Spectronics EA-160 Handheld UV Lamp User Manual

Introduction

This manual provides essential information for the safe and effective operation of the Spectronics EA-160 Handheld UV Lamp. The EA-160 is a corded handheld ultraviolet (UV) lamp designed for various research applications, featuring a 6W, 365nm integrally-filtered UV tube and operating on 120V.

Please read this manual thoroughly before using the device and retain it for future reference.

Safety Information

Always observe the following safety precautions to prevent injury or damage to the unit:

• Do not look directly into the UV light source. Prolonged exposure can cause eye damage.
• Wear appropriate UV protective eyewear and skin protection when operating the lamp.
• Ensure the lamp is connected to a grounded 120V power outlet.
• Do not operate the lamp in wet or damp conditions.
• Keep the lamp away from flammable materials.
• Disconnect power before cleaning or performing any maintenance.

What's in the Box

Verify that all components are present upon unpacking:

• 1 x Spectronics EA-160 Handheld UV Lamp
• 1 x 6W BLB Tube (pre-installed or separate)

Setup

Follow these steps for initial setup:

1. Unpack the EA-160 UV lamp and its components from the packaging.
2. If the 6W BLB tube is not pre-installed, carefully insert it into the lamp's fixture according to the markings. Ensure it is securely seated.
3. Place the lamp on a stable, flat surface or hold it securely by the handle.
4. Plug the power cord into a standard 120V AC grounded electrical outlet.

Image: A hand holding the Spectronics EA-160 Handheld UV Lamp, which emits a purple UV light. The lamp has a silver casing and a black handle.

Operating Instructions

To operate the Spectronics EA-160 UV Lamp:

1. Ensure all safety precautions are observed, including wearing UV protective eyewear.
2. Locate the power switch on the lamp.
3. Flip the switch to the "ON" position to activate the UV lamp. The 6W BLB tube will illuminate, emitting 365nm UV light.
4. Direct the UV light towards the area or object requiring illumination.
5. When finished, flip the power switch to the "OFF" position.
6. Unplug the lamp from the power outlet when not in use for extended periods.

Maintenance

Proper maintenance ensures the longevity and performance of your EA-160 UV Lamp:

• Cleaning: Disconnect the lamp from power before cleaning. Use a soft, dry cloth to wipe the exterior of the lamp. Do not use abrasive cleaners or solvents.
• Tube Replacement: The 6W BLB tube has a finite lifespan. If the light output diminishes significantly or the tube fails to illuminate, it may need replacement. Refer to the manufacturer's guidelines for compatible replacement tubes and replacement procedures. Ensure the lamp is unplugged and cool before attempting tube replacement.
• Storage: Store the lamp in a cool, dry place away from direct sunlight and extreme temperatures when not in use.

Troubleshooting

If you encounter issues with your EA-160 UV Lamp, refer to the following table:

Specifications

Warranty and Support

For warranty information or technical support regarding your Spectronics EA-160 Handheld UV Lamp, please contact the manufacturer or your point of purchase. Retain your proof of purchase for warranty claims.

Manufacturer: Thomas Scientific