ZURURU Replacement Bands for Veryfitpro ID130Plus HR and Y39 Fitness Trackers

Introduction

This manual provides essential instructions for the installation, use, and maintenance of your ZURURU replacement bands, designed for compatibility with Veryfitpro ID130Plus HR and Y39 fitness trackers. Please read this manual thoroughly to ensure proper usage and longevity of your product.

Compatibility

These replacement bands are specifically designed for the following fitness tracker models:

• Veryfitpro ID130Plus HR
• Veryfitpro Y39
• Lintelek ID130Plus HR
• Letsfit ID130Plus HR
• Livikey ID130Plus HR
• Kalinco ID130Plus HR

To verify your fitness tracker model, please refer to the instructions below:

Figure 1: Checking your fitness tracker model in the Veryfitpro app. Open the app, then tap 'Device' to view the model name (e.g., ID130Plus HR).

Using these bands with incompatible models may result in an improper fit or damage.

Package Contents

Each package typically includes:

• Two (2) ZURURU Replacement Bands (e.g., Black)

Figure 2: Typical package contents showing two black replacement bands.

Setup and Installation

Follow these steps to replace the bands on your fitness tracker:

1. Remove the Old Strap: Gently pull the existing bands off the fitness tracker body. Apply slight pressure in the direction indicated by the arrow if present on your original band.


Figure 3: Detaching the old band from the fitness tracker module.

2. Insert the New Strap: Align the new replacement band with the tracker body and push it in firmly until it clicks securely into place. Ensure both ends of the band are fully inserted and fixed.
3. Verify Security: Gently tug on the installed bands to confirm they are securely attached and do not detach easily.

For a visual guide on band replacement, please watch the following video:

Operating and Use

Once the replacement bands are securely attached, you can wear your fitness tracker as usual. Ensure the band fits comfortably on your wrist, neither too tight nor too loose, to allow for accurate sensor readings (e.g., heart rate, blood pressure) and comfortable wear throughout the day.

Figure 4: The adjustable strap accommodates wrist sizes from 5.4 inches (137mm) to 7.6 inches (193mm).

The stainless steel buckle and band holder are designed to keep your wristband securely fastened during daily activities and exercise.

Maintenance

To ensure the longevity and hygiene of your ZURURU replacement bands, follow these maintenance guidelines:

• Cleaning: Regularly clean the bands with a soft, damp cloth. For deeper cleaning, use mild soap and water, then rinse thoroughly and dry completely before reattaching to your tracker.
• Avoid Harsh Chemicals: Do not expose the bands to harsh chemicals, solvents, or abrasive cleaners, as these can damage the material.
• Storage: When not in use, store the bands in a cool, dry place away from direct sunlight to prevent material degradation.
• Inspect Regularly: Periodically check the bands for any signs of wear, tear, or damage. Replace them if any significant damage is observed to prevent loss of your fitness tracker.

Troubleshooting

• Band does not fit: Ensure your fitness tracker model is compatible with these replacement bands (refer to the Compatibility section). Double-check that the bands are inserted correctly and fully clicked into place.
• Band feels uncomfortable: Adjust the strap to a comfortable fit on your wrist. The bands are designed to fit wrist sizes between 5.4 and 7.6 inches.
• Band detaches easily: Make sure both ends of the band are securely fastened to the tracker module. If the issue persists, inspect the connection points on both the band and the tracker for any damage.

Specifications

Warranty and Support

For any issues or inquiries regarding your ZURURU replacement bands, please contact customer support. The manufacturer provides support for product-related concerns.

If you encounter any problems, please email the seller directly with your order number for assistance.