ByronStatics AM66 Portable AM/FM Radio User Manual

1. Introduction

Thank you for purchasing the ByronStatics AM66 Portable AM/FM Radio. This manual provides essential information for the safe and efficient operation of your radio. Please read it thoroughly before use and retain it for future reference.

2. Safety Information

• Do not expose the unit to rain or moisture to prevent fire or electric shock.
• Do not open the casing. Refer servicing to qualified personnel only.
• Avoid placing the unit near heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
• Use only attachments/accessories specified by the manufacturer.
• Unplug this apparatus during lightning storms or when unused for long periods.
• Dispose of used batteries responsibly according to local regulations.

3. Package Contents

Ensure all items are present upon unpacking:

• ByronStatics AM66 Portable AM/FM Radio
• Power Adapter (AC 120V)
• Owner's Manual (this document)

4. Product Overview

Familiarize yourself with the components and controls of your radio.

5. Setup

5.1 Powering the Radio

Your ByronStatics AM66 radio can be powered by either the included AC adapter or 4 AA batteries (not included).

Using the AC Adapter:

1. Locate the DC input jack on the back of the radio.
2. Insert the small plug of the AC adapter into the DC input jack.
3. Plug the AC adapter into a standard 120V/60Hz wall outlet.

Using Batteries:

1. Open the battery compartment cover on the back of the radio.
2. Insert 4 new 1.5V AA (UM3) batteries, ensuring correct polarity (+/-) as indicated inside the compartment.
3. Close the battery compartment cover securely.

Note: When the AC adapter is connected, battery power is automatically disconnected. Remove batteries if the radio will not be used for an extended period to prevent leakage.

6. Operating Instructions

6.1 Turning On/Off and Band Selection

1. Locate the AM/FM/OFF knob on the top of the radio.
2. Rotate the knob to 'AM' for Amplitude Modulation radio or 'FM' for Frequency Modulation radio. The radio will turn on.
3. To turn off the radio, rotate the knob to 'OFF'.

6.2 Tuning to Stations

1. Once the radio is powered on and a band (AM or FM) is selected, slowly rotate the large tuning dial on the front of the radio.
2. Observe the frequency indicator on the dial as you tune. Stop when you hear your desired station clearly.

6.3 Volume Control

1. The volume control knob is located on the top of the radio, opposite the AM/FM/OFF knob.
2. Rotate the knob clockwise to increase the volume and counter-clockwise to decrease it.

6.4 Antenna Adjustment

• For FM reception: Extend the telescopic antenna fully and rotate it for optimal signal reception.
• For AM reception: The radio uses a built-in ferrite bar antenna. Rotate the entire radio for best AM reception. The telescopic antenna is not used for AM.

6.5 Earphone Use

For private listening, plug standard 3.5mm earphones (not included) into the earphone jack located on the side of the radio. The built-in speaker will automatically mute.

7. Maintenance

7.1 Cleaning

Wipe the radio's exterior with a soft, slightly damp cloth. Do not use abrasive cleaners, waxes, or solvents as they may damage the finish.

7.2 Battery Replacement

When the radio's sound becomes weak or distorted, it is time to replace the batteries. Follow the instructions in Section 5.1 for battery installation.

7.3 Storage

If storing the radio for an extended period, remove the batteries to prevent potential leakage and damage. Store in a cool, dry place away from direct sunlight.

8. Troubleshooting

9. Specifications

10. Warranty and Support

BYRONSTATICS products are designed for reliability and performance. For warranty information or technical support, please refer to the documentation included with your purchase or contact BYRONSTATICS customer service through their official website or the retailer where the product was purchased.