Introduction
This instruction manual provides essential information for the proper installation, operation, and maintenance of your Autocop Car Central Locking System. Please read this manual thoroughly before attempting any installation or operation to ensure optimal performance and safety. This system is designed to provide convenient remote locking and unlocking for your vehicle.
Package Contents
Upon opening the package, verify that all components are present and undamaged. The standard package includes:
- 1 x Central Locking System Control Unit
- Remote Key Fobs (quantity may vary)
- Door Lock Actuators (typically 4 units)
- Siren
- Wiring Harness
- Mounting Hardware
Image: Overview of all components included in the Autocop Car Central Locking System package.
Setup and Installation
Installation of the Autocop Car Central Locking System requires technical expertise and familiarity with automotive electrical systems. It is highly recommended that installation be performed by a qualified professional to ensure correct wiring, proper functionality, and to avoid damage to your vehicle or the system.
Key Components:
Image: Central Control Unit. This unit processes signals from the remote and controls the locking mechanisms.
Image: Door Lock Actuators. These devices are installed within the car doors to mechanically operate the locking and unlocking.
Image: Siren. The siren provides audible alerts for locking/unlocking and alarm triggers.
General Installation Steps (Professional Guidance Recommended):
- Disconnect Battery: Always disconnect the vehicle's battery before beginning any electrical work.
- Mount Control Unit: Securely mount the central control unit in a dry, protected area within the vehicle, typically under the dashboard.
- Install Actuators: Install door lock actuators inside each door panel, connecting them to the existing manual lock rods. Ensure smooth operation without obstruction.
- Wire Actuators: Route actuator wires through door grommets and connect them to the main wiring harness.
- Install Siren: Mount the siren in the engine bay, away from heat and water, ensuring the sound is not muffled.
- Connect Power and Ground: Connect the main power wire to a constant 12V source and the ground wire to a solid chassis ground point.
- Integrate with Vehicle Wiring: Connect the system's wiring harness to the vehicle's electrical system for functions like ignition sensing, door trigger inputs, and indicator light outputs.
- Test System: Reconnect the battery and test all functions of the central locking system.
Operating Instructions
The Autocop Car Central Locking System is operated using the provided remote key fob.
Image: Remote Key Fob. This device controls the central locking and security functions.
Remote Key Fob Functions:
- Lock Button (🔒): Press once to lock all vehicle doors. The system will typically respond with a single siren chirp and/or indicator light flash.
- Unlock Button (🔓): Press once to unlock all vehicle doors. The system will typically respond with two siren chirps and/or indicator light flashes.
- Trunk Release Button (often depicted as an open trunk): Press and hold for approximately 3 seconds to open the vehicle's trunk (if connected and supported by the vehicle).
- Auxiliary/Panic Button (often depicted as a star or bell): This button may activate a panic alarm (press and hold) or control an auxiliary function depending on the system's configuration. Refer to your installer for specific functionality.
Automatic Functions: Some systems may include features such as automatic door locking when the ignition is turned on or automatic unlocking when the ignition is turned off. These functions are dependent on the installation and specific model features.
Maintenance
To ensure the longevity and reliable operation of your Autocop Car Central Locking System, follow these general maintenance guidelines:
- Remote Battery Replacement: If the remote's range decreases or it becomes unresponsive, replace the battery. Refer to the remote's casing for battery type (e.g., CR2032).
- Keep Components Dry: Ensure the control unit and remote key fobs are kept dry and away from excessive moisture.
- Regular Checks: Periodically test all locking and unlocking functions to ensure they are working correctly.
- Professional Inspection: If you notice any unusual behavior or hear strange noises from the locking mechanisms, have the system inspected by a professional.
Troubleshooting
If you encounter issues with your central locking system, refer to the following troubleshooting tips:
| Problem | Possible Cause | Solution |
|---|---|---|
| System unresponsive to remote | Dead remote battery, remote out of range, signal interference, system fuse blown. | Replace remote battery. Move closer to the vehicle. Check for strong radio interference. Inspect and replace system fuse if necessary (professional recommended). |
| Lock button unlocks, or unlock button locks | Incorrect wiring during installation (reversed polarity for lock/unlock signals). | This indicates a wiring error. Contact a professional installer to correct the wiring connections for the lock/unlock outputs. |
| Doors do not lock/unlock consistently | Loose wiring connection, faulty actuator, obstruction in door mechanism. | Check all wiring connections. Inspect door mechanisms for any physical obstructions. A faulty actuator may need replacement by a professional. |
| Automatic door unlock/lock not working | Feature not enabled, faulty ignition signal connection, system malfunction. | Verify if the feature was configured during installation. Check ignition signal wire connection. If issues persist, professional diagnosis is required. |
| Siren does not sound | Siren disconnected, faulty siren, wiring issue. | Check siren connections. Test siren functionality. Consult a professional for wiring inspection. |
If the problem persists after attempting these solutions, please contact a qualified automotive technician or Autocop customer support for assistance.
Specifications
- Brand: Autocop
- Model Number: GEN_Ubra_92
- Compatible Devices: Car
- Remote Control Included: Yes
- Box Contents: 1 Car Locking System (includes control unit, remotes, actuators, siren, wiring)
- Item Weight: Approximately 2.04 kg
Warranty Information
The Autocop Car Central Locking System comes with a 3-year warranty from the date of purchase. This warranty covers manufacturing defects under normal use. Please retain your proof of purchase for warranty claims. The warranty does not cover damage caused by improper installation, misuse, accidents, unauthorized repairs, or normal wear and tear.
For warranty service, please contact your retailer or Autocop customer support with your product details and proof of purchase.
Customer Support
For further assistance, technical support, or inquiries regarding your Autocop Car Central Locking System, please refer to the contact information provided by your retailer or visit the official Autocop website.
When contacting support, please have your product model number (GEN_Ubra_92) and purchase details readily available.