Peavey PV-1 Dual Receiver Rack Mount Kit Instruction Manual

Introduction

This instruction manual provides guidance for the proper installation and use of the Peavey Rack Mount Kit for PV-1 Dual Receivers. This kit is designed to securely mount two single half-rack Peavey PV-1 wireless microphone receivers into a standard EIA equipment rack, optimizing space and organization within your audio setup.

Package Contents

Please verify that all components listed below are present in your package:

• Two (2) L-shaped rack ears
• Two (2) flat connecting plates
• Necessary mounting screws (not explicitly shown but implied for assembly)

Setup and Installation

Follow these steps to properly install your Peavey PV-1 wireless microphone receivers into a standard EIA rack using this kit:

1. Prepare Receivers: Ensure both Peavey PV-1 wireless receivers are powered off and disconnected from any cables.
2. Attach Connecting Plates: Secure one flat connecting plate to the side of the first PV-1 receiver using the provided screws. Repeat this for the second PV-1 receiver, attaching the other flat connecting plate to its opposite side. These plates will join the two receivers together.
3. Join Receivers: Align the two PV-1 receivers side-by-side. Use the remaining screws to connect the two flat plates, effectively joining the two receivers into a single unit.
4. Attach Rack Ears: Secure one L-shaped rack ear to each outer side of the now-joined receiver unit. The longer flange of the L-bracket should face forward, with its holes aligning with the rack's mounting points.
5. Mount in Rack: Carefully slide the assembled unit into your standard EIA equipment rack. Secure the L-shaped rack ears to the rack rails using appropriate rack screws (typically not included with this kit, but standard for rack mounting).
6. Connect Cables: Once securely mounted, reconnect all necessary audio and power cables to your PV-1 receivers.

Ensure all screws are tightened securely to prevent movement or vibration during operation.

Operating Instructions

This rack mount kit is a passive accessory designed to house your Peavey PV-1 wireless receivers. It does not have any operational functions itself. Once the receivers are securely mounted, refer to the individual instruction manuals for your Peavey PV-1 wireless receivers for their specific operating procedures.

Maintenance

The rack mount kit requires minimal maintenance. Periodically inspect all mounting screws to ensure they remain tight. Clean the metal surfaces with a soft, dry cloth as needed to remove dust. Avoid using abrasive cleaners or solvents, as these may damage the finish.

Troubleshooting

• Receivers not fitting: Ensure you are attempting to mount two single half-rack Peavey PV-1 wireless receivers. This kit is specifically designed for these models.
• Loose in rack: Verify that all screws connecting the rack ears to the receivers and the rack ears to the equipment rack are securely tightened.
• Missing parts: Refer to the "Package Contents" section. If any parts are missing, contact Peavey customer support.

Specifications

Warranty Information

Specific warranty details for this product are typically provided with the original purchase documentation or can be found on the official Peavey website. Please retain your proof of purchase for any warranty claims. For detailed information regarding warranty coverage, terms, and conditions, please visit the official Peavey support page or contact their customer service directly.

Support

For technical assistance, missing parts, or further inquiries regarding your Peavey Rack Mount Kit, please contact Peavey customer support. You can often find contact information and additional resources on the official Peavey website.

You may also visit the Peavey Store on Amazon for more product information.