool-to-Touch Flocked Grill: The front grill remains cool to the touch during operation, reducing the risk of accidental burns.

Figure 2: Visual representation of Tip-Over and Overheating Protection

Product Overview

The Kismile Oscillating Parabolic Space Heater is designed to provide efficient and targeted warmth for indoor spaces. It features adjustable heat settings, an oscillation function, and a convenient timer.

Components:

• Heating Element: Parabolic radiant dish for focused heat.
• Control Dials: Two rotary dials for power/heat settings and timer.
• Oscillation Base: Allows for wide-angle heat distribution.
• Built-in Handle: For easy portability.

Figure 3: Multi-function regulation dials

Figure 4: Heater with built-in handle for portability

Setup

1. Unpack: Carefully remove the heater from its packaging. Retain packaging for off-season storage.
2. Placement: Place the heater on a firm, level surface. Ensure there are no obstructions within 3 feet (0.9 m) of the front, sides, or rear of the heater.
3. Power Connection: Plug the power cord directly into a 120V AC, 60Hz electrical outlet. Do not use extension cords or power strips.

Operating Instructions

Power On/Off and Heat Settings:

Use the right-hand dial (Heat/Oscillation Control) to select the desired heat mode:

• OFF: Turns the heater off.
• I (Low Heating): Activates the low heat setting (600W).
• I with Oscillation: Activates low heat with 65-degree oscillation.
• II (High Heating): Activates the high heat setting (1000W).
• II with Oscillation: Activates high heat with 65-degree oscillation.

Figure 5: Heat and Oscillation Mode Selection

Adjustable Timer:

Use the left-hand dial (Timer Control) to set an operating duration:

• Rotate the dial clockwise to select a time between 30 to 180 minutes.
• The heater will automatically turn off once the set time has elapsed.
• To operate continuously, set the dial to the "ON" position.

Figure 6: Adjustable Timer Settings

Oscillation Function:

When a heat setting with oscillation is selected, the heater will rotate 65 degrees to distribute warmth across a wider area.

Figure 7: Heater demonstrating 65-degree oscillation

Rapid Heating:

The parabolic design ensures rapid heat output, providing warmth almost instantly after activation.

Figure 8: Heater providing rapid heat

Maintenance

• Cleaning: Always unplug the heater before cleaning. Use a soft, damp cloth to wipe the exterior surfaces. Do not use abrasive cleaners or solvents. Ensure no water enters the interior of the heater.
• Storage: When not in use, store the heater in a cool, dry location. It is recommended to store it in its original packaging to protect it from dust and damage.

Troubleshooting

Specifications

Official Product Video

Watch this official video from Kismile Direct for a visual guide on the heater's features and operation.

Warranty and Support

For warranty information, technical support, or any inquiries regarding your Kismile Oscillating Parabolic Space Heater, please contact Kismile Direct customer service. Refer to the product packaging or the official Kismile website for the most up-to-date contact details.

Related documentsS5315

RELATED DOCUMENTKISMILE PTC-901C Ceramic Fan Heater: User Guide, Safety & OperationComprehensive guide for the KISMILE PTC-901C Ceramic Fan Heater. Covers features, detailed safety precautions, operating instructions, cleaning, maintenance, storage, and troubleshooting for optimal and safe use.View document →