Talon Snappit Radiator Pipe Cover Instruction Manual

Product Overview

The Talon Snappit ACSNW/10 is a snap-on pipe cover designed to aesthetically conceal radiator tails. This product is supplied as a set of 10 pieces, each 200mm in length, made from uPVC, and finished in white. It is intended for use with 15mm, 22mm, and 28mm pipework, providing a clean and finished look around radiator installations.

Image: A pack of 10 white Talon Snappit pipe covers, showing their snap-on design and smooth finish.

Setup and Installation

1. Prepare the Pipe: Ensure the radiator pipework is clean and free from debris. Measure the diameter of your pipe to confirm compatibility with 15mm, 22mm, or 28mm sizes.
2. Measure and Cut (if necessary): The Snappit covers are 200mm long. If a shorter length is required, carefully measure and cut the uPVC cover to the desired size using a suitable cutting tool.
3. Position the Cover: Align the open seam of the Snappit cover with the pipe.
4. Snap into Place: Gently but firmly press the cover around the pipe until it snaps securely into place. The design allows for a snug fit around the pipework.
5. Final Adjustment: Once snapped on, adjust the cover as needed to ensure it sits flush and provides the desired aesthetic finish.

Note: While the product is designed for 15mm, 22mm, and 28mm pipes, it is recommended to verify the exact fit for your specific pipe diameter before installation.

Usage

The Talon Snappit pipe covers are designed for decorative purposes, providing a neat and tidy appearance for exposed radiator pipes. They are suitable for both new installations and retrofitting to existing pipework to enhance the visual appeal of your heating system.

Maintenance

To maintain the appearance of your Talon Snappit pipe covers, simply wipe them clean with a soft, damp cloth. Avoid using abrasive cleaners or harsh chemicals, as these may damage the uPVC material or its finish.

Troubleshooting

• Cover does not snap securely:
  • Ensure the pipe diameter matches one of the specified sizes (15mm, 22mm, or 28mm).
  • Verify that the cover is correctly aligned before applying pressure.
  • Check for any obstructions or debris on the pipe or inside the cover.
• Cover appears too loose:
  • The pipe diameter may be smaller than the intended fit. Re-measure your pipe.
  • Ensure the cover is fully snapped into place along its entire length.

Specifications

Warranty and Support

For information regarding product warranty, please refer to the documentation provided at the time of purchase or contact your retailer. For further support or inquiries, please reach out to the manufacturer, TALON, through their official channels.