Jacob delafon ETB131-00

Jacob Delafon New Wave Toilet Cistern 2.6/4L Side Inlet White

Instruction Manual

1. Introduction

Thank you for choosing the Jacob Delafon New Wave Toilet Cistern. This manual provides essential information for the safe and efficient installation, operation, and maintenance of your cistern. Please read these instructions carefully before beginning installation or use, and retain them for future reference.

2. Safety Information

Always observe basic safety precautions when installing or servicing plumbing fixtures. Failure to follow these instructions could result in property damage or personal injury.

  • Ensure the water supply is turned off before starting any installation or maintenance work.
  • If you are unsure about any part of the installation process, consult a qualified plumber.
  • Wear appropriate personal protective equipment (PPE) such as gloves and eye protection.
  • Do not use abrasive cleaners or tools that could damage the cistern's surface.

3. Product Overview

The Jacob Delafon New Wave Cistern (Model ETB131-00) is designed for efficient water usage with a dual-flush mechanism (2.6/4 liters). It features a side water inlet for flexible installation.

Jacob Delafon New Wave Toilet Cistern, white, showing the side water inlet and top flush button.

Figure 1: Jacob Delafon New Wave Toilet Cistern. This image displays the white ceramic cistern with its lid and top-mounted flush button. A brass-colored water inlet connection is visible on the left side of the cistern. The cistern is designed to sit on a toilet bowl, which is partially visible below.

4. Setup and Installation

This section outlines the general steps for installing the cistern. Specific details may vary based on your existing toilet bowl and plumbing setup. It is recommended to consult a professional plumber for installation.

4.1. Before You Begin

  • Verify all components are present and undamaged.
  • Ensure the water supply valve is accessible and can be turned off.
  • Gather necessary tools: adjustable wrench, screwdriver, sealant, measuring tape.

4.2. Installation Steps

  1. Turn off Water Supply: Locate the main water shut-off valve for your toilet and turn it off. Flush the toilet to empty the existing tank.
  2. Remove Old Cistern (if applicable): Disconnect the water supply line and unbolt the old cistern from the toilet bowl.
  3. Prepare New Cistern: Install the flush valve and fill valve into the new cistern according to their individual instructions. Ensure all seals are correctly seated.
  4. Mount Cistern to Bowl: Place the cistern onto the toilet bowl, aligning the bolt holes. Secure it using the provided bolts, washers, and nuts. Tighten evenly to prevent cracking.
  5. Connect Water Supply: Attach the water supply line to the side inlet of the cistern. Hand-tighten, then use a wrench for a final quarter turn, being careful not to overtighten.
  6. Turn on Water Supply: Slowly turn the water supply back on and check for leaks around all connections.
  7. Adjust Water Level: Allow the cistern to fill. Adjust the fill valve to achieve the desired water level, typically marked inside the cistern.
  8. Install Lid and Flush Button: Place the cistern lid and install the flush button mechanism, ensuring it operates both the full and reduced flush.

5. Operating Instructions

The Jacob Delafon New Wave Cistern features a dual-flush system designed to conserve water.

  • Full Flush (4 Liters): Press and hold the larger part of the flush button for a complete flush. Use for solid waste.
  • Reduced Flush (2.6 Liters): Press and release the smaller part of the flush button for a water-saving flush. Use for liquid waste.

6. Maintenance

Regular maintenance ensures the longevity and optimal performance of your cistern.

6.1. Cleaning

  • Clean the exterior of the cistern with a soft cloth and mild, non-abrasive cleaner.
  • Avoid harsh chemicals, abrasive pads, or scouring powders, as these can damage the finish.
  • For internal cleaning, turn off the water supply, flush the cistern, and use a toilet bowl cleaner designed for internal tank use, following the product's instructions.

6.2. Internal Component Check

  • Periodically inspect the fill valve and flush valve for wear or mineral buildup.
  • Check the flapper or seal for proper seating and signs of deterioration. Replace if necessary.

7. Troubleshooting

Refer to the table below for common issues and their potential solutions.

ProblemPossible CauseSolution
Cistern constantly runs or refills slowly.Faulty fill valve, worn flapper/seal, incorrect water level adjustment.Check and adjust water level. Inspect flapper/seal for damage or debris; replace if necessary. Inspect fill valve for proper operation; clean or replace.
Weak or incomplete flush.Low water level, clogged siphon jet, flush valve obstruction.Ensure water level is at the correct mark. Clear any obstructions in the flush valve or siphon jet.
Leaks around the cistern base.Loose mounting bolts, damaged spud washer, cracked cistern.Tighten mounting bolts evenly. Inspect and replace the spud washer if damaged. If the cistern is cracked, it must be replaced.
Water leaks from the side inlet connection.Loose connection, damaged washer/seal on supply line.Ensure the water supply line connection is tight. Replace the washer or seal on the supply line if it is worn or damaged.

If you are unable to resolve an issue, please contact a qualified plumber or Jacob Delafon customer support.

8. Specifications

FeatureDetail
BrandJacob Delafon
Model NumberETB131-00
Product Dimensions (L x W x H)1 x 1 x 1 cm (Approximate, as per product data)
Item Weight10 Kilograms
Flush Volume2.6 / 4 Liters (Dual Flush)
Water Inlet PositionSide
ColorWhite

9. Warranty Information

Jacob Delafon products are manufactured to high-quality standards. For specific warranty terms and conditions, please refer to the warranty card included with your purchase or visit the official Jacob Delafon website. Keep your proof of purchase for warranty claims.

10. Customer Support

If you have any questions, require technical assistance, or need to order replacement parts, please contact Jacob Delafon customer support. Contact details can typically be found on the official Jacob Delafon website or on your product packaging.

Website: www.jacobdelafon.com (Please check for your regional website)

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.