1. Introduction
This manual provides essential information for the safe and efficient installation, operation, and maintenance of your Vortice Punto Evo ME 100 LL ES fan. Please read these instructions carefully before using the product and retain them for future reference.
2. Safety Instructions
Always adhere to the following safety guidelines to prevent injury or damage to the product:
- Ensure the power supply is disconnected before installation, maintenance, or cleaning.
- Installation must be performed by a qualified electrician in accordance with local wiring regulations.
- Do not operate the fan with a damaged power cord or plug.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- The fan is rated IP45, providing protection against water jets. However, avoid direct high-pressure water spray.
- Ensure adequate ventilation in the room where the fan is installed to prevent backflow of gases from open-flame appliances.
- Do not insert objects into the fan grille.
3. Product Overview
The Vortice Punto Evo ME 100 LL ES is an energy-efficient extractor fan designed for small rooms. It features a quiet, reliable motor and is constructed from UV-resistant ABS plastic for durability.
Key Features:
- IP45 Protection: Resistant to water jets, suitable for damp environments.
- Quiet Operation: Engineered for minimal noise output.
- Energy Efficient: Low power consumption motor.
- Two Speed Settings: Adjustable airflow for varying needs.
- UV-Resistant ABS Plastic: Durable material that resists discoloration over time.
Components:
Refer to the exploded diagram below for an illustration of the fan's main components.
4. Installation
The Vortice Punto Evo ME 100 LL ES fan is designed for various mounting applications, including wall or ceiling installation. Ensure the chosen location allows for proper air extraction and access for maintenance.
Installation Steps (General Guidance):
- Preparation: Disconnect power. Mark the mounting points and the opening for the duct on the wall or ceiling.
- Ducting: Create the necessary opening for the 100mm diameter duct.
- Mounting: Secure the fan body to the wall or ceiling using appropriate fasteners. The rear view of the fan shows the exhaust duct and mounting points.
- Electrical Connection: Connect the electrical wiring according to the wiring diagram provided with the product and local electrical codes. Ensure proper grounding.
- Final Assembly: Attach the front grille and any other covers.
- Testing: Restore power and test the fan's operation.
An example of a typical bathroom installation is shown below:
5. Operating Instructions
The Vortice Punto Evo ME 100 LL ES fan is designed for continuous or intermittent operation to extract stale air from rooms. It features two speed settings.
Turning On/Off:
The fan is typically connected to a light switch or a separate switch. Activate the switch to turn the fan on. Deactivate the switch to turn it off.
Speed Selection:
If your model includes a speed selector switch (either integrated or external), choose between the two available speeds to adjust the airflow rate according to your ventilation needs.
Airflow Direction:
This fan is an extractor fan, meaning it pulls air from the room and expels it outwards. The diagram below illustrates the typical airflow pattern.
6. Maintenance
Regular cleaning and maintenance will ensure optimal performance and longevity of your fan. Always disconnect the power supply before performing any maintenance.
Cleaning the Fan:
- Disconnect Power: Turn off the power supply to the fan at the main circuit breaker.
- Remove Grille: Carefully unclip or unscrew the front grille.
- Clean Grille and Housing: Wash the grille and the exterior housing with a soft cloth dampened with mild soap and water. The UV-resistant ABS plastic is easy to clean.
- Clean Impeller: Gently wipe the fan blades (impeller) with a dry or slightly damp cloth to remove dust and debris. Avoid bending the blades.
- Reassemble: Ensure all parts are dry before reattaching the grille.
- Restore Power: Turn the power supply back on.
Do not use abrasive cleaners, solvents, or harsh chemicals, as these can damage the plastic surfaces.
7. Troubleshooting
If you encounter issues with your fan, refer to the following common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Fan does not turn on | No power supply Faulty wiring Motor failure | Check circuit breaker and wall switch Verify wiring connections (consult electrician) Contact customer support |
| Reduced airflow | Blocked grille or duct Dirty impeller | Clean grille and check duct for obstructions Clean the impeller blades (refer to Maintenance section) |
| Excessive noise | Loose mounting Debris in impeller Motor issue | Ensure fan is securely mounted Clean impeller and check for foreign objects Contact customer support |
If the problem persists after attempting these solutions, please contact Vortice customer support.
8. Specifications
| Specification | Value |
|---|---|
| Model Number | ME 100 LL ES |
| Manufacturer | Vortice |
| Product Dimensions (D x W x H) | 11.1 x 15.9 x 15.9 cm |
| Material | Plastic (UV-resistant ABS) |
| Color | White |
| Power Source | Corded Electric |
| Voltage | 230 Volts |
| Wattage | 4 W |
| Airflow Capacity | 95 Cubic Meters per Hour |
| Special Features | Waterproof, Water-resistant (IP45) |
| Mounting Type | Floor Mounting (suitable for wall/ceiling) |
| Electric Fan Design | Exhaust Fan |
| Recommended Uses | Ventilation |
| Room Type | All Rooms |
| Batteries Required? | No |
9. Warranty and Support
For information regarding the product warranty, please refer to the documentation provided at the time of purchase or visit the official Vortice website. If you require technical assistance, spare parts, or have any questions not covered in this manual, please contact Vortice customer support directly.
Vortice Contact Information: Please refer to your product packaging or the official Vortice website for the most up-to-date contact details in your region.
