1. Important Safety Information
Please read all instructions before using the Cra-Z-Art My Look Super Spa Salon. Failure to follow these instructions may result in injury or damage to the product.
- Adult supervision is recommended during use.
- Do not immerse the entire unit in water. Only the foot basin is designed to hold water.
- Ensure the battery compartment is securely closed before adding water.
- Use only the recommended battery type (C batteries, not included). Do not mix old and new batteries, or different types of batteries.
- Remove batteries if the product will not be used for an extended period.
- Keep small parts away from young children to prevent choking hazards.
- If irritation occurs from any included cosmetic product, discontinue use immediately and consult a physician.
2. Package Contents
Verify that all items listed below are present in your package:
- 1 x Super Spa Salon Unit (with integrated massaging rollers and foot buffer)
- 2 x Nail Polishes (0.05 fl oz / 1.5 ml each)
- 1 x Pedi-Soak Packet (0.35 oz / 10 g) - Cotton Candy Scent
- 1 x Pair of Foam Pedicure Flip-Flops
- 1 x Set of Toe Separators
- Instruction Manual
Image: Cra-Z-Art My Look Super Spa Salon unit with nail polishes, foot soak, toe separators, and foam flip-flops.
3. Setup
3.1 Battery Installation
- Locate the battery compartment on the underside of the spa unit.
- Using a Phillips head screwdriver (not included), open the battery compartment cover.
- Insert the required C batteries (not included) according to the polarity markings (+/-) inside the compartment.
- Replace the battery compartment cover and secure it with the screw.
3.2 Initial Assembly
The spa unit typically comes pre-assembled. If any components like the water pump or waterfall pieces are separate, gently snap them into their designated positions as indicated in the product diagram. Ensure all parts are securely fitted before use.
4. Operating Instructions
4.1 Preparing the Spa
- Place the spa unit on a flat, stable surface.
- Fill the foot basin with warm water up to the indicated fill line. Do not overfill.
- Open the Pedi-Soak packet and sprinkle the contents into the water. Allow it to dissolve slightly.
4.2 Using the Spa
- Gently place your feet into the water.
- Locate the power button, usually on the side or back of the unit. Press it to activate the water circulation, massaging rollers, and magic rainbow light effects.
- Rest your feet on the massaging rollers for a gentle massage.
- Use the integrated foot buffer to gently exfoliate rough skin areas on your feet.
- Enjoy the soothing water and light effects.
- When finished, press the power button to turn off the spa.
- Carefully remove your feet from the spa and dry them thoroughly.
4.3 Nail Polish Application
- Place the toe separators between your toes to prevent smudging.
- Shake the nail polish bottle gently before opening.
- Apply a thin, even coat of nail polish to each toenail. Allow to dry completely before applying a second coat if desired.
- Once nails are dry, you can wear the foam pedicure flip-flops.
5. Maintenance and Care
- After each use, empty the water from the foot basin.
- Wipe the interior of the basin and all components with a soft, damp cloth and mild soap. Rinse thoroughly.
- Allow all parts to air dry completely before storing.
- Do not use abrasive cleaners or harsh chemicals, as these may damage the unit.
- Store the spa unit and accessories in a clean, dry place away from direct sunlight.
6. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Spa does not turn on. | Batteries are dead or incorrectly installed. | Check battery polarity. Replace with fresh C batteries. Ensure battery compartment is closed. |
| Water is not circulating or lights are dim. | Low battery power. Water level too low or too high. Obstruction in pump. | Replace batteries. Adjust water level to the fill line. Check for and remove any debris from the pump intake. |
| Nail polish is clumpy or difficult to apply. | Polish has dried out or separated. | Shake the bottle well. If still clumpy, the polish may need to be replaced. Store polish with cap tightly sealed. |
7. Specifications
- Product Dimensions: 5 x 14.7 x 11.8 inches
- Item Weight: 3.2 pounds
- Manufacturer Recommended Age: 8+ years (Note: Product data states 0-6 years, but packaging OCR indicates 8+. Following packaging for user manual context.)
- Power Source: C Batteries (not included)
- Manufacturer: Cra-Z-Art
8. Warranty and Support
For product support or inquiries regarding potential defects, please contact Cra-Z-Art customer service directly. Specific warranty details may vary and are typically provided with the product packaging or on the manufacturer's official website.
Please retain your purchase receipt for any warranty claims.