Wagner 9155

Wagner 9155 3000 PSI Airless Twin Stroke Piston Pump Paint Sprayer User Manual

Model: 9155

1. Introduction

This manual provides instructions for the safe and effective use of your Wagner 9155 Airless Twin Stroke Piston Pump Paint Sprayer. This contractor-grade sprayer is designed for residential and light commercial painting tasks, offering efficient application for various materials and surfaces. Please read this manual thoroughly before operation to ensure proper setup, use, and maintenance.

Wagner 9155 Airless Paint Sprayer with cart and hose

Figure 1: The Wagner 9155 Airless Twin Stroke Piston Pump Paint Sprayer, featuring its robust design, integrated cart, and hose connection.

2. Safety Information

Always prioritize safety when operating the Wagner 9155 paint sprayer. Refer to the comprehensive safety warnings provided with the product packaging and in the dedicated safety section of the printed user manual. Key safety considerations include:

  • Wear appropriate personal protective equipment (PPE), including eye protection, gloves, and a respirator.
  • Ensure adequate ventilation in the work area to prevent inhalation of paint fumes.
  • Never point the spray gun at people or animals. The high pressure can cause serious injury.
  • Always disconnect power before cleaning, servicing, or performing maintenance.
  • Keep children and pets away from the work area.
  • Do not operate the sprayer near open flames or ignition sources.
  • Follow all paint manufacturer's safety guidelines for the specific coating being used.

3. Package Contents

Verify that all components are present and undamaged upon unpacking your Wagner 9155 paint sprayer. The package should contain:

  • Wagner 9155 Paint Sprayer Unit
  • Filter
  • 515/211 VersaTip Reversible Airless Spray Tip
  • Upright Cart with 5-Gallon Pail Bracket
  • 1/4-inch by 35-foot Airless Spray Hose
  • User Manual

4. Setup

Proper setup is crucial for optimal performance and safety. Follow these steps to prepare your sprayer for use:

  1. Assemble the Cart: Attach the wheels and telescopic handle to the upright cart. Ensure all connections are secure. The 5-gallon pail bracket should be properly positioned.
  2. Connect the Hose: Securely attach the 1/4-inch by 35-foot airless spray hose to the sprayer unit and the spray gun. Hand-tighten connections, then use a wrench for a final snug fit, but do not overtighten.
  3. Install the Spray Tip: Insert the 515/211 VersaTip reversible airless spray tip into the spray gun. Ensure it is seated correctly and the guard is in place.
  4. Prepare Paint: Stir your paint thoroughly. If necessary, thin the paint according to the paint manufacturer's recommendations. Place the paint pail onto the cart's bracket.
  5. Prime the Sprayer: Follow the priming instructions in the detailed user manual to remove air from the system and draw paint into the pump. This typically involves setting the prime/spray valve to prime and running the unit until paint flows smoothly.

5. Operating Instructions

Once the sprayer is set up and primed, you can begin painting. Always maintain a consistent distance and speed for an even finish.

  1. Adjust Pressure: Set the pressure control to the desired level. The Wagner 9155 can operate up to 3000 PSI. Start with a lower pressure and gradually increase until you achieve a consistent spray pattern without tails.
  2. Test Spray: Before painting your main surface, test the spray pattern on a piece of scrap material. Adjust pressure or tip as needed.
  3. Spraying Technique:
    • Hold the spray gun perpendicular to the surface, maintaining a distance of approximately 10-12 inches.
    • Move your arm, not just your wrist, to ensure an even coating.
    • Overlap each pass by about 50% to avoid streaks.
    • Release the trigger at the end of each pass to prevent paint buildup.
  4. Changing Tips: The sprayer supports up to a .017 spray tip for different materials and spray patterns. Always relieve pressure from the system before changing tips.

6. Maintenance

Regular cleaning and maintenance extend the life of your sprayer and ensure consistent performance. Clean the unit immediately after each use.

  1. Relieve Pressure: Always turn off the sprayer and relieve all pressure from the system before cleaning or performing any maintenance.
  2. Flush the System:
    • Remove the paint pail and place the intake tube into a pail of appropriate cleaning solution (water for latex, mineral spirits for oil-based paints).
    • Set the prime/spray valve to prime and run the sprayer until the cleaning solution runs clear.
    • Switch to spray mode and spray the cleaning solution through the gun into a waste container until clear.
  3. Clean the Spray Tip: The 515/211 VersaTip is reversible. If a clog occurs during use, reverse the tip and spray briefly to clear it. After use, remove the tip and clean it thoroughly with a brush and cleaning solution.
  4. Clean Filters: Remove and clean all filters (in-line filter, gun filter) with the appropriate cleaning solution.
  5. Storage: Store the sprayer in a clean, dry place. For long-term storage, consider using a pump protector fluid to prevent corrosion and freezing.

7. Troubleshooting

This section addresses common issues you might encounter. For more detailed troubleshooting, refer to the full user manual.

ProblemPossible CauseSolution
No spray or weak sprayClogged spray tip, clogged filter, insufficient paint, air in system, low pressure setting.Clear tip by reversing, clean filters, ensure sufficient paint, re-prime the system, increase pressure.
Pulsating sprayAir in system, worn packing, clogged filter.Re-prime the system, clean filters, inspect and replace worn packing if necessary.
Paint tails (uneven spray pattern)Pressure too low, paint too thick, worn spray tip.Increase pressure, thin paint according to manufacturer, replace spray tip.
Leaking from gun or hoseLoose connections, damaged O-rings or seals.Tighten connections, inspect and replace O-rings or seals.

8. Specifications

Key technical specifications for the Wagner 9155 Airless Paint Sprayer:

  • Model Number: 9155
  • Brand: Wagner
  • Power Source: Electric
  • Maximum Pressure: 3000 PSI
  • Motor: 5/8 Horsepower
  • Flow Rate: Up to 0.33 Gallons Per Minute (GPM)
  • Hose Length: 35 feet (1/4-inch)
  • Supported Tip Size: Up to 0.017 inch
  • Included Components: Paint sprayer, filter, spray tip, cart with pail bracket, spray hose, user manual
  • Material: Plastic (housing), Thermoplastic (inner tube), Polyurethane (cover)
  • Color: Yellow
  • UPC: 024964182084

9. Warranty and Support

The Wagner 9155 Airless Twin Stroke Piston Pump Paint Sprayer comes with a 1-year manufacturer's warranty. For warranty claims, technical support, or to purchase replacement parts, please contact Wagner customer service directly. Retain your proof of purchase for warranty validation.

You can find additional support and contact information on the official Wagner website: Visit the Wagner Store

© 2023 Wagner. All rights reserved. This manual is for informational purposes only.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.