1. Introduction
Thank you for choosing the Casio TQ359/1 Alarm Clock. This analog quartz alarm clock is designed for reliability and ease of use, featuring a clear display, a loud alarm, a convenient snooze function, and an integrated light for visibility in low light conditions. This manual will guide you through the setup, operation, and maintenance of your new alarm clock.
2. Safety Precautions
- Do not expose the clock to extreme temperatures, direct sunlight, or high humidity.
- Avoid dropping the clock or subjecting it to strong impacts.
- Keep out of reach of small children.
- Dispose of used batteries properly according to local regulations.
- Do not attempt to disassemble or repair the clock yourself. Refer to qualified service personnel.
3. Package Contents
Please check that all the following items are included in your package:
- Casio TQ359/1 Alarm Clock
- 1 x AA Battery (pre-installed or included separately)
- User Manual (this document)
- Original Casio gift box
- Service card
4. Product Overview
Familiarize yourself with the main components of your Casio TQ359/1 Alarm Clock.
Figure 4.1: Front View - Shows the clock face with analog hands, luminous numbers, and the Casio Quartz logo. The black casing frames the white dial.
Figure 4.2: Back View - Displays the rear of the clock, including the battery compartment cover, the time setting knob, the alarm setting knob, and the speaker grille for the alarm sound.
Key Components:
- Time Setting Knob: Located on the back, used to adjust the current time.
- Alarm Setting Knob: Located on the back, used to set the desired alarm time.
- Alarm ON/OFF Switch: Typically a slide switch on the side or back to activate/deactivate the alarm.
- Snooze/Light Button: Large button on top, activates snooze when alarm sounds, or illuminates the dial when pressed.
- Battery Compartment: Located on the back, holds the AA battery.
5. Setup
5.1. Battery Installation
- Open the battery compartment cover located on the back of the clock.
- Insert one AA battery, ensuring the correct polarity (+ and -) as indicated inside the compartment.
- Close the battery compartment cover securely.
5.2. Initial Time Setting
- Locate the Time Setting Knob on the back of the clock.
- Rotate the knob clockwise or counter-clockwise to set the current time. Ensure the hour and minute hands are accurately aligned.
6. Operating Instructions
6.1. Setting the Alarm
- Locate the Alarm Setting Knob on the back of the clock.
- Rotate this knob to move the small alarm hand to your desired alarm time.
- Slide the Alarm ON/OFF Switch (usually on the side or back) to the 'ON' position. The alarm is now set.
6.2. Using the Snooze Function
When the alarm sounds, press the large Snooze/Light Button on the top of the clock. The alarm will temporarily stop and sound again after approximately 5 minutes.
6.3. Activating the Light
To illuminate the clock face in the dark, press and hold the Snooze/Light Button on the top of the clock. The light will remain on as long as the button is pressed.
6.4. Turning Off the Alarm
To permanently turn off the alarm, slide the Alarm ON/OFF Switch to the 'OFF' position. The alarm will not sound again until it is reactivated.
7. Maintenance
7.1. Cleaning
Wipe the clock with a soft, dry cloth. Do not use abrasive cleaners, solvents, or chemical sprays, as these may damage the casing or dial.
7.2. Battery Replacement
When the clock hands start to move slowly, or the alarm sound weakens, it is time to replace the battery. Follow the battery installation steps in Section 5.1.
7.3. Storage
If you plan not to use the clock for an extended period, remove the battery to prevent leakage and damage to the clock's internal components. Store the clock in a cool, dry place away from direct sunlight.
8. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Clock not working / Hands not moving | Battery is dead or incorrectly installed. | Replace the battery with a new AA battery, ensuring correct polarity. |
| Alarm does not sound | Alarm switch is OFF. Alarm time is not set correctly. Battery is low. | Slide the alarm switch to ON. Re-set the alarm time. Replace the battery. |
| Alarm is too quiet | Battery is low. | Replace the battery. |
| Light is dim or not working | Battery is low. | Replace the battery. |
9. Specifications
| Feature | Detail |
|---|---|
| Model Number | TQ359/1 |
| Movement Type | Analog Quartz |
| Power Source | 1 x AA Battery (included) |
| Functions | Time, Alarm, Snooze, Light |
| Dimensions (L x W x H) | 12 x 8.2 x 11.8 cm |
| Weight | 277 g |
| Case Color | Black |
| Dial Color | White |
| Country of Origin | China |
10. Warranty and Support
This Casio TQ359/1 Alarm Clock comes with a manufacturer's warranty. For products sold and shipped by Amazon, a 2-year factory warranty applies. If sold and shipped by a third party, please refer to the warranty information provided by that specific seller.
For technical support, troubleshooting assistance beyond this manual, or warranty claims, please contact your point of purchase or refer to the official Casio website for customer service contact information in your region.
