Important Safety Information
Please read and understand this entire manual before attempting to assemble, operate, or install the product. Failure to follow these instructions may result in electric shock, fire, property damage, or personal injury.
- This electric stove is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
- Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the stove and keep them away from the sides and rear.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over.
- To disconnect heater, turn controls to off, then remove plug from outlet.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
- Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
Product Description
The Muskoka MES32BL-2 Blackstone Series Electric Stove is designed to provide supplemental heat and a realistic flame effect for your living space. Featuring dual operable doors and a matte black finish, this unit enhances the ambiance of any room. It operates with or without heat, offering both high and low heat settings, and can heat areas up to 400 square feet. The LED lights enhance the wood-burning flame effect, and the unit includes a remote control for convenient operation.
Figure 1: Muskoka MES32BL-2 Electric Stove with one door open, revealing the realistic log and flame effect.
Package Contents
Carefully remove all components from the packaging and place them on a soft, clean surface. Ensure all items listed below are present before discarding packaging materials.
- Muskoka MES32BL-2 Electric Stove Unit
- Remote Control
- 2 x AAA Batteries (for remote control)
Setup and Installation
Placement
Place the electric stove on a firm, level surface. Ensure there is adequate clearance from combustible materials as specified in the Important Safety Information section. Do not block the air vents located on the bottom or rear of the unit.
Power Connection
- Ensure the stove's power switch is in the OFF position.
- Plug the power cord directly into a 120V, 60Hz grounded electrical outlet. Do not use an extension cord or power strip.
Remote Control Battery Installation
- Locate the battery compartment on the back of the remote control.
- Open the battery cover.
- Insert the two AAA batteries, ensuring correct polarity (+/-).
- Close the battery cover securely.
Operating Instructions
Manual Operation (Controls on Unit)
The control panel is typically located behind one of the operable doors or on the lower front panel of the stove.
- Power Switch: Turns the entire unit ON or OFF.
- Flame Effect Button: Activates or deactivates the LED flame effect. This can be used independently of the heater.
- Heat Settings: Selects between LOW heat, HIGH heat, or OFF.
Remote Control Operation
Point the remote control directly at the front of the electric stove for optimal response.
- ON/OFF Button: Powers the unit ON or OFF.
- Flame Button: Toggles the flame effect ON or OFF.
- Heat Button: Cycles through heat settings: LOW, HIGH, and OFF.
Maintenance
Cleaning
Always disconnect the power before cleaning the stove.
- Exterior: Wipe the exterior surfaces with a soft, damp cloth. Do not use abrasive cleaners or sprays.
- Glass/Screen: Clean the glass or mesh screen with a soft cloth. Avoid harsh chemicals that may damage the finish.
- Vents: Use a vacuum cleaner with a brush attachment to remove dust from the air intake and exhaust vents.
Light Bulb Replacement (if applicable)
This model uses LED lights for the flame effect, which typically do not require replacement. If your unit uses incandescent bulbs for the flame effect, refer to the specific instructions provided with your unit for bulb replacement. Ensure the unit is unplugged and cool before attempting any bulb replacement.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Stove does not turn ON. | No power to the unit. | Ensure the power cord is securely plugged into a grounded outlet. Check the circuit breaker. |
| No heat, but flame effect works. | Heater function is OFF or set to a low setting. | Press the heat button on the unit or remote to cycle through heat settings (LOW/HIGH). |
| Flame effect does not work. | Flame effect is OFF. | Press the flame button on the unit or remote to activate the flame effect. |
| Remote control not working. | Dead batteries or obstruction. | Replace batteries in the remote control. Ensure there is no obstruction between the remote and the stove's sensor. |
| Unit overheats and shuts off. | Overheat protection activated. | Unplug the unit, wait 10-15 minutes for it to cool down. Check for blocked air vents and clear any obstructions. Plug back in and restart. |
Specifications
- Model Number: MES32BL-2
- Brand: Muskoka
- Power Source: Corded Electric
- Installation Type: Freestanding
- Special Feature: LED Flame
- Style: Electric Stove
- Color: Matte Black
- Heating Coverage: Up to 400 sq ft
- Included Components: Remote Control
- Item Weight: 42.5 Pounds
- UPC: 833451502188
Warranty and Support
This product comes with a limited year warranty. For specific warranty details, claims, or technical support, please refer to the warranty card included with your purchase or contact Muskoka customer service directly. Keep your proof of purchase for warranty purposes.