Introduction
This user manual provides essential information for the safe and efficient operation of your KUPPET Compact Twin Tub Portable Mini Washing Machine. This semi-automatic appliance is designed for light to medium laundry loads, offering separate wash and spin functions with a total capacity of 26 lbs (18 lbs for washing, 8 lbs for spinning). Its compact design and built-in drain pump make it suitable for various living spaces, including apartments, dorms, and RVs.
Safety Instructions
- Always ensure the washing machine is placed on a stable, level surface to prevent vibration and noise during operation.
- Do not operate the machine with a damaged power cord or plug.
- Keep children and pets away from the appliance during operation.
- Do not immerse the electrical components in water.
- Unplug the machine from the power outlet before cleaning or performing any maintenance.
- Ensure proper ventilation around the machine.
- Do not overload the washer or spinner tubs beyond their specified capacities.
- Avoid washing waterproof materials or items that float excessively, as this may cause imbalance.
- Always close the lids during operation to prevent water splashing and ensure safety.
Product Components
Familiarize yourself with the main parts of your KUPPET Portable Mini Washing Machine:




Setup
- Unpacking: Carefully remove the washing machine from its packaging. Inspect for any damage during transit.
- Placement: Position the machine on a firm, flat surface. Ensure there is enough space around it for ventilation and operation.
- Water Supply: Connect the water inlet hose to a cold water tap. The machine has two water inlets, one for the wash tub and one for the spin tub, though typically water is added to the wash tub.
- Drainage: Extend the built-in drain hose (approximately 56.3 inches long) to a suitable drain area, such as a sink or floor drain. Ensure the hose is not kinked or blocked.
- Power Connection: Plug the power cord into a standard 110V/60Hz electrical outlet.
Operating Instructions
The KUPPET Twin Tub Washing Machine allows for separate or simultaneous operation of the wash and spin functions.
Washing Clothes:
- Load Laundry: Open the wash tub lid and place your clothes inside. Do not exceed the 18 lbs capacity.
- Add Water and Detergent: Fill the wash tub with the appropriate amount of water and detergent.
- Set Wash Selector: Turn the "Wash Selector" knob to either "Normal" for regular loads or "Gentle" for delicate items.
- Set Wash Timer: Turn the "Wash Timer" knob to your desired wash time, up to 15 minutes. The machine will begin washing.
- Drain Water: Once the wash cycle is complete, turn the "Wash Selector" knob to "Drain" to empty the water from the wash tub.
Spin Drying Clothes:
- Transfer Laundry: Carefully transfer the washed clothes from the wash tub to the spin tub. Ensure clothes are evenly distributed to prevent imbalance. Do not exceed the 8 lbs capacity.
- Place Spin Cover: Place the spin cover securely over the clothes in the spin tub.
- Set Spin Timer: Turn the "Spin Timer" knob to your desired spin time, up to 5 minutes. The machine will begin spinning.
- Remove Clothes: Once the spin cycle is complete, remove the clothes. They will be damp but significantly drier than after washing.
Maintenance
- Cleaning the Exterior: Wipe the exterior of the machine with a soft, damp cloth. Avoid abrasive cleaners.
- Cleaning the Tubs: Periodically clean the inside of the wash and spin tubs to prevent residue buildup. You can run a short cycle with just water and a small amount of vinegar.
- Drain Hose: Ensure the drain hose remains clear of blockages.
- Storage: If storing the machine for an extended period, ensure both tubs are completely dry and the drain hose is empty. Store in a dry, cool place.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Machine does not start. | Not plugged in; power outage; lid not closed properly. | Check power connection; verify power supply; ensure lids are fully closed. |
| Water does not drain. | Drain hose kinked or blocked; drain selector not set to "Drain". | Straighten drain hose and clear any blockages; turn "Wash Selector" knob to "Drain". |
| Excessive vibration or noise during spin. | Uneven load in spin tub; machine not on a level surface. | Redistribute clothes evenly in the spin tub; adjust machine's position on a level surface. |
| Clothes not clean after washing. | Overloaded tub; insufficient detergent; incorrect wash cycle selected. | Reduce load size; use appropriate amount of detergent; select suitable wash cycle (Normal/Gentle). |
Specifications
| Feature | Detail |
|---|---|
| Brand | KUPPET |
| Model Number | 26wash |
| Product Dimensions | 27.4 x 16.1 x 31.9 inches (W x D x H) |
| Item Weight | 26 pounds |
| Total Capacity | 26 lbs |
| Wash Capacity | 18 lbs |
| Spin Capacity | 8 lbs |
| Max Spin Speed | 1300 RPM |
| Power Supply | 110V/60Hz |
| Total Power | 420W (Wash: 280W / Dry: 140W) |
| Drainage Tube Dimensions | 56.3 inches |
| Control Type | Knob |
| Access Location | Top Load |
Warranty and Support
For warranty information or technical support, please refer to the contact details provided with your purchase documentation or visit the official KUPPET website. It is recommended to retain your proof of purchase for warranty claims.

