USA Chair Replacement Webbing Instruction Manual

Product Overview

This kit provides UV-resistant polypropylene webbing for replacing or customizing the seating surface of aluminum lawn chairs. Designed for durability and comfort, it allows for restoration or redesign of existing chair frames.

The webbing is made to last for years, offering a slight stretch for comfort and resistance to UV and water exposure.

Safety Information

Important: When re-webbing chairs, ensure the finished product is stable and secure. This product is intended for adult use. If used on a chair for children, be aware of entrapment risks. The maximum weight recommendation for a re-webbed chair is 225 pounds. For chairs intended for children, the maximum weight recommendation is 75 pounds. Always inspect the chair frame for damage before re-webbing.

Installation Instructions

This section details the process of re-webbing your lawn chair using either clips or screws. For a visual guide, please refer to the official instruction video below.

Official Installation Video

Step-by-Step Guide

1. Step 1: Measure Your Chair

   Measure your chair horizontally from one hole to another. Remember to measure all the way around the tube. Repeat this step to measure the length of the straps going in the opposite direction (vertically).

   

   Description: A person is shown measuring the width of a chair frame using a tape measure, ensuring to wrap it around the tube for accurate length.

2. Step 2: Cut the Webbing

   Based on your measurements, cut the webbing. The amount to add to your "hole to hole" measurement depends on the fastening method:

   • If using CLIPS, add 4 inches to your measurement.
   • If using SCREWS and 3-inch webbing, add 4.5 inches to your measurement.
   • If using SCREWS and 2.25-inch webbing, add 3.5 inches to your measurement.
   

   Description: This image displays a roll of webbing, a pair of scissors, and a measuring tape, illustrating the process of cutting the webbing to the correct length based on the chosen fastening method (clips or screws).

3. Step 3: Insert the Clips (if using clips)

   With the webbing straps cut, insert the clips into the straps approximately two inches from each end. Ensure the bend in the clips curves toward the long strap for proper installation.

   

   Description: A close-up view demonstrates inserting a metal clip into the webbing, highlighting that the clip's bend should face towards the longer portion of the strap.

4. Step 4: Secure Webbing with Clips

   Insert the clips into the proper holes in the chair frame. Pay special attention to the direction of the clip. Pull the webbing to the other side of the chair. Weave the webbing if needed to create the desired pattern. Insert the second clip into the corresponding hole on the other side of the chair. Reposition the clip if necessary. Try to get the webbing as tight as possible for a firm seat.

   

   Description: This composite image illustrates four key steps for attaching webbing with clips: inserting the clip into the webbing, positioning the clip in the chair frame's hole, wrapping the webbing around the frame, and finally, securing the second clip into its hole.

5. Step 5: Use Screws (if using screws)

   If using screws, take one corner of your webbing and fold it to create a triangle. Repeat with the other side. Push a screw through the center of the triangle. Use a Phillips screwdriver to screw one side into the chair frame. Repeat on the other side. Reposition the screw if necessary. Try to get the webbing as tight as possible.

   

   Description: A person is demonstrating how to prepare the webbing for screw attachment by folding a corner into a triangle and then pushing a screw through the folded fabric.

Maintenance

To clean the webbing, use mild soap and water. Allow the webbing to air dry completely before use or storage. Avoid harsh chemicals or abrasive cleaners, as these may damage the material.

Troubleshooting

No specific troubleshooting steps are provided for this product. If you encounter issues during installation or with the product's performance, please refer to the installation video or contact Lawn Chair USA customer support for assistance.

Specifications

Support

For further assistance, questions, or support regarding your Lawn Chair USA Replacement Webbing, please visit the official Lawn Chair USA store on Amazon or contact their customer service directly.

Lawn Chair USA Store: Visit Store