Tier1 RWF1100
Tier1 Refrigerator Water Filter Instruction Manual
Model: RWF1100
Product Overview
The Tier1 RWF1100 refrigerator water filter is designed to provide clean, fresh-tasting water and ice by reducing common impurities. This filter utilizes an activated carbon block to effectively remove chlorine taste and odor, rust, sediment, and turbidity from your water supply. It is a direct replacement for various filter models, ensuring a perfect fit and reliable performance.

Image: The Tier1 RWF1100 refrigerator water filter shown alongside its product packaging.
Installation Instructions
Follow these steps to properly install your new Tier1 RWF1100 refrigerator water filter. No special tools are required for installation.
Step 1: Locate the Filter Compartment
Identify the water filter compartment within your refrigerator. This is typically located in the upper right corner of the fresh food compartment or in the base grille.

Image: A view inside a refrigerator, highlighting the location of the water filter compartment.
Step 2: Remove the Old Filter
Gently push the tab or turn the old filter counter-clockwise (depending on your refrigerator model) to release it from its housing. Some water may drip out, so have a towel ready.

Image: A hand demonstrating the action of reaching into the refrigerator compartment to remove the existing water filter.
Step 3: Install the New Filter
Align the new Tier1 RWF1100 filter with the filter housing. Push the filter firmly into the compartment and turn it clockwise until it locks into place. Ensure a secure fit to prevent leaks.

Image: The new Tier1 water filter being inserted and twisted into its designated slot within the refrigerator.

Image: A detailed view of the top connection point of the Tier1 RWF1100 filter, showing the O-rings that ensure a watertight seal.

Image: A view of the bottom of the Tier1 RWF1100 filter, illustrating the hexagonal connection point and water inlet.
Step 4: Flush the System
After installation, dispense approximately 2-3 gallons of water through the refrigerator's water dispenser to flush out any air or carbon fines from the new filter. This will ensure optimal water quality.
Step 5: Reset the Filter Indicator Light
Most refrigerators have a filter indicator light. Refer to your refrigerator's user manual for specific instructions on how to reset this light after replacing the filter. This typically involves pressing and holding a specific button for a few seconds.
Operating Principle
The Tier1 RWF1100 filter operates using an activated carbon block filtration media. As water flows through the filter, impurities are trapped within the porous carbon structure, allowing only clean water to pass through.

Image: A diagram showing how water flows through the activated carbon block filter, illustrating the filtration process where impurities are absorbed and clean water exits.
Maintenance
For optimal performance and water quality, it is recommended to replace your Tier1 RWF1100 refrigerator water filter every 6 months or after filtering 300 gallons of water, whichever comes first. A sticker is included with the filter to help you track the installation date and next replacement date.
Troubleshooting
- Slow Water Flow: If water flow from the dispenser is slow, ensure the filter is correctly seated and locked into place. A new filter might also have some air trapped, which should clear after flushing a few gallons of water. If the filter is old, it may be clogged and require replacement.
- Water Taste/Odor: If water still has an undesirable taste or odor after replacement, ensure the filter was flushed thoroughly. If the issue persists, verify that the filter is the correct model for your refrigerator and that it is properly installed.
- Leaking: Check that the filter is fully inserted and twisted clockwise until it is snug. Ensure the O-rings on the filter are not damaged or missing. If leaking continues, remove and re-install the filter carefully.
Specifications
| Model Number | RWF1100 |
| Material | Activated Carbon Block |
| Product Dimensions | 2.41"D x 2.41"W x 9.25"H |
| Item Weight | 0.6 Pounds (9.6 ounces) |
| Capacity | 300 Gallons |
| External Testing Certification | NSF 42, NSF 372 |
| Compatible Replacements | CS-52, 640565, EVOLFLTR10, CS-51, AP3961137, EFF-6026A, WSB-1, WSQ-1, SGF-BO50, EAP8729485, OCS CS52, CS-450, CS-451, CS-452, CS-512, CS-522, CS-532, CS-562, 1257074, 56932, 2168701, 70020002518, W1085590, B20CS5, 5553629, 55866-05, 5586605, 55866-06, 5586606, WHKFR-PLUS, WHKF-R-PLUS, WHCF-IMTOS, WHCF-IMPLUS, WHKFR Plus WHCF-R-Plus 56932, W1085590, 8668597, C00094379, C00097913, D846181. |
Warranty and Support
Tier1 products are designed for quality and performance. For specific warranty information or technical support, please refer to the contact details provided on the product packaging or visit the official Tier1 website. It is recommended to retain your proof of purchase for warranty claims.
Related Documents - RWF1100
![]() |
Filterlogic UKF8001 Water Filter Compatibility Guide & Model Numbers Find compatible refrigerator models for the Filterlogic UKF8001 water filter. Includes Whirlpool, Maytag, EveryDrop, KitchenAid, Pur, and other brands with their model numbers. |
![]() |
Waterdrop WD-F07 Refrigerator Water Filter Compatibility Guide Find compatible filter and refrigerator model numbers for the Waterdrop WD-F07 refrigerator water filter. This guide lists cross-references for Whirlpool, Maytag, EveryDrop, KitchenAid, Pur, and other brands, along with compatible refrigerator models. |
![]() |
Waterdrop WDP-F07 Refrigerator Water Filter Compatibility Guide Find compatible refrigerator models for your Waterdrop WDP-F07 refrigerator water filter. This guide lists cross-references for Whirlpool, Maytag, Everydrop, Kitchenaid, and Pur filters, along with other replacement filter brands. |
![]() |
AQUA CREST AQF-FF07 Water Filter Compatibility Guide Find compatible Whirlpool, Maytag, Everydrop, Kitchenaid, and Pur refrigerator and filter models for the AQUA CREST AQF-FF07 water filter. Includes lists of other compatible filter brands and model numbers. |
![]() |
AIKO NEOSTAR 2S60 Solar Panel | 500W-520W High-Efficiency PV Module Explore the AIKO NEOSTAR 2S60 solar panel, a 500W-520W N-type ABC PV module offering superior efficiency, durability, and advanced features. Ideal for reliable solar energy generation with a 30-year performance warranty. |
![]() |
AIKO Comet 2U 640W-670W Mono-Glass Module Datasheet Technical specifications, features, and performance data for the AIKO Comet 2U series of high-efficiency mono-glass solar modules, including electrical characteristics, product specifications, and warranty information. |





