Introduction
This manual provides instructions for the Bandai Complete Selection Modification (CSM) V Buckle and Dragvisor set, designed for adult collectors. This set allows users to recreate the transformation and combat sequences from the 2002-2003 television series Kamen Rider Ryuki. The set includes the V Buckle transformation belt, the Dragvisor summoning device, and a comprehensive collection of Advent Cards and Card Decks.
Components
The Bandai CSM V Buckle & Dragvisor set includes the following main components:
- V Buckle: The primary transformation belt.
- Dragvisor: The summoning and card reading device.
- Card Decks: 17 unique Card Decks for various Kamen Riders.
- Advent Cards: 89 individual Advent Cards for use with the Dragvisor.

Figure 1: The V Buckle transformation belt. This belt is central to the Kamen Rider Ryuki transformation sequence.

Figure 2: The Dragvisor device. This handheld unit is used to summon Contract Monsters and activate Advent Cards.

Figure 3: A selection of the 17 included Card Decks. Each deck represents a different Kamen Rider.

Figure 4: A fan of the 89 Advent Cards. These cards are inserted into the Dragvisor to activate various abilities.
Setup
1. Battery Installation
The V Buckle and Dragvisor require 6 AAA batteries (not included) for operation. Follow these steps for battery installation:
- Locate the battery compartments on both the V Buckle and the Dragvisor.
- Using a small Phillips head screwdriver, carefully open the battery compartment covers.
- Insert the AAA batteries, ensuring correct polarity (+/-) as indicated inside the compartment.
- Replace the battery compartment covers and secure them with the screws.
Caution: Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. Always remove exhausted batteries promptly.
2. Preparing the V Buckle
The V Buckle is designed for adult waist sizes. If the belt is too tight, third-party extenders may be available (not included with this product). To wear the V Buckle, adjust the strap to fit comfortably around your waist and secure the buckle.
3. Preparing Card Decks and Advent Cards
Organize your desired Card Deck and Advent Cards. Each Card Deck is designed to be inserted into the V Buckle, and individual Advent Cards are used with the Dragvisor.
Operating Instructions
1. Activating the V Buckle
- Ensure batteries are installed.
- Select a Card Deck (e.g., Ryuki, Knight, etc.).
- Insert the chosen Card Deck into the slot on the V Buckle. The V Buckle will emit a sound effect indicating activation.
2. Using the Dragvisor and Advent Cards
The Dragvisor interacts with Advent Cards via embedded NFC chips to produce specific sounds and phrases.
- Hold the Dragvisor firmly.
- Open the card slot on the Dragvisor.
- Insert an Advent Card into the slot. The Dragvisor will detect the card's NFC chip and play the corresponding sound effect (e.g., "SWORD VENT," "STRIKE VENT," "GUARD VENT," "FINAL VENT").
- Remove the card to prepare for the next action.
3. Exploring Different Card Decks
The set includes Card Decks for 13 Riders, including Ryuki, Knight, Scissors, Zolda, Raia, Gai, Ouja, Tiger, Imperer, Verde, Femme, Ryuga, and Odin. Additionally, special decks like Ryuki (Survive Form), Knight (Survive Form), Ryuki (Blank Form), and Abyss are included. Each deck and its associated Advent Cards unlock unique sounds and interactions, allowing for varied play scenarios.
Maintenance
Cleaning
To clean the V Buckle and Dragvisor, wipe surfaces with a soft, dry cloth. For stubborn dirt, a slightly damp cloth can be used, followed by immediate drying. Do not use abrasive cleaners, solvents, or immerse the product in water.
Battery Care
When the product is not in use for extended periods, remove the batteries to prevent leakage and potential damage. Dispose of used batteries according to local regulations.
Storage
Store the product in a cool, dry place away from direct sunlight and extreme temperatures to preserve its condition and electronic components.
Troubleshooting
- No Sound/Power:
Ensure fresh AAA batteries are correctly installed in both the V Buckle and Dragvisor. Check for correct polarity. If issues persist, try a new set of batteries.
- Advent Cards Not Detected:
Ensure the Advent Card is fully and correctly inserted into the Dragvisor's card slot. The NFC chip must make proper contact. Avoid bending or damaging the cards.
- V Buckle Not Activating:
Verify that a Card Deck is fully inserted into the V Buckle's slot. Check battery status.
- Belt Fit Issues:
The V Buckle is designed for adult sizes. If the belt is too small, consider purchasing a compatible third-party belt extender (not included).
Specifications
| Brand: | Bandai |
| Model Name: | V Buckle & Dragvisor |
| Model Number: | 4549660298717 |
| Material: | Plastic |
| Power Source: | Battery |
| Battery Type: | 6 AAA Batteries (Not Included) |
| Item Weight: | 5290 Grams |
| Number of Pieces: | 1 (Set includes multiple components) |
| Age Range: | Adult Collector (Minimum Age 12 months for general toy safety, but product is for adult collectors) |
| Assembly Required: | No |
Safety Information
- This product is intended for adult collectors. While the manufacturer minimum age is 12 months, the complexity and collectible nature make it suitable for adults.
- Keep small components, such as Advent Cards, away from young children to prevent choking hazards.
- Always supervise children if they are allowed to interact with the product.
- Follow all battery safety guidelines as outlined in the Setup section.
- Do not attempt to modify or disassemble the electronic components beyond battery replacement.
Warranty and Support
Specific warranty details for this product may vary by region and retailer. Please retain your proof of purchase for any warranty claims.
For product support, inquiries, or to report defects, please contact Bandai customer service or the retailer from whom the product was purchased. Contact information can typically be found on the product packaging or the official Bandai website.