MaxLax EL Wire White (Model el wire 0004) Instruction Manual

1. Product Overview

The MaxLax EL Wire is a flexible, glowing rope light designed for various decorative applications. It operates on battery power, offering portability and ease of use. This model features a 9.8ft (3m) wire length and a 0.09-inch (2.3mm) diameter, providing 360-degree omnidirectional lighting.

Key features include:

• Noise Reduction: Equipped with an upgraded battery pack to minimize inverter noise.
• Safe & Energy-Efficient: Radiation-free and designed for low power consumption.
• Flexible & Cuttable: The wire can be bent into various shapes and cut to desired lengths (additional tools required for shaping and sealing cut ends).
• Multiple Light Modes: Offers Steady On, Strobe, and Blink modes, in addition to Off.

2. Setup Instructions

Follow these steps to set up your MaxLax EL Wire:

1. Install Batteries: Open the battery compartment on the portable power pack. Insert two (2) AA batteries (not included), ensuring correct polarity. Close the compartment securely.
2. Connect EL Wire: Plug the connector from the EL wire into the corresponding port on the battery pack. Ensure a firm connection.

For a visual guide on setup, please refer to the video below:

3. Operating Instructions

Once the batteries are installed and the EL wire is connected, operate the device using the button on the battery pack:

• Press the button once for Steady On mode.
• Press the button a second time for Strobe (fast flashing) mode.
• Press the button a third time for Blink (slow flashing) mode.
• Press the button a fourth time to turn the EL wire Off.

4. Maintenance

To ensure the longevity and optimal performance of your MaxLax EL Wire, follow these maintenance guidelines:

• Storage: When not in use, store the EL wire in a cool, dry place away from direct sunlight and extreme temperatures.
• Cleaning: Gently wipe the EL wire and battery pack with a soft, dry cloth. Avoid using abrasive cleaners or solvents.
• Battery Replacement: Replace batteries promptly when the light dims or stops working to prevent corrosion in the battery compartment.
• Water Exposure: The EL wire is not water resistant. Avoid exposure to water or high humidity.

5. Troubleshooting

Issue: Audible Noise from Inverter

Solution: The upgraded battery pack is designed to minimize noise, but a slight hum may still be present, especially in quiet environments. This is normal for EL wire technology. For best visual effect, use in dark settings where the light is the primary focus.

Issue: EL Wire Does Not Light Up

Solution:

• Check if the batteries are inserted correctly with the right polarity.
• Ensure the batteries are fresh and not depleted.
• Verify that the EL wire connector is securely plugged into the battery pack.
• Press the power button to cycle through the modes, ensuring it's not in the 'Off' position.

Issue: Difficulty Shaping the Wire

Solution: The EL wire is flexible and can be bent into shapes. However, to fix it into a specific, rigid shape, additional tools or fasteners (e.g., clips, adhesive, wire ties) may be required. The wire itself does not retain complex shapes without external support.

6. Specifications

7. Warranty and Support

For warranty information or technical support, please refer to the product packaging or contact MaxLax customer service directly. Contact details are typically provided with your purchase or on the manufacturer's official website.