HAFELE NAGOLD EVO 60

HAFELE NAGOLD Steel EVO 60 Chimney Hood

Model: EVO 60 | Brand: HAFELE NAGOLD

1. Introduction

Welcome to the user manual for your new HAFELE NAGOLD Steel EVO 60 Chimney Hood. This manual provides essential information for the safe and efficient installation, operation, and maintenance of your appliance. Designed with a full stainless steel body, this chimney hood features 3 speed controls and a powerful 190 W motor to ensure effective ventilation in your kitchen.

Please read this manual thoroughly before using the appliance and keep it for future reference.

2. Safety Information

Always adhere to the following safety precautions to prevent injury or damage to the appliance:

  • Electrical Safety: Ensure the power supply matches the rating plate. Do not use extension cords. Disconnect power before cleaning or maintenance.
  • Installation: Installation must be performed by a qualified technician in accordance with local regulations. Ensure proper ventilation and ducting.
  • Fire Hazard: Do not flambé under the range hood. Clean grease filters regularly to prevent grease accumulation, which can be a fire hazard.
  • Children and Vulnerable Persons: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
  • Maintenance: Only use original spare parts. Do not modify the appliance.

3. Package Contents

Upon unpacking, please verify that all components are present and undamaged:

  • 1 x Hafele Nagold Evo 60 Chimney Hood 60 Cm
  • Installation Kit (screws, brackets, etc. - specific items may vary, refer to packaging)
  • User Manual

If any items are missing or damaged, please contact your retailer immediately.

4. Setup and Installation

The HAFELE NAGOLD Steel EVO 60 Chimney Hood is designed for island mount installation with ducted/vented operation. Professional installation is highly recommended to ensure proper functioning and safety.

HAFELE NAGOLD Steel EVO 60 Chimney Hood

An image showing the HAFELE NAGOLD Steel EVO 60 Chimney Hood, a stainless steel island mount range hood with a rectangular base and a chimney extending upwards. The control buttons are visible on the front right side.

4.1. Pre-Installation Checks

  • Ensure adequate space above the cooking surface as per local building codes and manufacturer recommendations.
  • Verify the electrical supply is compatible and a dedicated circuit is available.
  • Plan the ducting route to the exterior, minimizing bends for optimal performance.

4.2. Installation Steps (Summary)

  1. Mounting: Securely attach the mounting bracket to the ceiling, ensuring it can support the weight of the hood.
  2. Ducting Connection: Connect the exhaust duct from the hood to the external ventilation system. Ensure all connections are sealed to prevent air leaks.
  3. Electrical Connection: Connect the hood to the electrical supply. This step must be performed by a qualified electrician.
  4. Final Assembly: Attach the chimney sections and any decorative panels.
  5. Test Operation: Power on the hood and test all functions (fan speeds, lights) to ensure correct operation.

Refer to the detailed installation diagram and instructions provided in the separate installation guide for precise measurements and steps.

5. Operating Instructions

Your HAFELE NAGOLD Steel EVO 60 Chimney Hood is equipped with user-friendly push-button controls for easy operation.

5.1. Control Panel

The control panel is located on the front right side of the hood and consists of several push buttons:

  • Power Button: Press to turn the hood ON or OFF.
  • Fan Speed Buttons (1, 2, 3): Press to select the desired fan speed.
    • Speed 1: Low suction, suitable for simmering or light cooking.
    • Speed 2: Medium suction, for general cooking.
    • Speed 3: High suction, for frying or strong odors.
  • Light Button: Press to turn the halogen lights ON or OFF.

5.2. Recommended Usage

  • Turn on the hood a few minutes before you start cooking to create an air flow.
  • Select the appropriate fan speed based on the intensity of cooking fumes.
  • Allow the hood to run for a few minutes after cooking to clear any remaining odors and steam.

6. Maintenance and Cleaning

Regular cleaning and maintenance will ensure the longevity and optimal performance of your chimney hood.

6.1. Cleaning the Stainless Steel Body

  • Always disconnect the power supply before cleaning.
  • Use a soft cloth dampened with warm water and a mild, non-abrasive detergent.
  • Wipe the stainless steel surfaces in the direction of the grain to avoid streaks.
  • Do not use abrasive cleaners, steel wool, or harsh chemicals, as these can damage the brushed finish.
  • Dry thoroughly with a clean, soft cloth.

6.2. Cleaning the Mesh Filters

The mesh filters trap grease and should be cleaned regularly (e.g., monthly, depending on usage) to maintain suction efficiency.

  1. Turn off and unplug the hood.
  2. Carefully remove the mesh filters by releasing their latches.
  3. Wash the filters in hot soapy water or in a dishwasher (if dishwasher-safe, check product specifications).
  4. Rinse thoroughly and allow them to dry completely before re-installing.

6.3. Replacing Halogen Lights

If a halogen light bulb needs replacement:

  • Ensure the hood is turned off and cool to the touch.
  • Carefully remove the old bulb.
  • Replace with a new bulb of the same type and wattage (refer to specifications).

7. Troubleshooting

Before contacting customer service, please refer to the following common issues and solutions:

ProblemPossible CauseSolution
Hood does not turn on.No power supply.
Faulty switch.
Check power cord connection and circuit breaker.
Contact a qualified technician.
Poor suction.Clogged grease filters.
Improper ducting.
Fan motor issue.
Clean or replace filters.
Check ducting for blockages or leaks.
Contact a qualified technician.
Excessive noise.Loose components.
Obstruction in fan.
Motor issue.
Check for loose screws or parts.
Inspect fan for foreign objects (ensure power is off).
Contact a qualified technician.
Lights not working.Bulb burnt out.
Electrical connection issue.
Replace bulb.
Contact a qualified technician.

If the problem persists after attempting these solutions, please contact HAFELE NAGOLD customer support or a certified service technician.

8. Specifications

FeatureDetail
BrandHAFELE NAGOLD
Model NumberEVO 60
Mounting TypeIsland Mount
Ventilation TypeDucted/Vented
Controls TypePush Button
Number of Speeds3
Noise Level62 dB
Light Source TypeHalogen
Filter TypeMesh
MaterialStainless Steel
Finish TypeBrushed
ColourSilver
Item Weight7 kg 460 g
Included ComponentsHafele Nagold Evo 60 Chimney Hood 60 Cm

9. Warranty and Support

For information regarding the product warranty, please refer to the warranty card included with your purchase or visit the official HAFELE NAGOLD website. Keep your purchase receipt as proof of purchase for warranty claims.

For technical support, spare parts, or service inquiries, please contact HAFELE NAGOLD customer service through their official channels. You may need to provide your product model number (EVO 60) and serial number (if applicable).

Official Website: www.hafele.in (Example link, actual link may vary)

© 2024 HAFELE NAGOLD. All rights reserved.

This manual is subject to change without notice.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.