Surpassed NP-FH50 Li-ion Battery Pack User Manual for Sony Handycam Camcorders DCR-SR40, DCR-SR42, DCR-SR45

1. Introduction

This manual provides essential instructions for the safe and effective use of your Surpassed NP-FH50 Li-ion Battery Pack. Please read this manual thoroughly before using the product and retain it for future reference.

2. Product Features

High-quality replacement Li-ion battery.
High energy density for extended usage.
Long cycle life for durability.
Provides extra power for digital video cameras and camcorders.
High capacity: 1080mAh.
Absolutely no memory effect, allowing charging at any time.
100% decoded and compatible with original cameras and chargers.

3. Package Contents

1 x Surpassed NP-FH50 Li-ion Battery Pack

4. Compatibility

This battery pack is compatible with Sony NP-FH50 series Lithium-ion batteries and is designed for use with the following Sony Handycam Camcorder models:

Sony DCR-SR40
Sony DCR-SR42
Sony DCR-SR45
And other compatible models using NP-FH50 batteries.

5. Setup and Installation

Follow these steps to install the battery pack into your compatible camcorder:

Ensure the camcorder is powered off before installation.
Locate the battery compartment on your camcorder. Refer to your camcorder's manual for specific instructions if needed.
Open the battery compartment cover.
Align the battery pack with the battery slot, ensuring the contacts match correctly.
Gently slide the battery into the compartment until it clicks into place. Do not force the battery.
Close the battery compartment cover securely.

Surpassed NP-FH50 Li-ion Battery Pack, front view

Figure 1: Front view of the Surpassed NP-FH50 Li-ion Battery Pack, showing the model number, voltage, capacity, and safety warnings. This image illustrates the battery's primary labeling and contact points.

6. Charging the Battery

To charge your Surpassed NP-FH50 Li-ion Battery Pack:

Remove the battery from the camcorder if it is installed.
Insert the battery into a compatible Sony NP-FH50 series battery charger.
Connect the charger to a power source.
Monitor the charging indicator on your charger. Charging times may vary.
Once fully charged, disconnect the charger from the power source and remove the battery.

Note: This battery features no memory effect, allowing you to charge it at any time without reducing its overall lifespan.

7. Operating Instructions

Once the battery is installed and charged, your camcorder is ready for use. Refer to your camcorder's instruction manual for specific operating procedures.

Ensure the battery is securely installed before powering on the camcorder.
Monitor the battery level indicator on your camcorder's display during use.
For optimal performance, avoid completely draining the battery frequently, although it has no memory effect.

8. Maintenance and Storage

Cleaning: Use a dry, soft cloth to clean the battery terminals if they become dirty. Do not use liquids or abrasive cleaners.
Storage: If storing the battery for an extended period, charge it to approximately 50% capacity. Store in a cool, dry place away from direct sunlight and extreme temperatures.
Disposal: Dispose of used batteries responsibly according to local regulations. Do not incinerate or puncture batteries.

Figure 2: Back view of the Surpassed NP-FH50 Li-ion Battery Pack, showing the "Li-ion Battery H" label. This image provides a view of the battery's rear casing.

9. Troubleshooting

Problem	Possible Cause	Solution
Battery not charging.	Incorrectly inserted into charger. Charger not connected to power. Charger or battery fault.	Re-insert battery correctly. Check power connection. Try a different charger or contact support.
Camcorder not powering on with battery.	Battery not fully charged. Battery not correctly installed. Battery or camcorder fault.	Charge the battery fully. Re-install the battery securely. Test with another battery if available, or contact support.
Short operating time.	Battery not fully charged. Battery nearing end of lifespan. High power consumption settings on camcorder.	Ensure full charge before use. Consider replacing the battery. Adjust camcorder settings (e.g., screen brightness).

10. Specifications

Model:	NP-FH50
Battery Type:	Li-ion (Lithium-ion)
Voltage:	7.4V
Capacity:	1080mAh
Compatible with:	Sony NP-FH50 series, Sony DCR-SR40, DCR-SR42, DCR-SR45
Condition:	New

Figure 3: Angled view of the Surpassed NP-FH50 Li-ion Battery Pack, highlighting its form factor and connector. This image provides a perspective of the battery's overall design.

11. Safety Information

WARNING: To prevent fire, explosion, or injury, observe the following precautions:

DO NOT incinerate the battery.
DO NOT expose the battery to high temperatures (above 140°F / 60°C).
DO NOT disassemble the battery.
DO NOT short-circuit the battery terminals.
Keep the battery away from water and moisture.
Keep out of reach of children.
If the battery leaks, swells, or emits an unusual odor, discontinue use immediately.

Another angled view of the Surpassed NP-FH50 Li-ion Battery Pack

Figure 4: A different angled view of the Surpassed NP-FH50 Li-ion Battery Pack, providing additional visual detail of its casing and design elements.

12. Warranty and Support

This Surpassed NP-FH50 Li-ion Battery Pack comes with a 1-year warranty from the date of purchase.

For any questions, concerns, or technical support, please contact our customer service. We are committed to providing quality power products and excellent customer service.

Please refer to your purchase documentation for specific contact details.