Eviva EVTB1011-60WH

Eviva Bella 60-Inch Freestanding Acrylic Bathtub User Manual

Model: EVTB1011-60WH

1. Introduction

This manual provides essential information for the safe and proper installation, operation, and maintenance of your Eviva Bella 60-Inch Freestanding Acrylic Bathtub. Please read all instructions carefully before installation and use. Retain this manual for future reference.

Eviva Bella 60-Inch Freestanding Acrylic Bathtub in a modern bathroom setting

Image 1.1: The Eviva Bella 60-Inch Freestanding Acrylic Bathtub installed in a contemporary bathroom.

2. Safety Information

Always observe the following safety precautions to reduce the risk of injury or property damage:

  • Ensure the floor structure can support the weight of the bathtub when filled with water and a person.
  • All plumbing and electrical connections (if applicable) must be performed by qualified professionals and comply with local codes.
  • Do not use abrasive cleaners or harsh chemicals on the acrylic surface, as this can cause damage.
  • Avoid placing heavy or sharp objects on the bathtub surface to prevent scratches or cracks.
  • Always test water temperature before entering the bathtub to prevent scalding.
  • Supervise children and individuals with limited mobility when using the bathtub.

3. Installation and Setup

The Eviva Bella bathtub is designed for straightforward installation. It is recommended that installation be performed by a professional plumber.

3.1 Pre-Installation Checklist

  • Verify all components are present and undamaged.
  • Ensure the installation area is clean, level, and has adequate drainage access.
  • Confirm floor support is sufficient for the bathtub's weight (approximately 90 lbs empty, plus water and user weight).

3.2 Positioning and Leveling

Position the freestanding bathtub in the desired location. The bathtub features an adjustable base for accurate leveling and stability. Adjust the feet as necessary to ensure the tub is perfectly level on all sides.

Diagram showing dimensions of Eviva Bella 60-Inch Bathtub: 60 inches length, 31.5 inches width, 26.8 inches height

Image 3.1: Dimensional overview of the Eviva Bella 60-Inch Bathtub.

3.3 Drain and Overflow Connection

The bathtub comes equipped with a middle drain and an overflow system. Connect the flexible drain hose to your floor drain according to local plumbing codes. The overflow is designed to prevent water from spilling over the tub's edge if it is overfilled.

Close-up of the bathtub's drain and overflow, highlighting low maintenance and non-porous features

Image 3.2: Detail of the chrome overflow and middle drain.

Note: A tub filler (faucet) is not included with this bathtub and must be purchased separately.

4. Operation

Using your Eviva Bella bathtub is simple and designed for a relaxing experience.

4.1 Filling the Bathtub

  1. Ensure the drain stopper is securely closed.
  2. Turn on your tub filler to the desired water temperature and flow rate.
  3. Fill the bathtub to a comfortable level, being mindful of the overflow to prevent spillage. The deep soaking design allows for a generous water depth.

4.2 Draining the Bathtub

After use, open the drain stopper to allow the water to empty. The middle drain facilitates efficient water removal.

Eviva Bella bathtub highlighting features like easy clean, durable, ergonomic, and non-slip

Image 4.1: The bathtub's ergonomic design and non-slip surface contribute to a comfortable and safe bathing experience.

5. Care and Maintenance

Proper care will ensure the longevity and pristine appearance of your Eviva Bella bathtub.

5.1 Cleaning the Bathtub

  • Clean the bathtub regularly with a soft cloth or sponge and a non-abrasive, mild liquid cleaner.
  • Rinse thoroughly with clean water after cleaning to remove all cleaner residue.
  • The high-grade acrylic and glossy finish are non-porous and stain-resistant, making cleaning easy.
  • Avoid using abrasive powders, steel wool, or harsh chemical cleaners (e.g., acetone, paint thinner, strong acids/bases) as these can damage the acrylic surface.
Top-down view of the Eviva Bella bathtub, emphasizing its glossy finish and high-grade acrylic material

Image 5.1: The glossy finish and high-grade acrylic ensure durability and ease of cleaning.

5.2 Preventing Damage

  • Do not drop heavy or sharp objects into the tub.
  • Avoid prolonged contact with rubber mats or suction cups, as they can cause discoloration over time.
  • For minor scratches, consult a professional or use an acrylic repair kit designed for bathtubs.

6. Troubleshooting

This section addresses common issues you might encounter with your bathtub.

ProblemPossible CauseSolution
Slow DrainageDrain stopper not fully open; partial clog in drain pipe.Ensure stopper is fully open. Clear any visible debris from the drain. If problem persists, a plumber may be needed to clear the pipe.
Water LeaksLoose drain connection; damaged drain seal.Check all drain connections for tightness. Inspect drain seals for damage and replace if necessary. Contact a professional plumber if the leak continues.
Surface ScratchesAbrasive cleaning; impact from sharp objects.Use only non-abrasive cleaners and soft cloths. For minor scratches, an acrylic repair kit can be used. For deep scratches, professional repair may be required.
Bathtub Not LevelUneven floor; adjustable feet not properly set.Adjust the leveling feet located at the base of the bathtub until it is stable and level.

7. Specifications

Key specifications for the Eviva Bella 60-Inch Freestanding Acrylic Bathtub:

FeatureDetail
Model NumberEVTB1011-60WH
Dimensions (L x W x H)60 x 31.5 x 26.8 inches (approx.)
MaterialAcrylic
ColorGlossy White
Installation TypeFreestanding
Capacity106 Gallons
Item Weight (Empty)90 Pounds
Drain LocationMiddle
OverflowIncluded, Chrome Finish
CertificationsUPC Certified
Image showing key specifications of the Eviva Bella bathtub including dimensions, material, finish, placement, and certifications

Image 7.1: Visual summary of the bathtub's specifications.

8. Warranty and Support

8.1 Manufacturer's Warranty

The Eviva Bella 60-Inch Freestanding Acrylic Bathtub is backed by a 1-year limited manufacturer's warranty. This warranty covers defects in materials and workmanship under normal use and service. Please retain your proof of purchase for warranty claims.

For detailed warranty terms and conditions, please refer to the documentation provided with your purchase or contact Eviva customer service.

8.2 Customer Support

If you have any questions regarding the installation, operation, maintenance, or warranty of your Eviva bathtub, please contact Eviva customer support. You can typically find contact information on the manufacturer's website or on your purchase receipt.

For further assistance, visit the official Eviva store: Eviva Store on Amazon.

© 2025 Eviva. All rights reserved. Information in this manual is subject to change without notice.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.