Ideal Standard San ReMo slimline K705401 Toilet Seat User Manual

Introduction

This manual provides detailed instructions for the installation, operation, and maintenance of your Ideal Standard San ReMo slimline K705401 Toilet Seat. Please read this manual thoroughly before installation and retain it for future reference.

Safety Information

• Ensure all components are present and undamaged before beginning installation.
• Do not use abrasive cleaners or harsh chemicals on the toilet seat or hinges, as this may damage the finish.
• Avoid excessive force when closing the seat, as this model does not feature a soft-close mechanism.
• Keep small parts out of reach of children.

Package Contents

Verify that all the following items are included in your package:

• Ideal Standard San ReMo slimline Toilet Seat (Duroplast, White)
• Stainless Steel Hinges and Mounting Hardware

Setup (Installation)

Follow these steps to properly install your new toilet seat. Basic tools such as a screwdriver or wrench may be required.

1. Prepare the Toilet Bowl: If replacing an old seat, remove it completely. Clean the toilet bowl's mounting area thoroughly.
2. Attach Hinges to Seat: Secure the stainless steel hinges to the designated points on the underside of the toilet seat using the provided screws. Ensure they are firmly attached but do not overtighten.
3. Position the Seat: Place the toilet seat with attached hinges onto the toilet bowl, aligning the hinge posts with the mounting holes on the ceramic.
4. Secure the Mounting Hardware: From underneath the toilet bowl, attach the washers and nuts to the hinge posts. Hand-tighten first to allow for minor adjustments.
5. Adjust and Tighten: Adjust the seat position to ensure it is centered and aligned with the toilet bowl. Once satisfied with the alignment, fully tighten the nuts using a suitable tool. Do not overtighten, as this can damage the ceramic or hardware.
6. Test Stability: Gently test the seat for stability. It should not wobble or shift.

Figure 1: Technical drawing illustrating the dimensions and hinge mounting points of the toilet seat.

Figure 2: The K705401 toilet seat shown installed on a compatible toilet bowl.

Operating (Usage)

The Ideal Standard San ReMo slimline toilet seat is designed for standard use. Please note the following:

• This toilet seat does not feature a soft-close mechanism. Close the seat and lid manually with care to prevent slamming.
• Ensure the seat is fully lowered before use.

Figure 3: The K705401 toilet seat in its closed position.

Figure 4: The K705401 toilet seat with the lid in the open position.

Figure 5: Front view of the K705401 toilet seat, highlighting its slimline design.

Maintenance

Proper care will ensure the longevity and appearance of your toilet seat.

• Cleaning the Seat: Use a soft cloth and mild, non-abrasive soap and water. Wipe gently and rinse thoroughly with clean water. Dry with a soft cloth.
• Cleaning the Hinges: The stainless steel hinges can be cleaned with a damp cloth and mild detergent. Avoid harsh chemicals or abrasive pads that could scratch the finish.
• Avoid: Do not use bleach, acid-based cleaners, scouring powders, or abrasive sponges, as these can damage the Duroplast material and stainless steel finish.
• Periodic Check: Periodically check the hinge connections to ensure they remain tight. Retighten if necessary to prevent wobbling.

Troubleshooting

Specifications

Warranty and Support

For warranty information or technical support, please refer to the official Ideal Standard website or contact their customer service department. Keep your proof of purchase for any warranty claims.

Note: Specific warranty terms may vary by region and retailer.