Planet Pool B003N1W05G

Planet Pool Underwater Repair Kit

Model: B003N1W05G

1. Product Overview

The Planet Pool Underwater Repair Kit is designed for repairing small damages to foil liners in pools and garden ponds. This versatile kit can be effectively used both underwater and on dry surfaces, making it suitable for all PVC garden pond and pool liners.

Planet Pool Underwater Repair Kit packaging showing adhesive and repair patches.

Image 1.1: Planet Pool Underwater Repair Kit contents.

2. Package Contents

  • 1x Adhesive tube
  • 2x Foil strips (patches), each measuring 20 x 10 cm

3. Safety Information

WARNING: This product contains chemicals that require careful handling. Please read all safety instructions before use.

3.1 Hazard Classification and Categories

  • Flammable Liquid 2
  • Eye Irritation 2
  • Specific Target Organ Toxicity - Single Exposure 3 (STOT SE 3)

3.2 Hazard Symbols (GHS)

GHS02 Flammable symbol (flame) and GHS07 Irritant symbol (exclamation mark).

Image 3.1: GHS Hazard Symbols GHS02 (Flammable) and GHS07 (Irritant).

3.3 Signal Word

DANGER

3.4 Precautionary Statements (P-phrases)

  • P101: If medical advice is needed, have product container or label at hand.
  • P102: Keep out of reach of children.
  • P280: Wear protective gloves/eye protection.
  • P303+P361+P353: IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water [or shower].
  • P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
  • P405: Store locked up.
  • P501: Dispose of contents/container in accordance with local/regional/national/international regulations.

3.5 Hazard Statements (H-phrases)

  • EUH066: Repeated exposure may cause skin dryness or cracking.
  • H225: Highly flammable liquid and vapor.
  • H319: Causes serious eye irritation.
  • H336: May cause drowsiness or dizziness.

4. Setup and Preparation

  1. Ensure the damaged area of the liner is clean and free from algae, dirt, or debris. For best results, gently scrub the area if possible.
  2. Cut a repair patch from the provided foil strips. The patch should be approximately 5 cm larger than the damaged area on all sides to ensure adequate coverage and adhesion.
  3. Gather necessary safety equipment, including protective gloves and eye protection, as indicated in the safety warnings.

5. Operating Instructions (Application)

5.1 Underwater Application

  1. Apply a thin, even layer of the adhesive to one side of the prepared repair patch.
  2. Carefully position the patch over the damaged area of the liner while underwater.
  3. Press the patch firmly against the liner for several seconds to ensure good contact and adhesion.

5.2 Dry Surface Application

  1. Apply a thin, even layer of the adhesive to one side of the prepared repair patch.
  2. Allow the adhesive to air dry for a short period until it becomes tacky (refer to adhesive instructions for specific drying times if available).
  3. Carefully position the patch over the damaged area of the liner.
  4. Press the patch firmly against the liner for several seconds to ensure good contact and adhesion.

5.3 Curing Time

After application, the adhesive will be fully cured and the repair will be fully load-bearing after approximately 2 hours.

6. Maintenance

Store any unused adhesive and foil strips in their original packaging in a cool, dry, and locked-up place, away from direct sunlight and out of reach of children. Ensure the adhesive tube is tightly sealed after use to prevent drying.

7. Troubleshooting

  • Patch not adhering: Ensure the surface was thoroughly cleaned and dry (for dry application) before applying the adhesive. Re-clean the area and apply a new patch.
  • Leak persists: The patch may not be large enough to cover the entire damaged area, or the edges may not be fully sealed. Ensure the patch extends at least 5 cm beyond the damage. Consider applying a second, larger patch if necessary.
  • Adhesive not curing: Ensure sufficient curing time (approximately 2 hours) has passed before stressing the repair. Environmental factors like extreme cold may prolong curing time.

8. Specifications

  • Brand: Planet Pool
  • Model: B003N1W05G
  • Package Dimensions: 23 x 14.6 x 0.2 cm
  • Package Weight: 5 g
  • Manufacturer: Planet Pool
  • Date First Available: 23 October 2019

9. Warranty and Support

Information regarding specific warranty terms or direct support contacts for this product is not available in the provided data. Please refer to the product packaging or the retailer's website for warranty details and customer support options.

© 2023 Planet Pool. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.