Stilo 25W 4000K Dimmable LED Batten 60cm Instruction Manual

Introduction

This manual provides essential information for the safe installation, operation, and maintenance of your Stilo 25W 4000K Dimmable LED Batten. Please read these instructions carefully before installation and retain them for future reference.

Safety Instructions

• Ensure the power supply is disconnected before installation, maintenance, or cleaning.
• Installation should be performed by a qualified electrician in accordance with local wiring regulations.
• Do not modify the product in any way.
• This product is designed for indoor use only.
• Avoid direct eye exposure to the LED light source.
• Do not cover the fixture with insulating material.

Package Contents

• 1 x Stilo 25W 4000K Dimmable LED Batten
• Mounting hardware (screws, wall plugs)
• Instruction Manual

Specifications

Setup and Installation

Important: Ensure the main power supply is switched off at the circuit breaker before beginning installation.

Step 1: Unpack and Inspect

Carefully remove the LED batten from its packaging. Inspect for any damage. Do not install if the product is damaged.

Image: Front view of the Stilo LED Batten. This image shows the full length of the batten with its white casing and translucent diffuser.

Step 2: Mark Mounting Points

Determine the desired location for the batten. Use the mounting brackets (if separate) or the fixture itself as a template to mark the drilling points on the ceiling or wall.

Step 3: Drill Holes and Install Wall Plugs

Drill holes at the marked points using an appropriate drill bit for your wall/ceiling material. Insert the provided wall plugs into the drilled holes.

Step 4: Secure Mounting Brackets (if applicable)

If your batten uses separate mounting brackets, secure them to the wall/ceiling using the provided screws. Ensure they are firmly attached.

Step 5: Electrical Connection

Connect the electrical wires from your mains supply to the terminal block on the LED batten. Ensure correct polarity (Live, Neutral, Earth). Refer to the wiring diagram provided with the product (if any) or consult a qualified electrician.

Image: Close-up view of the end cap and translucent diffuser of the Stilo LED Batten. This shows the textured surface of the diffuser and the white plastic end piece.

Step 6: Mount the Batten

Carefully attach the LED batten to the secured mounting brackets or directly to the wall/ceiling using the provided screws. Ensure it is securely fastened and stable.

Image: The Stilo LED Batten installed on a ceiling in a modern office setting, illuminating a desk with a computer. This demonstrates the product's application.

Step 7: Restore Power

Once installation is complete and all connections are secure, restore power at the circuit breaker.

Operating Instructions

Switching On/Off

Operate the LED batten using a standard wall switch connected to its power supply.

Dimming Function

This LED batten is dimmable. To utilize the dimming feature, it must be connected to a compatible LED dimmer switch (not included). Follow the dimmer switch manufacturer's instructions for installation and operation.

Maintenance

• Cleaning: Disconnect power before cleaning. Wipe the fixture with a soft, dry, or slightly damp cloth. Do not use abrasive cleaners or solvents.
• LEDs: The LEDs in this fixture are not replaceable. Do not attempt to open the fixture to replace LEDs.

Troubleshooting

If problems persist, consult a qualified electrician or contact customer support.

Warranty and Support

This product comes with a standard manufacturer's warranty. Please refer to your purchase documentation for specific warranty terms and conditions. For technical support or warranty claims, please contact your retailer or the manufacturer directly.

For more information, visit [Manufacturer Website Link] or contact customer service at support@example.com.