Product Overview
The Gravity Audio GR-15PW is a high-performance 15-inch car subwoofer designed to deliver powerful and clear bass. It features a dual 4 Ohm voice coil configuration, allowing for flexible wiring options to match various amplifier setups. With a peak power handling of 3200 Watts, this subwoofer is built for robust audio reproduction in your vehicle.
Key features include:
- Dual 4 Ohm Voice Coil Configuration
- Peak Power: 3200 Watts
- Competition Grade Pressed Paper Cone
- High Roll Foam Surround
- Advanced Air Flow Cooling System
Image: The Gravity Audio GR-15PW 15-inch car subwoofer. The image displays two subwoofers, one showing its silver cone and black foam surround, and the other showing its robust black magnet structure with yellow accents and "1600W" labeling, indicating its power handling capabilities.
Setup and Installation
Proper installation is crucial for optimal performance and longevity of your subwoofer. It is recommended that installation be performed by a qualified professional.
Mounting Considerations
- Ensure the mounting surface is sturdy and free from obstructions.
- Verify adequate clearance for the subwoofer's depth and excursion.
- For sealed or ported enclosures, follow recommended enclosure volume guidelines for the best sound quality.
Wiring and Connections
The GR-15PW features dual 4 Ohm voice coils. This allows for various wiring configurations to achieve different impedance loads at your amplifier. Common configurations include:
- Parallel Wiring (2 Ohms): Connect positive terminals of both voice coils together, and negative terminals of both voice coils together. Connect the combined positive to the amplifier's positive output and combined negative to the amplifier's negative output. This configuration presents a 2 Ohm load to the amplifier.
- Series Wiring (8 Ohms): Connect the positive terminal of one voice coil to the negative terminal of the other voice coil. Connect the remaining free positive terminal to the amplifier's positive output and the remaining free negative terminal to the amplifier's negative output. This configuration presents an 8 Ohm load to the amplifier.
Always ensure your amplifier is stable at the chosen impedance load. Use appropriate gauge wiring for power, ground, and speaker connections to prevent power loss and ensure safety.
Operating Guidelines
To achieve the best sound and prolong the life of your subwoofer, follow these operating guidelines:
- Break-in Period: Allow a break-in period of approximately 20-30 hours of moderate use before operating the subwoofer at high volumes. This allows the suspension components to loosen up and perform optimally.
- Gain Setting: Properly set the gain on your amplifier to match the output voltage of your head unit. Avoid setting the gain too high, as this can lead to clipping and damage to the subwoofer.
- Crossover Settings: Use a low-pass filter (LPF) on your amplifier or head unit to send only low frequencies to the subwoofer. A typical LPF setting for a 15-inch subwoofer might be between 60Hz and 80Hz, but this can vary based on your system and preferences.
- Subsonic Filter: If your amplifier has a subsonic filter, enable it and set it slightly below your enclosure's tuning frequency (for ported enclosures) or around 20-25Hz (for sealed enclosures) to protect the subwoofer from playing frequencies too low for its design.
- Listen for Distortion: If you hear any distortion, rattling, or unpleasant sounds, immediately reduce the volume. Continued operation with distortion can cause permanent damage.
Maintenance
The Gravity Audio GR-15PW is designed for durability, but proper care will ensure its longevity:
- Cleaning: Gently wipe the cone and surround with a soft, dry cloth to remove dust. Avoid using harsh chemicals or excessive moisture.
- Environmental Protection: Protect the subwoofer from extreme temperatures, direct sunlight, and moisture. While the product is not waterproof, reasonable protection from spills and condensation is advised.
- Inspect Connections: Periodically check all wiring connections to ensure they are secure and free from corrosion. Loose connections can lead to poor performance or damage.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| No Sound from Subwoofer | No power to amplifier; Loose wiring; Amplifier in protect mode; Incorrect gain setting; Blown fuse. | Check amplifier power and ground connections; Verify all speaker wires are secure; Check amplifier status light; Adjust gain; Inspect and replace fuses if necessary. |
| Distorted Sound | Gain set too high (clipping); Incorrect crossover settings; Damaged voice coil. | Reduce amplifier gain; Adjust LPF and subsonic filter settings; If distortion persists at low volumes, the subwoofer may be damaged and require professional inspection. |
| Weak Bass Output | Incorrect wiring impedance; Phase issue; Insufficient amplifier power; Poor enclosure design. | Verify wiring matches amplifier's stable impedance; Check phase switch on amplifier/head unit; Ensure amplifier provides adequate power for the subwoofer; Consult with an audio professional for enclosure optimization. |
Specifications
| Feature | Detail |
|---|---|
| Model Name | GR-15PW |
| Speaker Type | Subwoofer |
| Subwoofer Diameter | 15 Inches |
| Impedance | Dual 4 Ohm Voice Coil |
| Peak Power | 3200 Watts |
| RMS Power | 1600 Watts |
| Frequency Response | 30 - 2.5kHz |
| Sensitivity | 90 dB |
| Cone Material | Competition Grade Pressed Paper Cone |
| Surround Material | High Roll Foam Surround |
| Cooling System | Advanced Air Flow Cooling System |
| Item Weight | 20.6 pounds |
| Package Dimensions | 19 x 18.1 x 9.2 inches |
Warranty and Support
The Gravity Audio GR-15PW subwoofer comes with a Limited Warranty. Please refer to the warranty card included with your product for specific terms and conditions, including coverage duration and claim procedures.
For technical support, troubleshooting assistance, or warranty inquiries, please contact Gravity Audio customer service. Contact information can typically be found on the manufacturer's official website or on the product packaging.
