PowerPro Downrigger Line User Manual

1. Product Overview

The PowerPro Downrigger Line is engineered to provide superior performance for deep-water fishing applications. It is designed as a reliable replacement for traditional steel downrigger cables, offering enhanced sensitivity and strength.

Key Features:

• Eliminates electrostatic hum often associated with steel downrigger cables.
• Delivers the necessary strength to securely hold the cannonball in place.
• Features a small diameter to minimize blowback during deployment.
• Designed to resist burying in the spool, ensuring smooth operation.

2. Setup Instructions

This PowerPro line is intended as a direct replacement for steel downrigger cables. Follow these general steps for installation:

1. Remove Old Cable: Carefully remove the existing steel cable from your downrigger spool, following your downrigger manufacturer's instructions.
2. Attach New Line: Securely attach the PowerPro downrigger line to the downrigger spool. Ensure the knot is strong and reliable.
3. Spooling: Wind the PowerPro line onto the spool under moderate tension to prevent burying and ensure even layering. Avoid overfilling the spool.
4. Attach Terminal Tackle: Connect your cannonball or other terminal tackle to the end of the PowerPro line using appropriate knots and hardware.

Always refer to your specific downrigger model's manual for detailed instructions on cable replacement and spooling.

3. Operating Guidelines

Once installed, the PowerPro downrigger line operates similarly to traditional cables but with added benefits:

• Quiet Operation: Experience reduced noise due to the elimination of electrostatic hum common with steel cables.
• Minimal Blowback: The small diameter of the line helps reduce the amount of line drift caused by water resistance, allowing your cannonball to track more directly.
• Sensitivity: The near-zero stretch of the PowerPro line provides increased sensitivity, allowing you to better detect subtle changes in lure action or bottom contact.
• Deployment and Retrieval: Deploy and retrieve your downrigger as usual, noting the smooth performance of the PowerPro line.

4. Maintenance

Proper maintenance will extend the life and performance of your PowerPro downrigger line:

• Rinse After Use: After each use, especially in saltwater, rinse the line thoroughly with fresh water to remove salt, dirt, and debris.
• Inspect Regularly: Periodically inspect the entire length of the line for any signs of fraying, nicks, or abrasion. Pay close attention to sections that come into contact with the downrigger release clip or the bottom.
• Storage: Store your downrigger in a cool, dry place away from direct sunlight and extreme temperatures.
• Replace When Necessary: If significant damage or wear is observed, replace the line to ensure safety and optimal performance.

5. Troubleshooting

While PowerPro downrigger line is designed for reliability, here are some common issues and solutions:

• Line Burying in Spool: Ensure the line was spooled under sufficient tension. If it continues to bury, try re-spooling with more consistent tension.
• Line Twist: While less common with braided lines, excessive twisting can occur from certain lure actions or retrieval methods. Periodically run the line out without a lure to allow it to untwist.
• Reduced Sensitivity: Check for any slack in the line or issues with the downrigger mechanism. Ensure the line is properly spooled and tensioned.
• Premature Wear: Inspect all contact points on your downrigger (pulleys, guides, release clips) for sharp edges or burrs that could abrade the line.

6. Specifications

7. Warranty and Support

For specific warranty information and customer support regarding your PowerPro Downrigger Line, please refer to the manufacturer's official website or contact their customer service directly. Retain your proof of purchase for any warranty claims.

Manufacturer: Shimano American Corporation