Introduction
This manual provides essential information for the safe and efficient operation, setup, and maintenance of your Alpine Corporation 40" Tall Outdoor Floor Tiered Rustic Pump and Barrel Water Fountain (Model: TEC234BR). Please read all instructions carefully before assembly and use to ensure proper function and longevity of your product.
Safety Information
- Always disconnect the fountain from the power outlet before performing any maintenance or cleaning.
- Ensure the power cord is placed to avoid tripping hazards and is protected from damage.
- Do not operate the fountain if the pump or power cord is damaged. Contact customer support for assistance.
- Keep children and pets away from the fountain during operation to prevent accidents.
- Do not allow the pump to run dry, as this can cause damage. Always ensure the water level is adequate.
- Position the fountain on a stable, level surface to prevent tipping.
- Use only with a properly grounded outdoor electrical outlet.
Package Contents
Verify that all components are present and undamaged before proceeding with assembly:
- Fountain Unit (Tiered barrels and pump structure)
- Electric Water Pump
- Power Cord
- Instruction Manual (This document)
Setup Instructions
- Unpack Components: Carefully remove all parts from the packaging and lay them out on a clean, flat surface.
- Choose Location: Select a level outdoor location for your fountain, ensuring it is within reach of a suitable outdoor electrical outlet.
- Assemble Pump: Place the electric water pump inside the lowest basin of the fountain. Connect the pump's tubing to the water inlet on the fountain's upper structure. Ensure a secure connection.
- Fill with Water: Fill the lowest basin of the fountain with distilled water until the pump is fully submerged. Do not overfill.
- Connect Power: Route the power cord safely to the outdoor electrical outlet. Do not plug it in yet.
Operating Instructions
- Initial Start-up: After completing the setup, plug the power cord into a grounded outdoor electrical outlet. The pump will begin to circulate water, creating a tiered waterfall effect.
- Water Level: Regularly check the water level in the lowest basin. Due to evaporation, water levels will decrease over time. Refill with distilled water as needed to ensure the pump remains fully submerged.
- Adjust Flow (if applicable): Some pumps may have an adjustable flow rate. Refer to the pump's specific instructions if you wish to modify the water flow.
- Shut Down: To turn off the fountain, simply unplug the power cord from the electrical outlet.
Maintenance
- Regular Cleaning: Periodically clean the fountain and pump to prevent mineral buildup and algae growth. Disconnect power, drain water, and use a soft brush or cloth with mild soap and water. Rinse thoroughly.
- Water Quality: Use distilled water to minimize mineral deposits. If using tap water, consider using a fountain algaecide or clarifier to maintain water clarity.
- Pump Care: Clean the pump impeller regularly to ensure optimal performance. Refer to the pump's specific instructions for detailed cleaning procedures.
- Winterization: In freezing climates, drain all water from the fountain and pump before the first frost. Clean the fountain and store the pump indoors in a dry, frost-free location. Cover the fountain or store it indoors to protect it from harsh winter conditions.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Fountain not working | Not plugged in; power outage; low water level; pump clogged or damaged. | Check power connection; verify power supply; add water; clean pump impeller; replace pump if damaged. |
| Water flow is weak | Low water level; pump clogged; kinked tubing. | Add water; clean pump and tubing; straighten tubing. |
| Excessive splashing | Water level too high; fountain not level; pump flow too strong. | Remove some water; ensure fountain is level; adjust pump flow (if applicable). |
| Water becomes cloudy or green | Algae growth; mineral buildup; dirty water. | Clean fountain and pump; use distilled water; add algaecide/clarifier. |
Specifications
- Model Number: TEC234BR
- Product Dimensions: 22"L x 25"W x 40"H (56cm L x 64cm W x 102cm H)
- Material: Plastic
- Color: Dark Brown
- Item Weight: 12.4 pounds
- Power Source: Corded Electric
- Special Feature: Weather Resistant
Warranty and Support
This Alpine Corporation fountain is covered by a 1-year limited manufacturer warranty from the date of purchase. This warranty covers defects in materials and workmanship under normal use.
For warranty claims, technical support, or replacement parts, please contact Alpine Corporation customer service. Keep your proof of purchase for warranty validation.
Contact Information: Please refer to the contact details provided on the product packaging or the official Alpine Corporation website for the most current support information.
