1. Product Overview
The Bajaj Majesty 15GMH is a 15-litre storage water heater designed for efficient and reliable hot water supply. This manual provides essential information for the safe installation, operation, and maintenance of your appliance.
Image 1: Front view of the Bajaj Majesty 15GMH 15-Litre Storage Water Heater, showing the temperature gauge and control knob.
Key Features:
- Capacity: 15 Litres
- Wattage: 2000 Watts
- Swirlflow Technology: Designed for efficient heating.
- Magnesium Anode Rod: Provides protection against corrosion.
- Adjustable Thermostat: Allows for temperature control.
- Multiple Safety Systems: Includes protection against dry heating, overheating, and overpressure.
- High Pressure Compatibility: Suitable for high-pressure installations up to 0.7 MPa (8 bar).
- Neon Indicators: For power and heating status.
- Fire Retardant Cable: Equipped with a 3-pin plug for safety.
2. Setup and Installation
Proper installation is crucial for the safe and efficient operation of your water heater. It is recommended that installation be performed by a qualified technician.
2.1 Unpacking
Carefully remove the water heater from its packaging. Inspect the unit for any signs of damage. The package should contain:
- 1N Water Heater
- 1N Instruction Manual
- 1N Warranty Card
2.2 Mounting
The Bajaj Majesty 15GMH is designed for wall mounting and indoor installation. Ensure the wall is strong enough to support the weight of the water heater when full (approximately 25.6 kg).
Image 2: Diagram illustrating the dimensions of the Bajaj Majesty 15GMH water heater: 61.4 cm (length), 37.2 cm (height), and 37 cm (depth).
Dimensions (LxWxH): 61.4 x 37.2 x 37 Centimeters
2.3 Plumbing Connections
Connect the water inlet and outlet pipes to the designated ports on the water heater. Ensure all connections are secure and leak-free. The unit is suitable for high-pressure water supply systems, with a rated pressure of 0.7 MPa (8 bar).
2.4 Electrical Connection
Connect the water heater to a suitable 230 Volts, 2000 Watts power supply using the provided fire-retardant 3-pin plug. Ensure the electrical circuit is properly grounded and protected by a suitable circuit breaker.
3. Operating Instructions
Follow these steps for safe and effective operation of your Bajaj Majesty 15GMH water heater.
3.1 Filling the Tank
- Ensure all plumbing connections are tight.
- Open the cold water inlet valve to allow water to fill the tank.
- Open a hot water tap in your bathroom to allow air to escape from the system.
- Once water flows steadily from the hot water tap, close the tap. The tank is now full.
3.2 Powering On and Temperature Adjustment
- Plug the water heater into the power outlet. The power indicator (neon light) will illuminate.
- Adjust the temperature control knob to your desired setting. The heating indicator (neon light) will illuminate when the heating element is active.
- The water heater will automatically heat the water to the set temperature and then switch off. The heating indicator will turn off.
- When the water temperature drops, the heater will automatically switch on again to maintain the set temperature.
The water heater is designed to heat water efficiently, typically reaching a suitable bathing temperature within 15-20 minutes, depending on the initial water temperature and volume.
4. Maintenance
Regular maintenance ensures the longevity and optimal performance of your water heater.
4.1 General Cleaning
- Before cleaning, always disconnect the power supply to the water heater.
- Wipe the exterior of the unit with a soft, damp cloth. Do not use abrasive cleaners or solvents.
4.2 Anode Rod Inspection
The water heater is equipped with a Magnesium Anode Rod, which helps protect the inner tank from corrosion by attracting harmful salts. This rod should be inspected periodically (e.g., annually) by a qualified technician and replaced if significantly depleted.
4.3 Draining the Tank (If required)
If the water heater will not be used for an extended period or if there is a risk of freezing, the tank should be drained:
- Disconnect the power supply.
- Close the cold water inlet valve.
- Open a hot water tap to release pressure.
- Open the drain valve at the bottom of the water heater to allow water to empty.
5. Troubleshooting
This section addresses common issues you might encounter with your water heater.
| Problem | Possible Cause | Solution |
|---|---|---|
| No hot water | No power supply Thermostat set too low Heating element failure | Check power connection and circuit breaker Adjust thermostat to a higher setting Contact service technician |
| Water not hot enough | Thermostat set too low Excessive hot water usage Sediment buildup | Increase thermostat setting Allow time for water to reheat Contact service technician for descaling |
| Water heater leaking | Loose plumbing connections Pressure relief valve discharge Tank corrosion | Tighten connections This is normal if pressure is too high; check water pressure Contact service technician immediately |
| No power indicator light | No power supply Faulty indicator light | Check power connection and circuit breaker Contact service technician |
If you encounter issues not listed here or if the suggested solutions do not resolve the problem, please contact Bajaj customer support.
6. Specifications
| Specification | Value |
|---|---|
| Brand | Bajaj |
| Model Number | Majesty GMH |
| Type | Storage Water Heater |
| Capacity | 15 Litres |
| Wattage | 2000 Watts |
| Voltage | 230 Volts |
| Rated Pressure | 0.7 MPa (8 Bar) |
| Mounting Type | Wall |
| Installation Style | Indoor |
| Special Features | Overheat Protection, Over Temperature Protection, Pressure Release Valve |
| Colour | White |
| Item Weight | 10 kg 600 g |
| Item Dimensions (LxWxH) | 61.4 x 37.2 x 37 Centimeters |
| Country of Origin | India |
7. Warranty and Support
7.1 Warranty Information
The Bajaj Majesty 15GMH water heater comes with a warranty of 2 years on the product and 5 years on the inner tank, provided by Bajaj.
Legal Disclaimer: Warranty and further services are provided by the company (Bajaj) and not by the seller.
7.2 Manufacturer and Support
Manufacturer: Bajaj, Marketed by Bajaj Electricals Limited
For any service requests, technical assistance, or warranty claims, please contact Bajaj customer support directly. Refer to the warranty card included with your product for specific contact details and terms.
