EVO Gimbals IMR 26500 Batteries

EVO Gimbals IMR 26500 Li-Ion Rechargeable Batteries Instruction Manual

Introduction

This manual provides essential information for the safe and effective use of your EVO Gimbals IMR 26500 Li-Ion Rechargeable Batteries. Please read these instructions thoroughly before first use and retain for future reference.

Product Overview

The EVO Gimbals IMR 26500 Li-Ion Rechargeable Batteries are designed to provide reliable power for compatible camera stabilizers. This package includes two high-capacity IMR 26500 Li-Ion batteries.

Package Contents:

  • 2 x IMR 26500 Li-Ion Rechargeable Batteries

Key Features:

  • Battery Type: IMR 26500 Li-Ion
  • Capacity: 3600mAh (each battery)
  • Max Current Draw: 10A
  • Rechargeable: Yes

Important Safety Information

Failure to follow these safety instructions may result in fire, personal injury, or damage to property. Keep this manual for future reference.

  • Do NOT use these batteries in e-cigarette or vaping devices.
  • Always use a charger specifically designed for Li-Ion batteries.
  • Do not expose batteries to extreme temperatures (hot or cold), direct sunlight, or fire.
  • Do not short-circuit the battery terminals.
  • Do not disassemble, puncture, or modify the batteries.
  • Keep batteries away from water and other liquids.
  • Store batteries in a cool, dry place, away from metallic objects.
  • If a battery shows signs of damage, swelling, or leakage, discontinue use immediately and dispose of it properly.
  • Keep out of reach of children and pets.

Setup and First Use

Charging the Batteries:

  1. Insert the IMR 26500 Li-Ion batteries into a compatible Li-Ion battery charger. Ensure correct polarity (+ and -).
  2. Connect the charger to a power source.
  3. Allow the batteries to charge fully before first use. Refer to your charger's manual for specific charging indicators and times.
  4. Once fully charged, disconnect the charger and remove the batteries.

Installing Batteries into a Device:

  1. Refer to your device's instruction manual for specific battery installation procedures.
  2. Ensure the device is powered off before installing or removing batteries.
  3. Insert the batteries into the device's battery compartment, paying close attention to the correct polarity markings (+ and -).
  4. Secure the battery compartment cover.

Operating Instructions

These batteries are designed to power compatible camera stabilizers and similar electronic devices. Once installed, operate your device according to its specific instructions.

  • Always ensure batteries are fully charged for optimal performance.
  • Monitor your device's battery indicator to know when recharging is necessary.
  • When not in use for extended periods, remove batteries from the device and store them properly.

Maintenance and Storage

  • Cleaning: Use a dry, soft cloth to clean the battery terminals if necessary. Do not use liquids or abrasive cleaners.
  • Storage: Store batteries in a cool, dry place (ideally between 20°C and 25°C or 68°F and 77°F) away from direct sunlight and extreme temperatures.
  • For long-term storage, it is recommended to store Li-Ion batteries at approximately 50% charge to prolong their lifespan.
  • Disposal: Do not dispose of batteries in household waste. Recycle them at an authorized battery recycling facility.

Troubleshooting

ProblemPossible CauseSolution
Battery not chargingIncorrect charger, poor contact, damaged battery.Ensure charger is compatible and connected properly. Check battery for damage. Try a different battery or charger.
Device not powering onBatteries not installed correctly, low charge, incompatible batteries.Verify correct polarity and full insertion. Charge batteries. Confirm device compatibility.
Short operating timeBatteries not fully charged, aging batteries, high power consumption.Ensure full charge. Consider replacing old batteries. Reduce device power usage if possible.

If problems persist, contact customer support.

Product Specifications

  • Model: IMR 26500 Batteries
  • Battery Type: Lithium Ion (Li-Ion)
  • Capacity: 3600 mAh (Milliamp Hours) per battery
  • Max Current Draw: 10A
  • Voltage: 3.7V (nominal)
  • Weight: Approximately 4.8 ounces (total for 2 batteries)
  • Dimensions (per battery): Refer to 26500 standard dimensions (approx. 26mm diameter, 50mm length)
  • Manufacturer: EVO Gimbals

Compatibility

These batteries are compatible with the following devices:

  • EVO Rage (Gen2) Gimbals
  • EVO Rage-S Gimbals
  • Zhiyun Crane Plus Camera Stabilizers
  • Zhiyun Crane V2 Camera Stabilizers

Always verify battery specifications and compatibility with your device's manufacturer before use.

Product Visuals

Two EVO Gimbals IMR 26500 Li-Ion rechargeable batteries, black with white branding and red polarity markings.

Image 1: Two EVO Gimbals IMR 26500 Li-Ion rechargeable batteries. Each battery is black with white "EVO GIMBALS" branding, "IMR 26500 Li-Ion Battery 3.7V/3600mAh (13.3Wh)" text, and clear red positive (+) and negative (-) polarity indicators on the top and bottom ends. The top also shows "Made in China" and CE/RoHS certifications.

Two EVO Gimbals IMR 26500 Li-Ion rechargeable batteries shrink-wrapped together.

Image 2: Two EVO Gimbals IMR 26500 Li-Ion rechargeable batteries, shrink-wrapped together as a pair. The batteries are black with white branding and red polarity markings, identical to Image 1, showing how they are typically packaged.

Warranty and Support

For warranty information or technical support, please contact EVO Gimbals customer service. Details can typically be found on the product packaging or the official EVO Gimbals website.

Website: EVO Gimbals Store on Amazon

© 2025 EVO Gimbals. All rights reserved.