Introduction
This manual provides essential information for the safe and effective installation, operation, and maintenance of the Origin Battery OR-1270HR (12V 7.0AH) Sealed Lead Acid (SLA) Battery Replacement Kit for the Bruno Electra-Ride Elite Stairlift (SRE-2000). Please read these instructions thoroughly before proceeding with installation or use.
Product Overview
The battery replacement kit includes two (2) OR-1270HR - 12V 7AH SLA batteries designed to meet or exceed the original equipment manufacturer (OEM) specifications for your Bruno Electra-Ride Elite Stairlift (SRE-2000). These batteries are maintenance-free, non-spillable, and fully charged prior to shipment, ensuring they are ready for immediate installation.
Key Features:
- Includes two (2) OR-1270HR - 12V 7AH SLA Batteries
- Maintenance-free, AGM, Non-spillable design
- Approved for transport by air (DOT, IATA, FAA, CAB certified)
Safety Information
Always prioritize safety when handling batteries. Failure to follow these guidelines may result in injury or damage.
- Wear Protective Gear: Always wear safety glasses and gloves when handling batteries.
- Avoid Short Circuits: Do not allow metal objects to contact both battery terminals simultaneously. This can cause sparks, fire, or explosion.
- Proper Ventilation: Ensure adequate ventilation during charging to prevent gas accumulation.
- Keep Away from Children: Store batteries out of reach of children.
- Do Not Disassemble: Never attempt to open or disassemble the battery.
- Recycle Properly: Dispose of old batteries according to local regulations. Refer to the recycling section for more details.
Installation Instructions
Before You Begin:
- Ensure the stairlift is turned off and disconnected from the main power supply.
- Consult your Bruno Electra-Ride Elite Stairlift (SRE-2000) owner's manual for specific battery compartment location and access procedures.
- Gather necessary tools, which may include a screwdriver, wrench, and terminal cleaning brush.
Battery Replacement Steps:
- Locate the battery compartment on your stairlift.
- Carefully disconnect the negative (-) terminal first, followed by the positive (+) terminal, from the old batteries.
- Remove the old batteries from the compartment.
- Clean the battery tray and terminals if necessary.
- Place the new Origin Battery OR-1270HR batteries into the compartment, ensuring correct orientation.
- Connect the positive (+) terminal first, then the negative (-) terminal, to the new batteries. Ensure connections are secure.
- Close the battery compartment securely.
- Reconnect the stairlift to the main power supply and turn it on.
Operation and Charging
The OR-1270HR batteries are designed for constant voltage charging. Upon installation, the stairlift's charging system will automatically begin to charge the batteries if needed.
Constant Voltage Charge Parameters:
- Standby Use: 13.5 - 13.8 Volts
- Cycle Use: 14.4 - 15.0 Volts
- Initial Current: Less than 2.1 Amperes
Ensure your stairlift's charging system is functioning correctly to maintain optimal battery performance and lifespan.
Maintenance and Storage
These batteries are maintenance-free, meaning they do not require water additions. However, proper care can extend their lifespan.
- Keep Clean: Periodically inspect battery terminals for corrosion and keep them clean and tight.
- Temperature: Store and operate batteries in a cool, dry environment. Extreme temperatures can affect performance and lifespan.
- Long-Term Storage: If the stairlift will be unused for an extended period, ensure the batteries are fully charged before storage and periodically recharged to prevent deep discharge.
Troubleshooting
If your stairlift is not functioning correctly after battery replacement, consider the following:
- No Power: Check all battery connections to ensure they are secure and correctly polarized (positive to positive, negative to negative).
- Stairlift Not Charging: Verify that the stairlift is properly connected to the main power supply and that the outlet is functional. Consult your stairlift's manual for charger troubleshooting.
- Reduced Performance: Ensure the batteries have had sufficient time to fully charge after installation.
- Incorrect Batteries: Double-check that the installed batteries are indeed the correct OR-1270HR model for your SRE-2000 stairlift.
If issues persist, contact Origin Battery customer support or a qualified stairlift technician.
Specifications
| Specification | Detail |
|---|---|
| Battery Model | OR-1270HR |
| Voltage | 12 Volts |
| Amperage | 7.0 Ampere-hours (AH) |
| Battery Cell Type | Sealed Lead Acid (SLA), AGM, Non-spillable |
| Length | 5.94 inches (15.09 cm) |
| Width | 2.56 inches (6.50 cm) |
| Height | 3.72 inches (9.45 cm) |
| Weight (per battery) | 5.39 lbs (2.44 kg) |
| Terminal Type | F2 |
| Reusability | Rechargeable |
| UPC | 095056226498 |
Warranty Information
The Origin Battery OR-1270HR battery replacement kit comes with a one-year warranty from the date of purchase. This warranty covers manufacturing defects. Please retain your proof of purchase for warranty claims. The warranty does not cover damage due to improper installation, misuse, or neglect.
Customer Support and Recycling
For technical assistance, warranty inquiries, or any questions regarding your Origin Battery product, please contact the manufacturer:
- Manufacturer: Origin Battery
Battery Recycling:
These batteries contain lead and must be recycled. Do not dispose of them in household waste. For recycling information, please call 1-855-522-2288 or visit a local battery recycling center.