Progressive Industries SSP-50XL Portable RV Smart Surge Protector 50 Amp Instruction Manual

1. Introduction and Overview

The Progressive Industries SSP-50XL Portable RV Smart Surge Protector is designed to safeguard your RV's electrical system and appliances from various power fluctuations and surges. This unit is rated for 50 Amp service and provides three-mode surge protection with 1,650 joules and a maximum spike rating of 45,000 amps. It actively detects common wiring issues such as open ground, open neutral, and reverse polarity, helping to prevent potential electrical hazards before they can cause damage to your valuable equipment.

Constructed for outdoor use, the SSP-50XL features a weather-resistant design, thermal protection, and an all-weather shield assembly, ensuring durability in diverse environmental conditions. Bright LED indicators offer clear status monitoring, and a robust pull handle facilitates easy handling. Its compact and portable design allows for simple plug-and-play installation, making it an essential component for maintaining safe and reliable power for your RV during travel and at campsites.

2. Key Features

• Smart Surge Protection: Protects RV appliances from voltage fluctuations and surges, ensuring reliable performance for 50 Amp systems.
• High Surge Rating: Rated for 50 Amp and 120-240 V with 12,000 W capacity; absorbs surges up to 1,650 joules to prevent appliance damage.
• Powerful Fault Detection: Guards against over and under voltage, open ground and neutral, reverse polarity, and surge failure. Includes AC frequency protection.
• Outdoor Ready Design: Features an all-weather shield assembly and thermal protection. Built with tough Lexan housing for durability in harsh conditions.
• LED Indicators: Provides clear status monitoring with bright LED lights, improving visibility in low light.
• Portable and Easy to Use: Designed for simple plug-and-play installation.

3. Setup Instructions

Follow these steps to properly set up your SSP-50XL Portable RV Smart Surge Protector:

1. Inspect the Power Pedestal: Before connecting the surge protector, visually inspect the campsite power pedestal for any obvious damage or loose connections.
2. Connect the Surge Protector: Plug the SSP-50XL directly into the 50 Amp receptacle on the campsite power pedestal. Ensure a firm and secure connection.
3. Observe LED Indicators: Once plugged in, the LED indicators on the SSP-50XL will illuminate to display the power status and detect any wiring faults. Refer to the 'Operating Instructions' section for a detailed explanation of the LED codes.
4. Connect Your RV: After confirming a safe power status via the LED indicators, plug your RV's 50 Amp power cord into the receptacle on the SSP-50XL. Ensure this connection is also firm and secure.
5. Secure the Connection (Optional): If your unit includes a locking bracket or cover, utilize it to further secure the connection and protect against environmental elements.

Figure 1: Front view of the SSP-50XL Portable RV Smart Surge Protector.

Figure 2: Close-up view of the SSP-50XL LED indicators.

4. Operating Instructions

The SSP-50XL provides visual feedback through its LED indicators to inform you of the power status and any detected faults. Understanding these indicators is crucial for safe operation.

LED Indicator Guide:

Always check the LED indicators after connecting the surge protector to the power pedestal and before connecting your RV. If any fault is indicated (e.g., Reverse Polarity, Open Neutral, Open Ground), do not connect your RV. Contact campsite management or a qualified electrician to resolve the wiring issue.

Figure 3: The SSP-50XL protecting an RV's electronics in an outdoor setting.

5. Maintenance

The SSP-50XL is designed for minimal maintenance. However, regular inspection and proper care will ensure its longevity and continued performance:

• Visual Inspection: Periodically inspect the unit for any signs of physical damage, such as cracks in the housing, frayed wires, or corrosion on the prongs.
• Cleanliness: Keep the unit clean from dirt, dust, and debris. Use a soft, dry cloth to wipe the exterior. Avoid using harsh chemicals or abrasive cleaners.
• Connection Points: Ensure the electrical prongs and receptacles are free from moisture and debris before each use to maintain good electrical contact.
• Storage: When not in use, store the surge protector in a cool, dry place, away from direct sunlight and extreme temperatures.

6. Troubleshooting

If you encounter issues with your SSP-50XL, refer to the following troubleshooting steps:

Common Issues and Solutions:

• No Lights or Power:
  • Ensure the surge protector is fully and securely plugged into the power pedestal.
  • Check the circuit breaker at the power pedestal. It may be tripped or off.
  • Verify that the power pedestal itself is active. Try plugging in a simple device like a phone charger to test the outlet.
• Fault Indication (e.g., Red LED On, Blue LED Off):
  • Refer to the 'LED Indicator Guide' in Section 4 to identify the specific fault (Reverse Polarity, Open Neutral, Open Ground).
  • Do not connect your RV if a fault is indicated.
  • Contact campsite management immediately to report the issue and request a different pedestal or repair.
• Surge Protection LED (Green) is Off:
  • If the green LED is off while other power indicators are normal, it suggests the surge protection component may have been compromised by a significant surge.
  • The unit may still pass power, but its surge protection capability is diminished or lost. It is recommended to replace the unit to ensure continued protection.
• Intermittent Power:
  • Check all connections for tightness, including the surge protector to the pedestal and the RV cord to the surge protector.
  • Inspect the power cord for any damage.
  • The power source at the pedestal might be unstable. Monitor the LED indicators for any flickering or changes.

If problems persist after following these steps, contact Progressive Industries customer support for further assistance.

7. Specifications

8. Warranty Information

The Progressive Industries SSP-50XL Portable RV Smart Surge Protector comes with a Lifetime Warranty. Please note that the weather shield component is excluded from this warranty. For specific terms and conditions, please refer to the official warranty documentation provided with your product or contact Progressive Industries directly.

9. Support

For technical assistance, troubleshooting beyond the scope of this manual, or warranty claims, please contact Progressive Industries customer support. You can typically find contact information on the manufacturer's website or in the packaging materials included with your product. When contacting support, please have your model number (SSP-50XL) and purchase information readily available.