JSP TINFOIL-COTE Separating Liquid (Model de114) 8 ozs Instruction Manual

1. Introduction

JSP TINFOIL-COTE is an 8-ounce dental lab separating liquid designed for the clean and efficient separation of dental acrylics from plaster and gypsums. This product is formulated for professional use in prosthetic, orthodontic, and crown & bridge laboratories, ensuring accurate fit and performance without leaving oily residues or taking up space.

This image displays the JSP TINFOIL-COTE Separating Liquid in an 8-ounce bottle. The liquid is pink, and the bottle features a yellow label with product branding, usage directions, and safety warnings.

2. Safety Information

DANGER - POISON

WARNING!! KEEP OUT OF REACH OF CHILDREN

Always refer to the back label of the product for comprehensive safety warnings and handling instructions. Use in a well-ventilated area. Avoid contact with skin and eyes. In case of contact, rinse immediately with plenty of water and seek medical advice.

3. Preparation

Before applying JSP TINFOIL-COTE, ensure the model is thoroughly prepared. This typically involves boiling out any wax from the model to ensure a clean surface for application.

4. Operating Instructions

Follow these steps for optimal application and performance:

1. Application: After thoroughly boiling out wax, apply JSP TINFOIL-COTE to the model. This can be done using a brush or by pouring the liquid over the model. Ensure all areas requiring separation are completely covered.
2. Test Packing: If performing a test pack, use cellophane or plastic sheets after the test packing procedure.
3. Coating: Paint a heavy, even coat of JSP TINFOIL-COTE onto the model.
4. Drying Time: Allow approximately 60 seconds for the coat to dry before closing the flask. The liquid dries quickly.
5. Excess Removal: Any excess separating liquid will squeeze out during the flask closing process.
6. Adherence: The dried film will not adhere to teeth or metal, ensuring a clean separation.
7. Thinning: If necessary, the liquid may be thinned by adding water.

5. Maintenance and Cleanup

JSP TINFOIL-COTE is designed for easy cleanup. It rinses cleanly with water from teeth, metal, and base materials while remaining on the stone. The product leaves no oily residue, contributing to a clean working environment and accurate results.

6. Troubleshooting

• Liquid too thick: If the JSP TINFOIL-COTE appears too viscous for application, it can be thinned by adding a small amount of water.
• Poor separation: Ensure all areas of the model are thoroughly covered with a heavy, even coat. Verify that the wax has been completely boiled out prior to application.

7. Product Specifications

8. Warranty Information

Specific warranty details for JSP TINFOIL-COTE Separating Liquid are not provided in this manual. For information regarding product warranty, please contact JSP customer support directly using the contact information provided in the Support section.

9. Customer Support

For further assistance, technical support, or inquiries regarding JSP TINFOIL-COTE Separating Liquid, please visit the official JSP website:

www.jsp.cc