1. Important Safety Information
Read all instructions carefully before using this kerosene heater. Failure to follow these instructions may result in fire, explosion, property damage, personal injury, or death.
- Outdoor Use Only: This heater is designed exclusively for outdoor use. Do not use indoors, in tents, or in any enclosed or poorly ventilated areas. Kerosene heaters produce carbon monoxide, which is odorless and deadly.
- Proper Fuel: Use only high-quality, clear kerosene (K-1 grade). Never use gasoline, benzene, alcohol, paint thinners, or any other flammable liquids. Using improper fuel can cause fire or explosion.
- Ventilation: Ensure adequate ventilation even when used outdoors.
- Stable Surface: Always place the heater on a firm, level, non-combustible surface.
- Clearance: Maintain a minimum clearance of 1 meter (3 feet) from all combustible materials (walls, furniture, clothing, etc.).
- Never Leave Unattended: Do not leave the operating heater unattended, especially around children or pets.
- Refueling: Always turn off the heater and allow it to cool completely before refueling. Refuel outdoors in a well-ventilated area.
- Storage: Store kerosene in a separate, approved container away from the heater and any heat sources. Store the heater in a cool, dry place when not in use.
- Hot Surfaces: The heater's surfaces become very hot during operation. Avoid contact to prevent burns.
2. Product Overview
The Perel 2600W Portable Kerosene Heater is designed for efficient outdoor heating. It features a 4.6-liter tank, providing up to 18 hours of burn time, and a practical handle for easy portability.
3. Setup
- Unpack: Carefully remove the heater from its packaging and inspect for any damage. Retain packaging for future storage.
- Placement: Place the heater on a stable, level, non-combustible surface outdoors, away from any flammable materials.
- Fueling:
- Ensure the heater is off and cool.
- Unscrew the fuel tank cap.
- Slowly pour clean K-1 kerosene into the tank, using a funnel to prevent spills. Do not overfill; leave some space for expansion. The tank capacity is 4.6 liters.
- Securely replace the fuel tank cap. Wipe up any spills immediately.
- Wick Preparation: After filling the tank, allow approximately 30 minutes for the wick to fully absorb the kerosene before lighting. This prevents damage to the wick.
4. Operating Instructions
- Raise the Wick: Turn the wick adjustment knob (usually labeled 'UP') clockwise to raise the wick until it is slightly above the top of the wick guide.
- Lighting: Using a long match or lighter, carefully light the top of the wick. Ensure the entire circumference of the wick is lit.
- Adjust Flame: After lighting, allow a few minutes for the flame to stabilize. Adjust the wick height using the knob to achieve a clean, blue flame without excessive smoke or yellow tips. A proper flame should be approximately 1-2 cm (0.4-0.8 inches) high.
- Extinguishing: To turn off the heater, turn the wick adjustment knob (usually labeled 'DOWN') counter-clockwise until the wick is fully retracted and the flame is extinguished. Ensure the flame is completely out before leaving the heater.
5. Maintenance
Regular maintenance ensures safe and efficient operation of your heater.
- Wick Replacement: The wick is a consumable part and will need replacement over time. Replace the wick when it becomes hard, charred, or no longer produces a clean flame. Refer to the manufacturer's instructions for specific wick replacement procedures. A replaceable wick is included with the heater.
- Cleaning:
- Ensure the heater is off and completely cool before cleaning.
- Wipe the exterior with a soft, damp cloth. Do not use abrasive cleaners or solvents.
- Periodically clean the burner area and any air vents to ensure proper airflow.
- Fuel Tank: Drain and clean the fuel tank at the end of each heating season or if the heater will be stored for an extended period. Use only clean kerosene for flushing.
6. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Heater won't light | No fuel, wick too low, wick hardened, improper fuel. | Check fuel level, raise wick, replace wick, use correct kerosene. |
| Low or weak flame | Wick too low, wick dirty/hardened, low fuel, poor ventilation. | Raise wick, clean/replace wick, refuel, ensure adequate ventilation. |
| Excessive smoke or odor | Wick too high, dirty wick, improper fuel, poor ventilation. | Lower wick, clean/replace wick, use correct kerosene, ensure adequate ventilation. |
| Flame goes out quickly | Low fuel, wick not fully saturated, wick mechanism issue. | Refuel, allow wick to saturate (30 min), inspect wick mechanism. |
7. Specifications
- Brand: Perel
- Model Number: 438866
- Part Number: TC84100N
- Manufacturer: Velleman Group nv
- Power Output: 2600W
- Fuel Type: Kerosene
- Fuel Tank Capacity: 4.6 Liters
- Burn Time: Up to 18 hours
- Fuel Consumption: Approximately 250 ml/hour
- Product Dimensions: 33 x 33 x 45 cm (D x W x H)
- Weight: 5.1 kg
- Color: Red
- Material: Metal
- Special Features: Portable
- Recommended Use: Outdoor, Garden, Camping
8. Warranty and Support
For warranty information, technical support, or to purchase replacement parts, please contact your retailer or the manufacturer, Velleman Group nv, directly. Keep your purchase receipt as proof of purchase.
