AOLIKES PL 902035

AOLIKES 902035 600mAh Replacement Battery User Manual

Model: PL 902035

1. Introduction

This manual provides essential information for the safe and effective use of your AOLIKES 902035 600mAh Replacement Lithium-ion Battery. Please read this manual thoroughly before installation and use.

AOLIKES 902035 600mAh Lithium-ion Battery, top view showing model number and voltage

Image 1.1: Top view of the AOLIKES 902035 600mAh Lithium-ion Battery, displaying its model number and voltage specifications.

2. Product Overview

The AOLIKES 902035 is a 3.7V rechargeable Lithium-ion battery designed as a replacement for various portable electronic devices.

Key Features:

  • Voltage: 3.7V nominal, 4.2V fully charged.
  • Capacity: 600mAh (2.22Wh).
  • Model: PL902035.
  • Protection: Built-in battery protection circuit module (PMC) to prevent overdischarge and short circuit.
  • Connector: Genuine JST Connector Ph1.25, 2-Pin.
AOLIKES 902035 600mAh Lithium-ion Battery, side view showing the connector

Image 2.1: Side view of the AOLIKES 902035 battery, highlighting the attached JST 2-Pin connector.

3. Setup and Installation

Follow these steps for proper installation of the replacement battery:

  1. Preparation: Ensure the device is powered off and disconnected from any power source before beginning the replacement process.
  2. Old Battery Removal: Carefully remove the old battery from your device. Note its orientation and wiring.
  3. Polarity Check: Before connecting the new battery, compare its wiring with the old battery. The red wire on the AOLIKES 902035 battery connects to the positive (+) power pole, and the black wire connects to the negative (-) power pole. Ensure correct polarity to prevent damage to the device or battery.
  4. Connection: Connect the JST 2-Pin connector of the new battery to the corresponding port on your device's circuit board.
  5. Secure Placement: Place the new battery securely within the device's battery compartment.
  6. Reassembly: Reassemble your device carefully.
Close-up of the JST 2-Pin connector with dimensions

Image 3.1: Detailed view of the JST 2-Pin connector, showing its dimensions for compatibility verification.

4. Operating Instructions

Once installed, the battery operates as a standard power source for compatible devices. For optimal performance:

  • Initial Charge: It is recommended to fully charge the battery before its first use in the device.
  • Charging: Use a charger compatible with 3.7V Lithium-ion batteries. Avoid overcharging or using incompatible chargers.
  • Discharge: Avoid completely draining the battery to 0% charge, as this can reduce its lifespan.
  • Temperature: Operate the battery within recommended temperature ranges (typically 0°C to 45°C for charging, -20°C to 60°C for discharging).

5. Maintenance and Storage

  • Cleaning: Keep battery contacts clean and free from dust or debris. Use a dry, soft cloth for cleaning.
  • Storage: If storing the battery for an extended period, charge it to approximately 50% and store in a cool, dry place away from direct sunlight and extreme temperatures.
  • Regular Check: Periodically check the battery for any signs of swelling, leakage, or damage. Discontinue use immediately if any issues are observed.

6. Troubleshooting

ProblemPossible CauseSolution
Device does not power on after battery installation.Incorrect polarity; Battery not fully charged; Loose connection.Verify red wire is connected to positive and black to negative. Charge the battery. Ensure connector is firmly seated.
Battery does not hold charge.Battery defect; Incompatible charger; Battery reached end of life.Test with a known good charger. If new, contact seller. Replace battery if old.
Battery swells or overheats.Overcharging; Internal short circuit; Physical damage.Immediately discontinue use and safely dispose of the battery. Do not attempt to charge or use.

7. Specifications

AttributeValue
BrandAOLIKES
Model NumberPL 902035
Battery TypeLithium Polymer
Nominal Voltage3.7 Volts
Fully Charged Voltage4.2 Volts
Capacity600 mAh (2.22 Wh)
Dimensions (L x W x T)35 x 20 x 9 mm (1.38 x 0.78 x 0.35 inch) max
Weight11g
Connector TypeGenuine JST Connector Ph1.25, 2-Pin
Compatible DevicesBluetooth Speaker, MP3, PDA, MP4, FM radio, Wireless Bluetooth Headset, Pet GPS, Keychain cam small camera, mini DVR, electronic readers, etc.

8. Safety Warnings and Disposal

  • Do not disassemble, puncture, short circuit, or expose the battery to fire or high temperatures.
  • Keep out of reach of children.
  • Do not use if the battery appears damaged, swollen, or leaking.
  • Dispose of batteries responsibly according to local regulations. Do not dispose of in household waste.

© 2024 AOLIKES. All rights reserved.

For support, please refer to your product's original vendor or purchase platform.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.